What is the correct voltage divider formula? Please help thank you so much

Q: An air filled parallel-plate capacitor is connected to a 12 Volts battery, the battery is…

A: Given- 1st case: An air filled parallel plate capacitor is connected to Battery, V = 12 volts The…

Q: A MOS device with an aluminum gate is fabricated on a p-type silicon substrate. The oxide thickness…

A: A MOS device with an aluminium gate is fabricated on a p-type siliconsubstratetox=22nm=220…

Q: A three-phase, four wire, ABC system with a line voltage of 380 Volt, has three impedances of Z =10…

A:

Q: 18. A 10.0 µF capacitor, a 40.0 uF capacitor, and a 100.0 uF capacitor are connected in series. A 12…

A: Given,       C1=10 μFC2 =40μFC3 =100μFV = 12 V

Q: Required information Problem 06.015 - DEPENDENT MULTI-PART PROBLEM - ASSIGN ALL PARTS Two capacitors…

A: The given problem is from capacitor.  The detailed solution is given in the next step

Q: d) To measure currents in the simple circuit shown in Fig. 2 below, you would replace a wire between…

A: We know that  For measuring current we connect ammeter in series with the corresponding element…

Q: 8.33 The output power of filter is 100 mW, when the signal frequency is 5 kHz. When the frequency is…

A:

Q: TRUE OR FALSE: The Z-transform of x(n)= 0.25nu(n)+0.5nu(-n-1) is 0.25 < |z| < 0.5

A: Note: Z-Transform of anu(n)=11-az-1  , ROC Z&gt;aZ-Transform of anu(-n-1)=11-az-1  , ROC Z&lt;a

Q: Create a simple/personalized series and parallel resistors and supply them with a voltage. Resistors…

A: To draw the combination of a series -parallel circuit by using atleast non-identical resistors:

Q: Assuming ideal elements in the circuit shown below, the voltage Vab will be v 1 A a 2 Ω ww 5 V

A: Given circuit-   To find- The voltage Vab.

Q: what is the settling time, percentag eovershoot and time to first peak?

A: Given : G(s)=10(s+1)(s+3)(s+20)  and Gc(s)=21(s+1) A) what is the settling time, percentage…

Q: An LRC circuit is shown with an alternating source with a current given by i(t)= Icos(oot), with…

A: Note: Current and voltage in case of R Load is in phase. Current Lag voltage by 90 degree in L load…

Q: A balanced three-phase source with grounded neutral has line-to-neutral voltages of 135 volts with…

A: Given data Line-to-neutral voltage, VAN=135∠0° Series internal impedance, Zin=0.1+j0.15 Ω/phase Load…

Q: Problem 03.037 - Mesh analysis: Independent and dependent voltage sources In the circuit given…

A: The circuit is shown below:  In the above circuit, the voltage drop across the 4-ohm resistor is,…

Q: A five-bit DAC covers a voltage range of 0 to 2 V. Calculate how much voltage each bit is worth.…

A: The DAC problem is solved as shown below. The basic problem on resolution

Q: Given the circuit below, determine the Q of the network and calculate the phas voltage Vo as well as…

A:

Q: Question 3 The generator in the Fig. 2 is delivering 1.0 pu active power under pre-fault conditions…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: H.W. For a 2/4 dipole: 1. Find the radiation resistance. 2. Maximum directivity and maximum…

A: Dipole An electric dipole is a pair of charges that are equal and opposite, separated by a short…

Q: 1. What is the total inductance for the circuit shown? Hol+ L₁ = 75 µH L₂= 1.6 mH L₁ = 125 μH L₂=…

A: We need to find out the equivalent inductance for given circuit.

Q: Determine V₁, V2, and the power dissipated in all the resistors in the circuit of Fig. 3.50. 6 A "…

A: We need to find out node voltage and power dissipation in each resistor for given circuit .

