Answered: What normal force must be applied at…

Name: Note: Please state what formula you are using. And please be clear and
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: Note: Please state what formula you are using. And please be clear and detailed with your solution. Atleast explain. It will help me, thanks.Problem: A Triangular gate having a horizontal base of 1.30 m and an altitude of 2 m is inclined 45o from the

Engineering

Mechanical Engineering

What normal force must be applied at the vertex of the gate to open it?

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.113P: Calculate the resultant force caused by the water acting on the parabolic arch dam. The water levels...

See similar textbooks

Similar questions

Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen, air, and saturated steam at a temperature of 100C. Let D=1m,U=1m/sec, and hc=1W/m2K.
Compute the surface area of the axi-symmetric domed structure.
Calculate the resultant force caused by the water acting on the parabolic arch dam. The water levels are 16 ft on the upstream side and zero on the downstream side. For water, use =62.4lb/ft3.
Please be xlear and detailed with your answer. Write an explanation in every formula and solution you used. Problem: A Triangular gate having a horizontal base of 1 30 m and an altitude of 2 m is inclined 45 o from the vertical with vertex pointing upward The base of the gate is 2 70 m below the surface of oil s 0 80 What normal force must be applied at the vertex of the gate to open it? Show figure
Please be clear with your solution. Make an explanation for the formula and solution you used. Problem: A Triangular gate having a horizontal base of 1 30 m and an altitude of 2 m is inclined 45 o from the vertical with vertex pointing upward The base of the gate is 2 70 m below the surface of oil s 0 80 What normal force must be applied at the vertex of the gate to open it? Show figure
है water 2m diameter circular gate 3m 160⁰ CAREFUL WITH UNITS!! a) Find the magnitude F and point of application y R of the water force on the circular gate shown. Notice: 3 m to top of gate. Also, recall: circle | = pi D4 / 64. b) Also, if the liquid were crude oil (S.G. = 0.86), what would the force magnitude be? -
QI: In Figure below find the resultant pressure force and the depth of the centre of pressure on the cylinder gate of diameter 4 ft which has a circular hole of 0.9 ft diameter located above the centre of the main gate by I ft. 1.2 Oil, S-0.8 D-0.9
): Find the hydrostatic pressure force acting on the ABCD curvilinear surface. (The width of the gate is 3 m). Draw hydrostatic pressure distribution on this figure. 2.4m Water Water 1.6 m ANAA
Fluid Force on a Tank Wall :- In the given question/s find the fluid force on the vertical side of the tank, where the dimensions are given in feet.Assume that the tank is full of water :- (see the figure as attached here).
Force due to Liquid PressureProblem 3: A gate is in the form of letter T with the vertical 2 ft wide and 4 ft high. The horizontal crosspiece is 6 ft long and 1 ft high. Find the force on one side if the gate is submerged vertically with the top of the crosspiece along the surface of water
Suppose there is a triangle-shaped window installed vertically on the side of a city under the ocean. Assume that the bottom of the triangle is 2,000 ft below the surface of the water. The density of sea water is 63.93 pounds per cubic foot. The top of the triangle is 10 ft wide, and the triangle is 5 feet tall and is symmetrical about its middle. Refer to the drawing below: Find the fluid force on the window due to the ocean. 10 5
n. O • O M A : Homewo... -> Fluid Mechanics Basra Engineering Technical College Hydrostatic Forces Second Stage MSc. Zahraa A. Nadeem Home Works 1- A 60 cm square gate has its top edge 12 m below the water surfacc. It is on a 45 angle and its bottom edge is hinged as shown Waler in Fig. What force P is needed to just open the gate and its location? Hinge 2- A tank containing water is shown in Fig. Calculate the total resultant force acting on side ABCD of the container and the location of the center of pressure. y = 62.4 Ib/ft Water 3- Find the total pressure and position of center of pressure FREE WATER SURFACE on a triangular plate of base 2 m and height 3 m which is immersed in water in such a way that the planc of the plate 2 m- makes an angle of 60 with the free surface of the water. The basc of the plate is parallel to water surface and at a depth of 2.5 m from water surface. 4- The 200 kg, 5 m wide rectangular gate shown in Figure is hinged at B and leans against the floor at A…