2. A coil has a resistance of 482 and an inductance of 1.5H connected in series. If the current flowing through the coil is 6amps. What will be the rms value of the supply voltage if its frequency is 60HZ

2. A coil has a resistance of 482 and an inductance of 1.5H connected in series. If the current flowing through the coil is 6amps. What will be the rms value of the supply voltage if its frequency is 60HZ

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 7RQ

See similar textbooks

Related questions

Q: Two reactors are connected in series across a 10 V, 10 kHz source. They are spaced so that there is…

Q: Consider an electric motor that requires a 120 V rms power source and a current of 1.5 A rms. If the…

A: Given an electric motor that requires a, Source voltage, Vrms=120 V Current, Irms=1.5 A The…

Q: 1. A relay coil is connected to a 210-V, 50-Hz supply. If it has a resistance of 30 2 and an…

Q: Q7. A coil with number of turns 1000 and inductance, 10.5H. Determine the following, i. Average emf…

Q: coil has a resistance of 10 ohms and draws a current of 5A when connected across a 100-V, 60 Hz…

Q: A transformer connected to a120 V (rms) ac line is to supply 12.0 V (rms) to a portable electronic…

A: Given: Primary side voltage, V1=120V Secondary side voltage, V2=12V Load resistance, RL=5Ω

Q: When connected to a 120 V (rms). 60 Hz power line, a load absorbs 4 kW at a lagging power factor of…

A: Given data VL=line voltage=120Vfrequency f=60HzActive power=4 kWCos ∅1=0.8Cos ∅2=0.95 new value of…

Q: A 480-V rms, 60 Hz source supplies a load having a total impedance of 50 angle 60° Q. Find the…

Q: A 50 Hz, alternating voltage of 150 V (rms) is applied independently to:

A: Vm=2Vrms =2×150Vm=212.13 V a- For purely resistive, phase angle- ϕm=0 i=Imsinwt=Im sin…

Q: A sinusoidal current has a rms value of 3 amperes, its peak to peak value will be 3.46 amp O 2.1213…

Q: The oscilloscope have produced two different sinusoidal outputs, V, (t) and V,(t). Find the…

A: Let the two-time domain signals be…

Q: A sinusoidal current has a rms value of 3 amperes, its maximum value will be 3.46 amp 0.866 amp O…

Q: A sinusoidal current has a rms value of 3 amperes, its maximum value will be O 2.1213 amp 3.46 amp…

Q: triangle waveform with following specifications in Table B1. Table B1 RMS Voltage 50mV Number of…

A: In this question , we will make triangular waveform with given data and also find secondary current…

Q: A sinlge phase load consist of a coil having a resistance of 10 Ω and an inductance of 100 mH. The…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A 50 uF capacitor is connected across a 230V, 50Hz supply. Calculate a) the reactance offered by the…

A: Given:C=50μFVRMS=230Vf=50Hz Peak value= 2×RMS value

Q: 11. What is the inductance of the coil whose resistance is 100 Q if it draws 0.55 A from a 110 V. 60…

Q: Q3 A three-phase induction motor has the following data: 50 hp and V440 and 50HZ operating at full…

A: first calculate total active and reactive power before and after compensation . reactive power…

Q: A coil has resistance of 5 ohm and capacitive reactance of 6 ohm . a) what is the impedance of…

A: Given: A coil has, Resistance, R=5 Ω Capacitive Reactance, XC=6 Ω

Q: 44. The equation for 60 cycles current sine wave having RMS value 30 amperes, will be __ A. 42.4…

A: The solution is given below

Q: A voltage waveform, e(t) = 100 V sin ( 314 rad/s t), is connected across a 5mH pure inductance.…

Q: A sinusoidal 50 Hz voltage of 200 V(rms) supplies the following three circuits which are in parallel…

A: Circuit diagram can be drawn as,

Q: Ql: In an industry a general-purpose visual equipment displays an alternating waveform comprising of…

A: The general equation of an ac waveform can be expressed as In this case, the expression of the…

Q: Kindly answer A coil has an inductance of 40 mH and negligible resistance. Calculate its inductive…

A: Given:- A coil has Inductance (L)= 40mH Resistance (R)=0 ohm We have to determine inductive…

Q: 4. The primary coil of a transformer has 350 turns and the secondar has 2000 turns. If the maximum…

A: In this question, Find the rms secondary voltage and current of the given transformer. We know…

Q: A 50 Hz, alternating voltage of 150 V (rms) is applied independently to: (a) resistance of 10 ohms,…

Q: A relay has a 500-turn coil that draws 50 mA rms when a 60-Hz voltage of 24 V rms is applied. Assume…