Q: Required information Problem 06.001 - DEPENDENT MULTI-PART PROBLEM - ASSIGN ALL PARTS The voltage…

A:

Q: Problem 03.038 - Mesh analysis: Independent voltage and current sources In the circuit given below,…

A:

Q: If a receiver could use an ideal isotropic antenna, it could receive -40 dBm. How much could be…

A:

Q: The following results were obtained from measurements taken between the two terminals of a resistive…

A:

Q: -1 0 Problem 5: x= 2 0 1 0 i. == ii. Find the stability of the system Find the transfer function y=…

A: State space representation of a system is given it is asked to find the stability of the system and…

Q: Required information Consider the given circuit where = 6 mA. An ammeter with internal resistance R¡…

A:

Q: You are given a system whose input-output relationship is: y[n] = H{x[n]} = x²[n] + x² [n − 2].…

A: System input output difference equation is given it is asked to state the type of system

Q: ! Required information Problem 04.057- DEPENDENT MULTI-PART PROBLEM - ASSIGN ALL PARTS Consider the…

A: Thevenin's theorem The French engineer M.L. Thevenin discovered this theorem, which is also known as…

Q: a. Prove that sin (nwot) and sin(mwot) are orthogonal over a period.

A:

Q: Daily load of an industry is 200 kW for first hour, 150 kW for next seven hours, 50 kW for next…

A: Total annual bill in ruppes = Tariff rate per KWh× total KWh consumed by industry in a year +Tariff…

Q: Calculate for the low cut-off frequency of the bandpass filter given below. 1.5k vi-M 0.047u O 225…

A:

Q: In the circuit given below, R= 90 2. Calculate the mesh currents i and 12. R 10 92 40 V + % i₁ 310 Ω…

A:

Q: 2. The rotor resistance per phase of a 4-pole, 50 Hz, 3-phase induction motor are 0.025 and 0.125…

A:

Q: 4. An LRC circuit is shown with an alternating source with a current given by i(t)- Icos(cot), with…

A: Given: In this question, the given details are, The LRC circuit with an alternating source with a…

Q: For the circuit shown, determine the values of Rp and Lp if the bridge is balanced at f= 1 kHz.…

A:

Q: A noninverting current amplifier is portrayed in the figure below. Calculate the gain idis. Take R₁…

A: The operational amplifier problem can be solved as shown below.

Q: In the given circuit, where V= 20 V, determine the currents i, iz, and i3. 1Ω www V(+ 4Ω 2Ω The…

A:

Q: A conducting rod of mass 0.75 kg and resistance 1 Ohm is pulled in the horizontal direction across…

A: Magnetic field The magnetic field is the area around a magnet where magnetism is felt. The magnetic…

Q: Required information Problem 05.001 - DEPENDENT MULTI-PART PROBLEM - ASSIGN ALL PARTS The equivalent…

A: We need to find out the output impedance for given circuit.

Q: (15) Name three basic forms for interconnect ng subsystems. For each form, state how the equivalent…

A: 15)Interconnecting subsystem:⇒cascade⇒feedback⇒parallel

Q: Consider the following RL circuit with Vs-200V, R1-100 ohm, R2- 100 ohm, R3- 50 ohm, L-20 H. The…

A: The general expression of inductor current in series RL Circuit Charging…

Q: 16 -3 Q6: Consider a MOS device with a p-type silicon substrate with N = 2×10¹ cm³. The a -2. oxide…

A: Given: In this question, the given details are, Consider a MOS device with a p-type silicon…

Q: The output characteristics of the common-base configuration relate the levels of which of the…

A:

Q: a-Find the mathematical expressions for the transient behavior of iz and vi for the circuit shown…

A:

Q: To install an antenna with a line-of-sight transmission at a distance of 75 miles, determine the…

A:

Q: Question 57 A spacecraft in 550km circular orbit passes directly over a ground station. The ground…

A: We need to find out received power and gain for given system .

Q: Q3: Determine the currents I1, I2, and ID2 for the network of figure. the diodes are assumed to be…

A: We need to find out the current for given circuit.

Q: O An MOS structure made on a silicon wafer doped with 3.8 x 10¹5 cm-³ phosphorous atoms has a 40 nm…

A:

Q: Ql-calculate the total power for the following 3-phase circuit b Solution: 120-120° V Fille 120/120…

A:

Q: Given the impulse response of a DT-LTI system h(n) = -3(0.8)"u(n) a.) Find the magnitude and phase…

A: