2-propanol and water are mixed in three different ratios in this experiment to test the effects of solvent polarity on the rate. Convert the ratios used to percentages and then volumes needed to make each solvent system. Total volume of the final solution should be 20 mL. Percent Volume Needed to make 20 mL Solvent System 2-propanol water 2-propanol water 2:3 2-propanol/H2O 1:1 2-propanol/H2O 3:2 2-propanol/H2O

Q: Draw the reaction between acetylsalicylic acid and NaHCO3 then draw the reaction between that…

A: This reaction between acetylsalicylic acid, commonly known as aspirin, and sodium bicarbonate is…

Q: What is the function of the sulfuric acid in the dehydration of alcohols to form alkenes

A:

Q: While recrystallizing, what should you do if you have solid particles that don’t dissolve even after…

A: a) If the solid particles are not dissolving in the solvent even upon adding the hot solvent, then…

Q: Propose an alternative method for purifying the product today. Briefly describe how you would…

A: The solution of the question is given below:  No. of moles can be calculated by = given mass / molar…

Q: Imagine your original mixture had contained a component capable of sublimation, such as naphthalene.…

A:

Q: . Any organic solvent waste generated in this experiment should be collected in your fume hood and…

A: Organic solvents may be Carcinogenic, Toxic, corrosive, radioactive material, explosive. If we…

Q: Note the color of the cupric sulfate pentahydrate before and after heating. Question: Observations…

A:

Q: Carbonyl Compounds The following data were obtained in the experiment for Carbonyl Compounds. Using…

A: Given

Q: Suppose we start with 3.0g of contaminated benzoic acid. After recrystallisation we end up with 2.3g…

A: Given Mass of contaminated benzoic acid = 3.0 g Mass of pure benzoic acid = 2.3g

Q: 4. The reflux set-up in the experiment allows prolonged heating of the liquid reactants for them to…

A: In organic chemistry experiment, reflux technique is used used to obtain the product in chemical…

Q: Find the Rf value from given data. Thank you

A: In Thin Layer Chromatography, the compounds can be separated by the solvents in the TLC plate. The…

Q: 3. Rank these solvent systems from on that would cause a compound to elute from the column fastest…

A: Given : Mixture of solvents  To find : Solvent that elute the Compound fastest and slowest .…

Q: In this experiment, the eluant is O 1) petroleum ether O 2) water 3) dichloromethane 4) ethyl…

A: In the given question we have to choose the correct eluent used in the column chromatography.…

Q: A student was given an unknown compound dissolved in acetone. The student decided to identify the…

A: Thin-layer chromatography is the technique that is used to separate or purify the compound from a…

Q: 7. A student did a distillation experiment using 40 % aqueous ethanol and presented his result of…

A: Given : Distillation process using 40% ethanol  To find : 7 . Conclusion  8. Purpose of fractional…

Q: Can you answer this question please:  Explain why bromoethane was added last (Please type your…

A: Addition of NaOH in p-acetamidophenol along with reflux of the solution is done to generate a strong…

Q: Q2. What does “crude” product mean? Q3. What is the advantage of using Buchner filtration in…

A: “Since there are multiple questions and it is not mentioned that which one has to be solved so I am…

Q: Use what you know about solubility, chemical kinetics, reaction rates, and how extractions works to…

A: Coffee consists of 2-3% caffeine, 3-5% tannin, 13% proteins, carbohydrates and 10-15% oil. The…

Q: Each of the student statements below is wrong. Explain why they are not correct. (a) All my…

A: The dissolution of a known amount of a solute to a solvent produces a solution of know…

Q: 1. 6-hydroxy-1-naphthoic acid is soluble in 5% NaOH and soluble in 5% NaHCO3. 2. The addition of…

A: 6-Hydroxy-1-napthoic acid has the following structure where we find that there is one carboxylic…

Q: Any organic solvent waste (besides methanol and ethanol) generated in this experiment should be…

A: Organic solvent waste is the liquid waste generated after a reaction has been performed.

Q: In the multistep reaction, a bromine in acetic acid solution was used that contained 0.15mL of…

A: A bromine in acetic acid solution was used that contained 0.15mL of bromine in 0.3mL of acetic acid.…

Q: Based on the solubility data which solvent(s) used in this experiment would be an effective grease…

A: When any solvent dissolves any substance, we can keep in mind the rule that ' Like dissolves like'.…

Q: The result of the TLC analysis of the reaction between reagents A and B is shown in Figure 2. Mark…

A: The result of reaction between reagent A and reagent B are given in the TLC plate as

Q: 1.Each of the student statements below is wrong. You will need to explain why they are not correct.…

A: There are some of the common tricks associated with recrystallization to get a relatively pure…

Q: The question is:    Consider a mixture containing 0.5 benzil and 0.05 biphenyl. Your task is to…

A: Extraction:It is a process used for the separation of a substance of interest mixed with others.…

Q: Peak Retention Time (minutes) Area 1.201 136501204 acetone 2.011 1253056 toluene ortho-product…

A:

Q: Would an organic liquid with a density of 1.006 g/mL make a good extraction solvent? Explain.

A: Density is very important characteristic to keep in mind while choosing the solvent for extraction…

Q: Concentrated sulphuric acid is used in this experiment to O help the crystal growth of…

A: Here we have to choose correct option about why concentrated H2SO4 used in above experiment and in…

Q: 1. a) "Solution 1" is made from the addition of water to a portion of the 0.0500 M  Fe3+ "…

A: Given, Molarity of prototype solution = 0.05M Fe3+. Volume of prototype solution = 10.0mL. Volume of…

Q: What property determines which layer is on top or bottom in an extraction?

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A yellow compound, dissolved in methylene chloride, is added to a chromatography column. The elution…

A: Chromatography is a laboratory method for the isolation of a mixture. In a fluid called the mobile…

Q: Based on the results of your experiment, do you have hard or soft water? Does this match the data…

A: The question is based on the concept of hardness of water. hardness is present due to presence of…

Q: Pinacl-Pinacole lab What visual criterion is to be used to assess whether the crude reaction product…

A: Pinacol pinacol rearrangement is a type of rearrangement which occurs  in geminal diols and…

Q: Starting Material mmol mL Methyl Salicylate 10.0 1.3 Weight m.p. (°C) 1.59 g 158-160 Product…

A: % Yield = 100 x mmol of salicylic acid/mmol of methyl salicylate Number of mmol = 1000 x Mass in…

Q: An oil sample had its iodine number determined using the pyridinium tribromide method. The sample…

A:

Q: Choose all that apply. In Experiment 4, we use a mixture of 50% water and 50% isopropyl alcohol as…

A: As we know "Like dissolve like". The polar solute can be dissolved in polar solvent and non-polar…

Q: Please answer the question at the bottom, Thanks. LAB NOTES FOR PREPARATION OF BUTYL MAGNESIUM…

A:

Q: Using the diagram below, explain how you would prepare serial dilutions of 10-3, 10-5 and 10-6 of a…

A: Dilution means decreasing the concentration of a solution by adding the solvent .  In serial…

Q: Cite one factor that affects percent yield during recrystalization.

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Solubility of Amines in Acid Put 2 ml of water in a 10x75-mm test tube. Add 5 to 10 drops of…

A: Upon addition of acids the aniline forms the ionic compounds and becomes soluble in water but upon…

Q: It is important to pre-wet the filter paper before filtering your sample. Which statements about…

A: One important step in the procedure for filtration using filter paper is to pre-wet the filter paper…

Q: A student forgot to add the mass of the unknown solute in trial 1 to the mass of the solute that was…

A: Mass = ( m1+m2  ) divided by 2

Q: #1. Part A. in a drug discovery program, a hit compound________. A. Shows activity in an animal…

A: In drug discovery program, a hit compound shows the required type of activity in the screening…

Q: If 80% of a desired compound is extracted into the organic phase in each step (leaving 20% in the…

A: Given : 80 % of the desired compound gets extracted in each extraction leaving 20 % in the aqueous…

Q: At the end of your experiment, left over reagents should be disposed of in a(n) Regular garbage…

A: At the end of your experiment, left over reagents should be disposed of in an

Q: i need help calculating the therotical yield based on the data in the lab and please show me the…

A:

Q: An enzymatic method for determining alcohol in the wine is evaluated by comparison with a…

A: Solution -

Q: Can you please help me complete the tables? please kindly also include some sample calculations.…

A:

Q: Will the melting point increase or decrease with the benzoic acid, 4-chloroanaline, and naphthalene…

A: During the extraction of benzoic acid, 4-chloroaniline and naphthalene, HCl is added at the first…

Solutions

Solutions can be considered as homogeneous mixtures which contain two or more than two chemical substances. The chemical substance which is the greater part is defined as solvent. And the chemical substance that is dissolved in a solvent is referred to as solute. Solution chemistry plays an important role in chemistry since it supports many commercial applications of solutions.