Water flows through a Venturi meter, as shown in the figure. The pressures of the water at locations a and b in the pipe support columns of water that differ in height by L = 12 in. The atmospheric pressure is 14.7 Ibf/in?, the specific volume of water is 0.01604 ft/lb, and the acceleration of gravity is g = 32.0 ft/s?. Patm = 14.7 lbr/in.? g= 32.0 ft/s? Water v = 0.01604 ft³/lb

Water flows through a Venturi meter, as shown in the figure. The pressures of the water at locations a and b in the pipe support columns of water that differ in height by L = 12 in. The atmospheric pressure is 14.7 Ibf/in?, the specific volume of water is 0.01604 ft/lb, and the acceleration of gravity is g = 32.0 ft/s?. Patm = 14.7 lbr/in.? g= 32.0 ft/s? Water v = 0.01604 ft³/lb

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The pressure of water flowing through a pipe is measured by the arrangement shown below. For the values given, calculate the pressure in the pipe. Po=30 kPa Air Pipe Waler 15°C Water hy = 50 cm 15°C L=6 cm h = 8 cm 4=6 cm Ciage fluid SG = 24
pls ans asap Water flows at 0.07 cubic meter per second through a pipe. A horizontal venturi meter with throat diameter of 150-mm was used to measure the velocity inside the pipe. Based on manometer reading, the differential gauge is deflected 1.2 meter. If the specific gravity of the manometer fluid is 1.60, the diameter of the pipe, in millimeter (mm), that was used is
Oil of sp.gr. = 0.9 flows through a vertical pipe (upwards). Two points A and B one above the other 40 cm apart in a pipe are connected by a U-tube carrying mercury. If the difference of pressure between A and B is 0.2 kg/cm, 1- Find the reading of the manometer. 2- If the oil flows through a horizontal pipe, find the reading in manometer for the same difference in pressure between A and B. %3D
... P1 = 50 KPa P2 = 10 KPa 4m OIL 1.6m OIL In the figure, an orifice is locates in the partition wall so that it discharges oil (SG = 0.8) from left to right side of the room. The orifice %3D has a diameter of 100mm and is under the surface of oil, 4m from the surface on the left and 1.6m from the surface on the right. The surface at the left is under 50KPA of pressure and the surface at the right side is under 1OKPA of pressure. Determine the actual discharge in the orifice if C = 0.92 112.03 L/s B 87.63 L/s 95.25 L/s 103.07 L/s No Answer among the choices
The tank contains water and immiscible oil with S=0.84. What is h in cm? 6 cm 12 cm Oil Water 8 cm
5. Figure shows the schematic representation for the measurement of velocity of air (density = 1.2 kg/m³) through a constant-area duct using a pitot tube and a water-tube manometer. The differential head of water (density = 1000 kg/m³) in the two columns of the manometer is 10 mm. Take acceleration due to gravity as 9.8 m/s2. The velocity of air in m/s is Flow 10 mm
Fig shows a U-tube differential manometer connecting two pressure pipes at A and B. Pipe A contains a liquid of specific gravity 1.6 under the pressure of 113 kN/m². The pipe B contains oil of specific gravity 0.6 under the pressure of 203 kN/m?. Find the difference of pressure measured by mercury as fluid filling U-tube in mm. The value of x and y are 2.2 m and 1.2 m respectively. P S X- Mercury The Mercury level difference (h) in mm
A tank is filled with water at a rate of 9 gal/min as shown in the figure below. Given that D = 3 ft and h = 1.5 ft, what is the rate of change of depth of the water in the tank in inches per minute? Vin. h O 1.15 inches/minute O 2.04 inches/minute 4.60 inches/minute
Q1(b) A multi fluid manometer is shown in Figure Q1(b). Determine the following: (i) Determine height 'h' if the difference in pressure between the two pipes is 15.38 kPa; (ii) Difference in pressure between the two pipelines if both pipes are in the same level. Take density of air = 1kg/m³ and density of water = 1000kg/m³. Oil SG 0.79 Gasoline SG = 0.70 PIPE Air- 45 cm Pipe hcm 22 cm 10 cm `Water `Mercury SG = 13.6
1- In steady flow,the fluid characteristics at a point do not change with B- pressure ..... Pa. 2- The value of atmospheric pressure Patm at sea level is A- Patm = 101300 Pa B- Patm= 100000 Pa C- Patm = 1000000 N/m² A- Time 3- The value of static pressure at a point in a liquid depends on ........... A- Surface area B- height of liquid C- width of tank 4- Piezometer is used for measuring. Pressures. A- High B- low 5- The rate of volume flow Q is expressed as. C-meduim A- Q = mass x velocity B- Q = force x density C- force A- Time C- Q = area x velocity 6- If the value of Reynolds number is more than 3000 the flow is called A- transition B- laminar C- turbulent A-high 7- In uniform flow the velocity at any given time does not change with respect to. B- pressure C- space B- The value of static pressure in a liquid depends on .......... ..............above the point. B- height of liquid C- width of tank A- Surface area - The unit of mass flow rate (m) is. A- M³/S B- N/M² ..........above…
A and B are cross-sections of two pipes with water flowing. These pipes look like To measure the pressure difference between A and B by connecting a U manometer is requested. The heights in the U manometer are given in inches (1 inch=25.4mm). Since Moil=850 kg/m3 and 'mercury=13600 kg/m3 A- Find the pressure difference B. B Oil 8 -H20 10 H20 4 3 Hareketli plaka -Hg-
A differential manometer connects two pipelines as shown. Fluid 1 is water and fluid 2 is glycerin (SG = 1.26). Temperature is 20°C. hi = 27 cm h2 = 28 cm h = 33 cm Determine the difference in pressure between the two pipes. Which pipe has the higher pressure? Fluid 1 Fluid 2 B Mercury