20.11 Below are data taken from a batch reactor of bacterial growth (after lag phase was over). The bacteria are allowed to grow as fast as possible for the first 2.5 hours, and then they are induced to produce a recombinant protein, the production of which slows the bacterial growth significantly. The theoretical growth of bacte- ria can be described by dX dt

Q: a) In the space below, write a balanced chemical equation for the reaction. b) Assuming the reaction...

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If y...

Q: ti- kihat is the approximation of fick's equation C Hint: the first three terms)!

A: The first law of Fick’s gives the relationship between the diffusive flux and the concentration grad...

Q: The fact that polymer’s physical properties depend on its atomic composition is very important in ma...

A: Physical properties of a polymer include its toughness, elasticity, viscoelasticity, and its tendenc...

Q: The experimental observations for the determination of contact angle is presented below. Calculat...

A: (a)

Q: Coconut milk was extracted from fresh coconut flesh. The rheological behavior ofcoconut milk contain...

A: Part (a)   The given fluid is coconut milk which is a non-Newtonian fluid. It follows the power-law ...

Q: Why do some evaporators operate under vacuum? How is the vacuum produced?

A: The reason for operation of some evaporators under vacuum is to be mentioned along with the method f...

Q: In a beaker 150.0 g iron is heated to the temperature of boiling water. In another beaker, 50.0 g wa...

A: The specific heat of the iron is to be calculated for the given mixture of iron and water.

Q: Coconut milk was extracted from fresh coconut flesh. The rheological behavior of coconut milk contai...

A: Note: Since we only answer 1 question, we’ll answer the first one. Please resubmit another question ...

Q: Determine how many grams of each of the following solutes would be needed to make 3.60×102 mL of a 0...

A: Moles of any substance is given by  Moles = Concentration X volume of solution in L Since the concen...

Q: Question in photo below

A: Given information:   Power of the plant, W = 800000 kW The temperature of the steam generated, T1 = ...

Q: What is the analogical reason between heat transfer by conduction and flow of electricity through oh...

A: The diagram for the composite wall with conductivity ‘k’, thickness ‘t’, and cross-sectional area ‘A...

Q: A quiescent body of water has a depth of 600 mm. The DO level at the bottom after 16 days is 3.5 mg/...

A: Let, dissolved oxygen (DO) be represented by ‘A’.   Since the surface of the water body is exposed t...

Q: Why does the underflow consist of both leached solids and liquid containing leached material?

A:

Q: Consider a vapor phase is in equilibrium with a liquid stream leaving the bottom of a distillation c...

A:

Q: A force that will accelerate 1 slug of mass at a rate of  1ft/s2 is known as a   a. Newton. ...

A: The relation between the slug and acceleration in terms of force is to be chosen from the given opti...

Q: Balance with no chemical reaction. Estimate the steam and the cooling water required for the distill...

A: Since the amount of acetone in the bottom product is less than 100 ppm, acetone present in the botto...

Q: A block of unknown metal has the following dimensions: 1cm× 1cm×3cm. The block's density is 80o09/m³...

A: Mass of any metal is given by  Mass = density X volume  

Q: What is the approximation of Fick's equation(Hint: the first three terms)

A: The approximation of Fick’s law are as follows: Flux should be considered in only one dimension tha...

Q: Material Balances question

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question...

Q: O As a researcher in the field of heat transfer, how will you distinguish between radiation by black...

A: The difference between a black body and a real body is to be mentioned.

Q: Solve a,b and c

A: (a)   The first law of Fick’s gives the relationship between the diffusive flux and the concentratio...

Q: a) If the expansion is carried out isothermally and reversibly, calculate Q. W, AH and AU. Draw the ...

A:

Q: Practice 23This system of pure water at 75°C is not at equilibrium. What happens for the system to r...

A: A 2 phase system of Liquid -Vapor which are not in equilibrium.

Q: A meat processing factory’s raw effluent has a five day BOD at 20oC of 1760 mg/l. If the k value is ...

A:

Q: What is the difference between suspension leaching and percolation leaching? For what conditions is ...

A: Suspension leaching is also known as agitated leaching. The method is used for the ores that does no...

Q: Chemical Engineering Question

A:

Q: The McCabe-Thiele method of stage analysis is based on a certain principle. Name this principle and ...

A: The McCabe-Thiele method of stage analysis is based on a certain principle that is constant molar ov...

Q: A chemical engineer is planning to start a starch manufacturing unit. He prepared a project plan, id...

A: (a)   The data for activity with their required time is given as:

Q: describe six specific safety precautions to be stated in work permit and explain any four potential ...

A: Places which are enclosed and it creates conditions which can result in an accident or injury that w...

Q: 1. Consider a case in which you have a material that support a certain stress at 75°C and you have s...

A: Differential Scanning Calorimetry or DSC is a traditionally common method used to estimate Transitio...

Q: Material Balances question

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question...

Q: A meat processing factory’s raw effluent has a five day BOD at 20 degrees Celcius of 1760 mg/l. If t...

A:

Q: 1000 kg/h of a mixture of benzene (B) and toluene (T) that contains50% w/w benzene by mass are separ...

A:

Q: By analyzing the free-energy change resulting from partitioning in an aqueous two-phase extraction, ...

A: For a globular protein, the interface is between the protein sphere and the liquid phase for the aqu...

Q: (a) At what position across the pond is the air no longer laminar? (b) Determine the mean gas-film m...

A: Consider the well mixed open pond with methylene chloride diffused in it. Assume methylene chloride ...

Q: It is desired to use a rotary vacuum filter to separate slurry containing 20 kg of water per kilogra...

A:

Q: Coconut milk was extracted from fresh coconut flesh. The rheological behavior of coconut milk contai...

A: The given fluid is coconut milk which is a non-Newtonian fluid. It follows the power-law according t...

Q: While driving down the highway you notice that your speedometer reads 50 miles/hr and 80 km/hr. Whic...

A: The faster speed out of the 2 given options is to be chosen.

Q: A mixture of 0.30 mole fraction benzene and the rest toluene is fed to a continuous distillation col...

A: (a) The number of theoretical plates required to achieve the given separation is to be determined.  ...

Q: What operating condition will give the minimum number of plates/stages during distillation?

A: The condition at which minimum number of plates are obtained during distillation is to be stated.

Q: Use material balance based on species method to calculate the products from reactor, where the twofo...

A: The two reactions taking place are, 1) 2 C10H22 → 2 C10H10 + 12 H2  2) 2 C10H22 + 2 H2 → 4 C5H12  Th...

Q: A stream with a flow of 1.7 m3/s and BOD 3.4 mg/l is saturated with DO (9.27 mg/l at 20oC). It recei...

A:

Q: An explanation would be helpful!

A: The given system of two flasks connected to each other by a tube is at the temperature of 45°C. Flas...

Q: A roll of aluminum foil from the grocery store is 12 inches wide by 75 feet long (if you unroll it)....

A: Since the mass of Aluminium foil is given by  Mass = density X volume  And volume = length (unrolled...

Q: Give an example of a hybrid system that involves recycle.

A: An example of a hybrid system that involves recycle is to be mentioned.

Q: If the intensity of light after it passed a blank solution was 3.42. Calculate the absorbance of a s...

A: The absorbance of the given sample of light is to be calculated.

Q: Prove that carnot engine efficiency can never equal one

A: Carnot engine runs on Carnot cycle which is made up of 4 reversible process  The 4 reversible proces...

Q: a. What is the approximation of Fick’s equation (Hint: the first three terms)   b. A quiescent body ...

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,...

Q: During the crystallisation of aluminium hydroxide in an alumina production plant, the feed solution ...

A: Given data: The crystallization of aluminum hydroxide is achieved in aluminum production plant. Conc...

Q: Chemical Engineering Question

A: Given:   The pressure of the system, P = 1 atm Molar flow rate of acetone, n = 100 kg-mol/s The init...