Untitled SectionWhich of the statement is true about 3-phase induction motor (IM) ?Ns: Synchronous speedThe rotor magnetic field of IM rotates at Nsbut stator magnetic field rotates at less thanNsBoth rotor magnetic field and stator magneticfield rotates at NsThe rotor magnetic field of IM rotates at thespeed less than Ns but stator magnetic fieldrotates at Ns.Both rotor magnetic field and stator magneticfield rotates at the speed less than NsThe magnitude of the flux in the air-gapof 3-phase induction motorisNoneDepends on the slip of induction motorDepends on the phase sequenceDepends on supply frequency

We are authorized to answer one question at a time, since you have not mentioned which question you…

Answered: Which of the statement is true about 3-…

Engineering

Electrical Engineering

Which of the statement is true about 3- phase induction motor (IM) ? Ns: Synchronous speed

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter35: Harmonics 916

Section: Chapter Questions

Problem 3RQ: Would a positive-rotating harmonic or a negative-rotating harmonic be more harmful to an induction...

See similar textbooks

Related questions

Q: generators are operated at 90% of rated values (i.e. new value/old .value) 1 0.924 0.88 O 1.05 0.95…

A: Double line to ground Fault: when two lines get interconnected to each other through the Ground…

Q: Problemas Find the system fregnancy response for the ff two of b) y(n] -3y [n-1]+2√(n-2] =x[n]

Q: Synchronous speed in RPM of 6 pole, 50 Hz, 3-phase induction motor will be: (a) 1500 (b) 3000 (c)…

A: Given, Number of pole, P = 6 Frequency, f = 50 Hz Synchronous speed, Ns =?

Q: Let the impulse response of a filter be ℎ[?] = {ℎ[0] = −0.5, 0.5} a) Calculate the frequency…

Q: 1. Q3\ To design the combinational circuit by using a decoder and external gates in the design…

A: We will design the given function by using of decoder

Q: 2- نماز (0,625+ تعا) (1 - 3.753 - 2 - ) = (ساز)b) X)

Q: B/ Find Req a-b if vab = 40 V in the circuit of Figure: a 1202 60 302 20 92 {202

Q: The rotor of a 4-pole ac generator is wound with a 200 turns coil. If the flux per pole is 5 mWb and…

A: Given: An AC generator with, Number of pole, P = 4 Number of turns, N = 200 Flux, φ=5 mWb Speed, Ns…

Q: The message signal given in the figure below is used in both FM and PM. Given that the maximum…

Q: Q5.Determine Vo and i in the circuit shown in figure 5 using KVL method. 12 V No 4V (7 SO

Q: What is the closed-loop transfer function of the following system? R(s) OY(s) OY(s) R(S) O M(s) G(s)…

A: Given control system block diagram, Given system having forward path Gs Unity feedback, Hs=1

Q: TVT QUESTION 3 Q3: Find the current and power supplied by the battery to the given circuit. 4 K A 6…

A: In this question we will find current supplied by battery and power supplied by battery....

Q: نقطة واحدة نقطة واحدة * * Admittance, represented by the symbol Z, is a measure of the opposition to…

Q: 1. What is the advantage of angle modulation for (noise and interference), the bandwidth of…

A: Angle modulation: It is a technique where the phase or frequency of the carrier signal changes in…

Q: A three-phase system having an rms line voltage of 141.4V is connected to a delta balanced load with…

A: Given data, Line voltage VL=141.4 V Load impedance ZL=15∠300 Ω

Q: 9. Find the Thevenin equivalent circuit for the circuit shown in Figure below, using the mesh…

Q: Q5 Find the average output voltage of the full wave rectifier if the input signal = 24 sinwt and…

A: Types of Converters AC-DC Converter (Rectifier) DC=DC Converter DC-AC Converter (Inverter) AC-AC…

Q: For the circuit shown, Vc voltge is C₁ HH 10 µF O -4.48V O -3.48V Re 22% 100 kQ Rc1.2kQ C₂ H 10 pF…

Q: Calculate the missing values. Paste a screenshot of your answers below the circuit. VA= ? IT = 7 A…

Q: The Bode plot of a control system is shown in Fig.2. Find the: 60 40 20 Fig.2 S iv--3dB frequency…

A: For the above given question we need to calculate the values of 3db frequency, gain and phase…

Q: 4.2 For a step up d.c.-d.c. chopper with an input d.c. voltage of 220 volts, if the output voltage…

A: Given a step up DC-DC chopper with, Input DC voltage, Vs=220 volts Required output voltage, Vo=330 V…

Q: An iron ring of circular cross sectional area of 3 cm2 and mean diameter of 20 cm is wound with 500…

A: Given data: Area, A=3 cm2Diameter, d=20 cm Number of turns, N= 500 turns Current, I= 2A Flux, ϕ=0.5…

Q: Q6 Performs your calculation then select the right results Find the change in the BACK E.M.F when…

Q: The signal x(t) = cos2n70t+cos 27120t is input to the square-law modulator system given below with…

Q: A universal series motor has a resistance of 30 and an inductance of 0.5 H. when connected to a 250…

Q: HW 2: Find the trigonometric Fourier of symmetric square wave shown. x(t) -T/2 -1 T/2

A: In this question, We need to determine the Trigonometric series series. We know Trigonometric…

Q: The z-transform of [n] = u[-n] is

Q: #1. Find the mesh currents ir and i2 in the circuit below. Use Mesh Analysis. 4 Ω Μ 45 V (+ 5 Ω Μ 5…

A: Given circuit:

Q: A 440 V, 3-phase, 10 pole and 50 Hz synchronous motor delivering a torque of 50/ Nm. Delivers a…

A: Given, Synchronous motor delivering torque, T = 50π Nm Number of pole, P = 10 Frequency, f = 50 Hz

Q: The logic function realized by the circuit below is X = +VDD TIE DI TO DI B Ent 4 X

A: Given: The logic circuit with the inputs A, B, C and the output is X.

Q: Q2: A: Determine the minimum transmission BW in a TDM system transmitting 35 different messages,…

A: Given No. of messages transmitted (N )= 35 Message signal bandwidth (fm) = 5KHz. Find min…

Q: For the circuit shown, if the resistance equals 100, the inductive reactance equals 409, and the…

A: Given circuit: R=10 ΩXL=40 ΩXC=20 Ω

Q: QUESTION 3 Q3: Find the current and power supplied by the battery to the given circuit. A 6 K 4 K…

A: About Kvl and power delivered by battery in the circuit. We know Practical battery has emf in series…

Q: Q2: B: system, the output signal to quantization ratio is to be hold to a minimu of 25 dB. If the…

A: Signal power is given by, S.P=Am22 Noise power is given by, Noise power = △22

Q: Q2: B: In PCM system, the output signal to quantization ratio is to be hold to a minimum of 25 dB.…

A: The standard formula to find Level (n) and Bandwidth in PCM is n=log2LL=3×actual value of signal to…

Q: In the given circuit below, what will be the value of current flowing through 2 ohm resistance? 202…

A: Given circuit,

Q: A prism spreads white light into its various component wavelengths, or colours то FO The electric…

A: As per guidelines given to us, we can only provide the solution of one question in multiple types of…

Q: 16.12 Determine i() in the circuit of Fig. 16.35 by means of the Laplace transform. using mesh

Q: In the BJT circuit below, assume VBE 0.6V and CE current gain ß very large. Then the collector…

A: Given circuit, Base emitter junction voltage, VBE=0.6 V CE current gain β very large

Q: Cyril the Circuit Analyst is examining the interaction of both AC and DC sources with a circuit. The…

Q: مود 2- On what dependent the frequency of the antenna of AM-TX? Why? ۱۱۰ - الاح لم -

A: Frequency range of AM : Antennas are more than just basic hardware that connects to every radio.…

Q: Can you implement an anti-causal filter using a computer? Let the impulse response be ℎ[?] = {−0.5,…

A: Given the anti-Causal filter:: Few basic points that must be consider about this filter are::…

Q: What is the unit impulse response of the system shown in figure for t≥ 0? R(s) 1 (s + 1) 1. S C(s)

A: Given system: Unit impulse response, ht=? for, t≥0

Q: Q2// The supply voltage for a single-phase full-wave uncontrolled rectifier is vs-240v2 sin3141. The…

A: Given voltage supplied for a single-phase full-wave uncontrolled rectifier is Vs = 2402 sin314t.the…

Q: 2 The value of RE The value of Rc= The value of VCEQ=. C1 ViH The exact Value of A AU = Vo

A: The required parameters can be calculated by using the DC analysis and AC analysis of the CE…

Q: The figure shown is an example of summing amplifier circuit. With the given values of R1, R2, R3 and…

A: In this question we will find input voltage v2 for given summing amplifier....

Q: determine the Fourier transform

Q: what is the difference between common collector simplifier, common base amplifier and common emmiter…

A: BJT is a 3 terminal device. The terminals are base, emitter and collector. BJT acts like amplifier…

Q: 12 T1-P T2 20 30 B 80 40 60 A 30 20 10

A: In parallel combination equivalent capacitors are sum of individual capacitor and in series…

Q: A three-phase induction motor has: n=1500 rpm, n=1440 rpm, the input power of the motor is Pin =…

A: Given, A three-phase induction motor has Ns=1500 rpmNm=1440 romPin=37.5 kWPnl=1.5 kW

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

Untitled Section
Which of the statement is true about 3-
phase induction motor (IM) ?
Ns: Synchronous speed
The rotor magnetic field of IM rotates at Ns
but stator magnetic field rotates at less than
Ns
Both rotor magnetic field and stator magnetic
field rotates at Ns
The rotor magnetic field of IM rotates at the
speed less than Ns but stator magnetic field
rotates at Ns.
Both rotor magnetic field and stator magnetic
field rotates at the speed less than Ns
The magnitude of the flux in the air-gap
of 3-phase induction motor
is
None
Depends on the slip of induction motor
Depends on the phase sequence
Depends on supply frequency

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1+

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

why the slip of induction motor is never zero.
What are the factors that the induced voltage in three phase induction motor depends upon and Explain how the rotating magnetic field is produced in the three phase induction motor. ii) When the speed difference will be maximum in three phase induction motor. Justify your answer
A dc generator is run at 500 rpm. The eddy current losses and hysteresis losses are found to be 100 and 200 W, respectively. At what speed will it be run to reduce the core losses by 20%?
4- An induction Motor is a) Self-starting with high torque c) Self-starting with low torque 5- In three-phase squirrel-cage induction motors a) Rotor conductors are kept open b) Rotor conductor ends are short-circuited through slip rings c) Rotor conductors are short-circuited through end rings d) Rotor conductors are connected to insulation b) Self-starting with zero torque d) Not self-starting
Explain why the slip of an Induction motor is directly proportional to the rotor copper loss.
a. Explain how a rotating magnetic field is produced in a three-phase induction motor. b. Explain the rotor action on a three-phase squirrel cage motor when the load increases from NO-LOAD to rated FULL- LOAD
Differentiate between the AC and DC magnetic fields applied to an induction motor stator.
Name three factors that determine the torque produced by an induction motor.
Would a positive-rotating harmonic or a negative-rotating harmonic be more harmful to an induction motor? Explain your answer.
1. The operation of Commutator in DC Motor is * O a) to convert dc to ac O b) to convert ac to dc O c) to convert fixed dc to variable dc O reverse the current direction in the rotating windings each half turn
the magnetic strengh of the field poles on a perment magnet DC motor cannot be varied a- true b- false
A) Although the magnetic field for each phase of a 3-phase induction motor is merely switching back and forth between north and south poles, the resultant magnetic influence from all phases sets up a rotating magnetic field to cut the rotor conductors. a) true b) false B) In a two-pole stator winding of a 3-phase motor, how many revolutions does the rotating magnetic field make in one cycle of the electrical current? a) one b) 60 c) 3600 d) none of the above 3.