when we have smooth surface at the contact to the body, we will have one tangent force to the body True O False O
Q: A force F of magnitude 76 N is applied to the gear. Determine the moment (positive if…
A:
Q: The above refrigeration system uses R-12 as the refrigerant, determine: 1. Enthalpies at each point…
A:
Q: millimeter. What are two plates joined by three nails with a diameter of 15 T N the shear stress in…
A: Given:Number of nails, n=3Diameter of the nails, d=15 mmShear force F=1200 N
Q: An air current impinges laterally on an isolated train car of dimensions 3 m high, 12.2 m long and…
A:
Q: words, describe the difference between the magnitude of a vector and the direction. In addition,…
A:
Q: The specific heat in kj / kg. C for a crude fraction with Specific gravity of 0.819 at 55.6 C is
A: Write the given data. SG=0.819T=55.6 °C
Q: The heat transfer from a 2-m-diameter sphere to a 25 °C air stream over a time interval of one hour…
A:
Q: Determine the support reactions at A and E.
A:
Q: Molybdenum has a BCC crystal structure, an atomic radius of 0.1363 nm, and an atomic weight of 95.94…
A:
Q: A steady-flow Carnot refrigeration cycle uses refrigerant-134a as the working fluid. The refrigerant…
A: Given that: For a Carnot refrigeration cycle with R134a as working fluid, Condenser temperature is…
Q: A Carnot heat engine receives 650 kJ of heat from a source of unknown temperature and rejects 250 kJ…
A:
Q: Q3-For the truss shown in Figure (3), determine the forces in members BK, CD and DK. 9 B 20 KN 40 KN…
A: Draw the free-body diagram of the truss.
Q: A Simply Supported beam of 4 m span is in the form of hollow square bar (120x120 mm) as shown in…
A:
Q: 5- The moment of inertia of a square of side (a) about an axis through its centre of gravity is A.…
A:
Q: 3. A space at sea level is 25°F and RH = 30% Find the other properties of the air in that space. DB…
A: (3) Answer From psychrometric chart:- @ DB = 25F and RH = 30%, we get WB = 18.8 F Humidity= 0.00082…
Q: The thermal conductivity of a fluid is 0.09 BTU/ft-h-F having a kinematic viscosity of 0.0215 ft…
A: Given that: k = thermal conductivity of the fluid = 0.09 BTU/ft-h-F ν = kinematic viscosity of the…
Q: A ball is thrown vertically up with a velocity of 33.4m/s at the edge of a 47.1-m cliff. Calculate…
A:
Q: Derive the equations as given below as applied to COOLER - DEHUMIDIFIER apparatus using the basic…
A: According to the law of conservation of mass The mass entering the system = The mass leaving the…
Q: Q.5 (20%) Determine the reactions in C on member BCD as shown in figure? 6 m 4 m D 2 m 300 kN
A: Detailed explanation and solution of the above problem uploaded in below pictures.
Q: OS: A cylinder piston contains 100/ air at 110 kPa. The air is then compressed in a reversible…
A:
Q: The force F has a magnitude of 780 N. Express F as a vector in terms of the unit vectors i and j.…
A:
Q: 0.5 An aluminum bar with a cross-sectional area of 2 inches bears the applied axial loads as shown…
A: Given:Cross-sectional area of the bar, A=2*2 in2Modulus of elasticity, E=10*106 psi
Q: The ideal gas law, discovered experimentally, is an equation of state that relates the observable…
A: Given: mass: m Velocity: Vx Length: Lx collision is elastic To find: force ?
Q: 3- Concurrent forces are those forces whose lines of action A. lie on the same line B. meet at one…
A: Given: Concurrent forces are those forces whose lines of action A. Lie on the same line B. Meet at…
Q: (1)The brake mean effective pressure? (2) the mechanical effeciency
A:
Q: For the truss loaded as shown, determine the equation for the line of action of the stand-alone…
A: First, we should determine the angles α and β showed in the figure below:
Q: Q3: Water (p= 990 kg/m³ & μ= 0.0013 Pa.s) is pumping from an atmospheric water tank to wa with…
A:
Q: Calculate the conductive heat transport through the layered wall in kW of a furnace wall of 1 ft²…
A:
Q: Find the rectangular components for the four forces shown Z 40° 35° F₂ 530° 11F11 = 5 kN 11F₂11= 10…
A: Given, F1= 5kn , F2= 10 kn, F3= 20Kn F4= 40 Kn
Q: A gas mixture ( N_{2} =5% H_{2} =15% . NH_{3} =76% and Ar = 4% ) flows through a pipe, 25.4 mm in…
A:
Q: A ball with diameter D = 5 cm and with initial temperature 0 °C is to be exposed to air at 33°C, h =…
A:
Q: B- A human had a meal of 200 Cal, and drunk water, answer the following: Answer three only 1. What…
A: Given: A human had a meal of 200 Cal and drunk water. So in the meal there are some nutrients…
Q: 10. Outer space is almost a perfect vacuum, hence, are not possible between two separate surfaces.…
A: Given: A statement is provided with a blank which is needed to be completed.
