Water is pumped to a storage tank from a pool by a centrifugal pump. The elevation difference between the pool and the storage tank is 60 m. The stórage tank and the pool are open to atmosphere. 50 meters of 6 in Sc 40 steel pipe is used between pool and pump. After the pump 6 in Sc 40 pipe with a length of 22 m is suddenly contracted to 4 in Sc 40 pipe, that is 70 m. The flow rate of water is 2.5 m/min and the temperature is 20°C. If the pump efficiency is 0.6 and the cost of electrical energy is 0.40 TL/kWh,calculate daily cost of electricity used for this system.

Water is pumped to a storage tank from a pool by a centrifugal pump. The elevation difference between the pool and the storage tank is 60 m. The stórage tank and the pool are open to atmosphere. 50 meters of 6 in Sc 40 steel pipe is used between pool and pump. After the pump 6 in Sc 40 pipe with a length of 22 m is suddenly contracted to 4 in Sc 40 pipe, that is 70 m. The flow rate of water is 2.5 m/min and the temperature is 20°C. If the pump efficiency is 0.6 and the cost of electrical energy is 0.40 TL/kWh,calculate daily cost of electricity used for this system.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q3: Two tank are connected with piping system as shown. If the pump characteristics are given by: hp- 31-120000 and, 7p--190000Q+8590Q Where hp is in meters and Q in m³/s and np is the pump efficiency (%).Estimate the operational cost of the pumping (10000) m² of water to the upper tank if the cost of IKwh is 2000 ID. Neglecting the minor losses. H=15mm 0-150mm
Water is pumped to a storage tank from a pool by a centrifugal pump. The elevation difference between the pool and the storage tank is 60 m. The stórage tank and the pool are open to atmosphere. 50 meters of 6 in Sc 40 steel pipe is used between pool andpump. After the pump 6 in Sc 40 pipe with a length of 22 m is suddenly contracted to 4 in Sc 40 pipe, that is 70 m. The flow rate of water is 2.5 m/min and the temperature is 20°C. If the pump efficiency is 0.6 and the cost of electrical energy is 0.40 TL/kWh,calculate daily cost of electricity used for this system
Please include a diagram.A pump supplies water at a flow rate of 4ft3/s from an open reservoir through a horizontal 8-in sched 40 pipe. The head loss from the reservoir to the suction of the pump is 2 ft-lbf/lbm, and the discharge is at 90 psig into a 6-in sched 80 pipe. The pump has an efficiency of 65% answer the following:a.) The head that must be delivered by the pump to the water is ________ or energy developed by the pump or output energy of the pumpb.) input energy to the pumpc.) Rated power of the pump in kW
In an industrial cooling process, water is circulated through a system. Ifwater is pump from the first floor through a 6cm diameter pipe with a speed of0.45m/s under a pressure of 400torr, what will be the pressure on the nestfloor 4m above into a pipe with diameter 2cm?
A pump receives water from a tank. If the pump needs 24 n of NPSHA, how high must the water level be above the pump centerline if the water saturated at 1724 kpa ? The friction loss in the pipe averages 0.3m for each 6m height and the flow is 23 lps in a 15024 cm id pipe.
The pump shown in the figure iswhen pumping water from a lake to a lake aboveIt gives 7.5 kW of energy to the water. your lakesThe elevation difference between the surfaces of 9 m and the loadloss is 4.5 m. under given conditionsa.) The flow through the pipes,b.) The power loss that occurs under these flow conditionsfind it.
A pump works between two opened tanks through a piFe of 10 cm diameter and length of 30 m with a friction factor of 0.02. The characteristic formula of the pump is given by H-52-1010 Q. There is a valve friction factor of 0.02. The characteristic formula of the located before the pump of minor losses factor (K) S Eten by the figure Q2 below, If the height of deliver side tank is 3 m Find:1) The volumetric fiow late n vaje Is fully opened 2) The percent valve setting if the dow rate is reduced by a half of the rate in )ASsame, free and large tank at the suction side tank]. Pump is given by H-52-1010 Q. There is a valve
A pump draws water at a head of 11Om and a discharge rate of 550 Ips. Determine the water power output if the pump efficiency is 70%.
The water needs of a small farm are to be met by pumping water from a well that can supply water continuously at a rate of 50 L/min. The water level in the well is 13 m below the ground level, and water is to be pumped to the farm by a 2-cm internal diameter pipe. The required length of piping is measured to be 20 m, and the total head loss in the piping system is estimated to be 10 m.a) Using Bernoulli equation, determine the pressure difference between the two points (A & B).
The water needs of a small farm are to be met by pumping water from a well that can supply water continuously at a rate of 50 L/min. The water level in the well is 13 m below the ground level, and water is to be pumped to the farm by a 2-cm internal diameter pipe. The required length of piping is measured to be 20 m, and the total head loss in the piping system is estimated to be 10 m. a) Using Bernoulli equation, determine the pressure difference between the two points (A & B). b) Taking the efficiency of the pump to be 70 percent, determine the rated power of the pump that needs to be purchased.
Water from a reservoir A 10 m elevation is drawn by a motor-driven pump to an upper reservoir B at 72 m elevation. Suction and discharge head loss is 0 0.15 m. For the discharge rate of 15 liters per second, find the power input to the motor if the overall efficiency is 8 percent.
A pump discharges 50 tons of water per hour to a height of 8 m, overall efficiency of the pumping system being 69%, what is the input and output power?