A: Given data: N=500IRMS=50 mA=502 mAVRMS=242 V The expression for the v(t) is given as, vt=Vmcosωt=242…

Q: coil when connected across 40 V DC draws 640 W. When connected across (104 + j78) V AC, the coil…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: 1. A 70-Vac source has the following waveform. Determine: 180 V h) equation of the waveform (in time…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: The voltage applied to the metal grid of CRO is negative with respect to cathode. Select one: O True…

A: Concept of CRO CRO is called as Cathode Ray Oscilloscope. The main component of CRO is Cathode Ray…

Q: nts A 100 mH coil of negligible resistance is connected to an AC circuit in which an effective…

Q: A load is consisting of induction motors is drawing 80 kW from a 220-V, 60-Hz power line at a power…

A: Referring to the given question, the load power (P) is 80kW. The power factor is given as 0.72.…

Q: A coil with a resistance of 240 has a reactance of 320 when connected across a supply voltage, v=…

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question for…

Q: A0) is supplied by an RMS value of 22o-v, 60-Hz source

Q: A. What is the coefficient of coupling of two co inductance are 1.2 and 2 H? B. An emf of 9.7mV is…

Q: Determine the peak-to-peak voltages, RMS voltage, frequency, period and phase shift for the…

Q: SCR SCR U1 U2 V1 LOAD •R V SCR SCR U4 U3

Q: When a current of 1A flows in a coil having 1450 turns. If the coil inductance is 900 mH, the flux…

A: Flux linking in coil can be calculated as by the given formula.

Q: The equation for 60 cycles current sine wave having RMS value 30 amperes, will be ____. Kindly…

A: The solution is given below

Q: deduce the equivalent circuit of the coil

A: If the supply is applied to coil with iron core, then the power is observed for meet the core…

Q: A coil draws 1875 watts when connected to a 165 V dc source. It consumes 30.72 watts when use on a…

A: I have checked every calculation but not getting 39 mH but my solution is 100% correct. There may be…

Q: https://matlab.mathworks.com/ Question 1 Which of the following best describes the average power…

Q: In a linear circuit, the voltage source is v, = 12 sin(10°t +24°) V (a) What is the angular…

Q: A sinusoidal voltage v = (10 sin 377t) V r.m.s is applied to a resistor of 50 Q. The average power…

A: Given data: Vt=10sin377t VR=50 Ω

Q: Which element (capacitor or inductor) should be placed in parallel with the circuit to achieve unity…

A: In this question we need to find which element should place in parallel to make the overall power…

Q: What is the inductive reactance of an inductor whose inductance is 5H if the angular velocity of the…

A: Given, L = 5H ω = 100 rad/sec XL = ?

Q: A generator delivers an AC voltage of the form Av = (88.0 V)sin(60xt) to a capacitor. The maximum…

Q: A load connected to a 210 V rms 50 Hz power line It draws 7 kW of power with a back power factor of…

Q: 1. An inductive circuit takes a current of 15 A at 0.78 pf when connected to a source 250 V, 50 hz…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Concept explainers

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.

Question

THE SUBJECT IS BASIC ELECTRICAL ENGINEERING

Chapter 12. Voltage and Current Relation

2. A coil has a resistance of 482 and an inductance of 1.5H connected in series. If the current
flowing through the coil is 6amps. What will be the rms value of the supply voltage if its
frequency is 60HZ.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a current draw of 36 amperes at full load. The motor is connected to a 480-volt line. A three-phase wattmeter indicates a true power of 22 kW. Determine the power factor of the motor and the amount of capacitance needed to correct the power factor to 95. Also determine the minimum voltage rating of the capacitors. The capacitors are to be connected in wye.
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source. 61 Datermine the volto in the girRuit F Figura 1 1?
An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is the rmscurrent in this circuit? (b) By what factor does the current changeif the frequency of the voltage is doubled? (c) Calculate the current for a frequency of 2.00 kHz
An inductor and a 470 ohm resistor are connected in series with a function generator. The current is 53.7mA RMS 8kHz. The reactive power is 2.32 var. Find the value of the inductance.
Find the RMS current from 30⁰ to 180⁰ at Im = 10 Amperes
The rms value of the resultant current in a wire which carries a dc current of 20 A and a sinusoidal alternating current of peak value 20 A is 1. 34.1 A 2. 17.3 A 3. 24.5 A 4. 40.0 A
The maximum value of sinusoidal voltage is given by Vm= 1 V, What is the value of Peak to Peak voltage?
QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function generator. The inductor draws 100mA RMS, the capacitor draws 150mA RMS, and the resistor draws 200mA RMS. Find the magnitude of the total current. O 450mA RMS O 544mA RMS O 352mA RMS O 206mA RMS
Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 Vusing a single 14 V dc voltage source