Q: Each propeller of the twin-screw ship develops a full-speed thrust of F = 375 kN. In maneuvering the…
A: Given:Force generated by the propeller, F=375 kNc=14 ma=55 mb=100 m
Q: B/ Determine the resultant of the force system shown in Figure (1B) and show it on a sketch with…
A: Given :- To Find:- Resultant of the force system given above Distance/location of the resultant…
Q: What is the Reynolds number of a fluid flowing in a tube with an inside diameter of 1 inches? The…
A:
Q: An experimental device imparts a force of magnitude F-43 lb to the front edge of the rim at A to…
A:
Q: A water feed pump operates with a mass flow rate of 464 kg/s. The inlet pressure is 689 kPa and the…
A: Given data Mass flow rate = m = 464 kg/s Inlet Pressure = Pi = 689 kPa Outlet Pressure = Po = 26 MPa…
Q: A renewable energy project developer is beginning a new project. List and describe a selection of…
A: Given Renewable energy project developer To find Relevant issue
Q: The mass center G of the 1350-kg rear-engine car is located as shown in the figure. Determine the…
A:
Q: A Mineral with a hardness of 7 appears in two different forms. One is a six sided barrel-shaped…
A: Given question: A Mineral with a hardness of 7 appears in two different forms. One is a six sided…
Q: An adiabatic air compressor compresses 0.002 m³/s of air at 140 Kpa an 1.2 Mpa and 350 °C,…
A: Given data s per questionAn Adiabatic air compressorV1˙=0.002 m3/s, P1=140 kPa, T1=25°C=25+273=298…
Q: Determine the equivalent spring stiffness constant of the following spring in series and parallel.…
A:
Q: Figure F4ON -NON -KON 1 of 1 Determine the coordinate direction angle a of the resultant of the two…
A:
Q: B- A three-lobe rotary positive-displacement pump moves 0.45 cm³ of blood in each lobe volume Vlobe-…
A:
Q: IF load : 100N and Effort force : 500N How can we calculate Fulcrum force?? Do anyone have a good…
A: GivenLoad=100NEffort force =500N
Q: 14 The brass bar shown is loaded axially in compression so that the maximum stress induced is 125…
A: Given Maximum stress = 125 MPa Diameter, D = 30 mm Hole diameter, d = 20 mm Find Total…
Q: The joint is subjected to the axial member force of 6 kips. Determine the average normal stress…
A: Given:Force acting, F=6 kipThickness of the member, t=1.5 in
Q: The motion of a particle is defined by the relation x = 6tª + 8t³ - 14t² + 10t + 16 where x and t…
A:
Q: Q3- For the truss shown in Figure (3), determine the forces in members BK, CD and DK. 20 KN 8 40 KN…
A:
Step by step
Solved in 2 steps
- Qu: Caleulate the magnitude 4 direation f foree exerted on the three-quarter cylinder (ABCD), shown in figure below, which is (3m) long perpendicular to the figue. A lso prove that this force passes through paint O. 2m Water A BIf the weight of the container is 100kg. What a ere the tensions of cables AB, AC, and AD Also how do you know the coordinates. How do you know if they are negative or positive? Please explain why they are negative or positive and how do you find them(the coordinates), find the value of the force F required for the 98.7 bf block to rise with constant velocity. Consider the smooth surface and its inclination is 25 degrees. 0°
- A tank is filled with fluid under prcssurc anti the prcssurc gauge fixcd at the top indicatcs a prcssurc of 21 kPa. The curved surfacc of the top is quarter of a circular part of radius 2.6 m. calculate the magnitude (N) and direction (degree) of the resultant force on the cun'ed surface. (p=950kg./m³for fluid)In the set-up shown, a rectangular gate, ABCD, is used to store layers of oil and water. Theweight of the gate is 4 kN and the force exerted by the stopper on the gate is measured tobe 30 kN.Draw the free body diagram of the rectangular gate.The high-pressure water cock is rigidly attached to the support at D. Neglecting the weights of the members, draw the FBD of the entire assembly and count the unknowns.
- Find the force P required to hold the gate in the position as shown in the figure. The gate is 5 meters wide.Qu: Calculate the magnitude f direction of foree exerted ou the three-quar ter cylinder (ABCD), shown in figure below, which is (3m) [ong perpendizular to the figue. A lso prove that this force passes through point O. Water 2 mA cylinder with a mass of m and a diameter of D is moving downward on the oil film at clearance h. Please indicate the kinetic equation of the cylinder. Please tell me the process of solving.
- A cylader of l a fiandor is made with material of relative density o5. It is moored in fresh water by one end and the water level the sefrnde cyliader- is 1m abeye the middle of Find the tension of the moo Cable oProblem# 5 Container is placed over incliced plare, it accelarate at 10 m/s2, will the water inside tank spil from the container tank (200 300*400), the level of water inside the tank is 150 Also determine the force on the left side of the contaneralith the aid of an appro priate diagram, ex plain.why when a Capillary tube is inserted in a reserveir containing liquid, the Liguid level in the tube will rise or fall and denire an expression for the riselfell.