Water flows at a rate of 1.17L/s through a flanged faucet with a partially closed gate valve spigot. The inner diameter of the pipe at the location of the flange is 2cm, and the pressure at that location is measured to be 90kPa. The total mass of the faucet assembly plus the water within it is 5.7 kg. Calculate the net force on the flange.

Water flows at a rate of 1.17L/s through a flanged faucet with a partially closed gate valve spigot. The inner diameter of the pipe at the location of the flange is 2cm, and the pressure at that location is measured to be 90kPa. The total mass of the faucet assembly plus the water within it is 5.7 kg. Calculate the net force on the flange.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter8: Leak Detection, System Evacuation, And System Cleanup

Section: Chapter Questions

Problem 2RQ: Name and briefly describe the six classes of leaks.

See similar textbooks

Similar questions

Please urgenttttttttt
2.) Hệ thống thể hiện trong hình được sử dụng để đo chính xác sự thay đổi áp suất khi ap suất được tăng lên bằng A P trong đường ống nước. Khi A h=70 mm, sự thay đổi áp suất đường ống là bao nhiêu? Đáp số: AP = 867 Pa Water Pipe Glycerin, SG 1.26 D= 30 mm Ah d=3 mm
slove this fluid problem
A Vessel ot yn Yolume contuine.an DiL which wsighs. 30.2KND
FBD COMPLETE SOLUTION
complt solution
Please solve using turbulent flow equations.
Hw SAE 10W30 motor oil is used as a lubricant between two machine parts 4 lbf.s ft² (bf f+² What is the required spacing in inches? O Assume M=1х10 Tmax=2 du= 4 ft
Part B plz
Is there a flaw in the pipeline design as shown in Flgure 4 ? (select one): (A) The strainer and foot valve should not be used as the combination may cause cavitation. (B) The foot valve should not be used as it may cause cavitation. (C) The pump should be placed at a higher elevation to prevent cavitation from occurring. (D) The gate valve should not be placed on the suction side of the pump as it may cause cavitation. (E) The intake is not placed deep enough below the water surface of the river as it may cause cavitation. (F) None Elevation 180 m- 450 All of Steel Pipe Diameter 250mm· Smooth Bend B Gate Valve- (wide open) River Elevation -Pump at Elevation 125 m 120 m Smooth Bend Sump -Strainer and foot valve at 115m Figure 4
Fbd and equation should be included
aolve very very fast in 15 min | dybala