V3 is 9m/s, find h.

Q: An isolated traffic signal with pedestrian indication angled intersection with road A, 18 m wide and...

A:

Q: From the figure shown, determine the quantity of materials required for a 7 mx 4 m bedroom for the 2...

A: Given Data Length of bedroom = 7.0 mWidth of bedroom = 4.0 m Spacing of the joists = 0.4 m  

Q: A hollow circular section, of external diameter 200 mm and thickness 20 mm is used as a beam. The ma...

A: Given data,  External diameter = 200 mm Thickness = 20 mm Internal diameter = 160 mm Maximum bending...

Q: Compute the acceleration of body B and the tension in the cord attached to it. 300 lb 4-0.20 200 lb ...

A: Given: The coefficient of friction is 0.20. Consider the figure,

Q: Situation 1| Simply Supported Beam ABCDE below carries multiple loads as shown. A built-up section m...

A:

Q: A particle has an initial velocity of 100 fps up to the left at 30° with the horizontal. The compone...

A:

Q: A uniform slender rod (E= 210 × 103 MPa) of length 3 m and cross-sectional area of 250 mm2 is rotati...

A:

Q: Determine the reactions and the force in each member of the trusses shown using methods c consistent...

A:

Q: A box section ABCD is subjected to different loadings on all the four sides as shown in the figure. ...

A: Given arrangement, For a box section ABCD Ratio of fixed end moments at A and B for the member Ab

Q: The 29-N force Pis applied perpendicular to the portion BC of the bent bar. Determine the moment of ...

A: Given data,  P = 29 N θ = 48 ° To find out the moment of P about A and B. 

Q: P1. Two bodies A and B are separated by spring. Their motion down the incline is resisted by a force...

A:

Q: definition of a digital envelope

A: definition of a digital envelope

Q: Determine the diameter of a cast iron pipe which is required to carry water at 10 degrees C at the r...

A: Given Discharge, Q=250 liters/secLoss of head= 2m/100m length of pipeAverage height of pipe wall=0.3...

Q: What is negative superelevation and cant deficiency. Briefly explain with a neat sketch

A: Introduction:  Super-elevation  is the transverse slope provided to counteract the effect of centrif...

Q: Determine the resultant (in newton) of the forces acting on the pin as shown in the figure if the fo...

A: Determine resultant,R=?

Q: Determine the flexural stress at point A (in MPa) given that the bending moment applied to the secti...

A:

Q: Find deflection at C and D. Using Moment- 22,500 lb Area Method 3000 lb/ft B D 4 ft 12 ft 6 ft 8 ft

A:

Q: Calculate for the following member forces of the frame shown below using Portal Method. a. Shear at ...

A:

Q: Solve for the following internal forces occurring on the beam loaded as shown below a. Moment at B i...

A: Given-                                Here, a= 4.1 m, b=45.6 kN/m, c= 33.4 kN , d= 13.8 kN/m Calcula...

Q: Compute the intensities of active and passive earth pressure at depth of 6 m in dry cohesionless san...

A: Given that, H = 6m φ = 30°, Unit weight of the sand, Y = 18kN / m³   Find   Active and passive Earth...

Q: RIN/m A shallow foundation shown below, with e,=0.34 m and eg=0.28 m. Water level is located at a de...

A:

Q: 300 N/m

A: RA + RB = (0.5 x 3 x 0.3)+ ( 0.5x0.3x1.5)  RA + RB  = 0.675  RB x 4.5 = (0.5 x 3 x 0.3) x 2 + ( 0.5x...

Q: (5000 mm2) (4000 mm?) (5000 mm2) (5000 mm2) 140 kN 5 m 5 m 3m (4000 mm?) (zuu 000r)

A: Given : Determinate truss E = 200 GPaMethod of Consistent Deformation

Q: 120 mg/m3 of SO2 concentration is present at STP. What will be its concentration in ppm at 20°C?

A:

Q: For the beam shown, do the following: 1. Determine the values of shear at every change of load point...

A:

Q: Cement Mortar Plaster Lime Plaster Gypsum Plaster Gypsum Plaster High-Strength Gypsum Plaster Fibere...

A: The objectives of plastering are: To conceal defective workmanship To give smooth surface to avoid ...

Q: A hollow circular section, of external diameter 200 mm and thickness 20 mm is used as a beam. The ma...

A:

Q: . For the beam loaded as shown in the figure below, determine the following unknowns using a geometr...

A:

Q: a. Axial force on member marked with a in kN. b. Axial force on member marked with b in kN.

A: Axial Force in member a is 10.2 KN   

Q: Problem 1. A simple curve having a radius of 229.18 m has a back tangent of N 28° E, and a forward t...

A: We have to determine the value of deflection at the point of intersection of the property line and s...

Q: solve the whole truss   find equilibrium   find R1 ,r2, FAB,FAI,FBC,FBI,FCI, FCH,FCD, FIH, FHD,F...

A:

Q: A borehole log profile in a construction project is shown in the figure. The proposed construction w...

A: Given : Net stress, σnet = 12 kN/m3Unit weight of water, γw = 9.81 kN/m3                            ...

Q: Determine the diameter of a cast iron pipe which is required to carry water at 10 degrees C at the r...

A:

Q: 300 lb 4-0.20 200 lb

A: Hi! Thank you for the question As per the honour code, We’ll answer the first question since the exa...

Q: What is the definition of a digital envelope?

A: Dear student, Please find the answer in the below attachments Thank you 

Q: 1. Calculate the bar force in member AB due to REAL loads in kN.0 2. Calculate the bar force in memb...

A: Given data in question  Loads Dimensions  Truss To find out  Member forces Note We will use method o...

Q: Determine the stress produced in rod if tensile load of 3.3 N aplied on

A: Determination of stress in rod####  

Q: What is the pH of the solution containing 10-5 M H2SO4? Assume complete dissociation of H2SO4 in wat...

A: Given data,Concentration of H2SO4=10-5To find the ph of the solution

Q: Given a cantilever beam with given loadings and cross-section as shown in the figures, what is the s...

A:

Q: The floor frame shown carries a (superimposed) service dead load of 2.2 kPa. Slab S1 is 110 mm thick...

A: Density of concrete=23.6 kN/m3 Density of cement=31.5 kN/m3 (g=10 m/s2) Therefore,load of 25 mm ceme...

Q: The cantilever beam in the figure is a 3 m long h229 wide flange profile. the isolated load at the f...

A:

Q: An embankment load on a silty clay soil layer as shown below. Determine the stress increase under th...

A:

Q: Map distance=5 cm Ground distance%3D2 km Determine scale

A: Given data : The value of map distance=5 cm The value of ground distance=2 Km   To find: Scale of ma...

Q: CE - 4510 HOMEWORK # 7 4-#子 ) f'c= 5000 psi fy= 60ki In= 30'-0" %3D %3D 2" %3D WoL 5 KLF %3D 36 FIND...

A:

Q: Find the moment (kN-m) at point A if the following data and figure are given: 1 square = 1 sq.meter ...

A: To find the moment at point A 

Q: Situation 1| Simply Supported Beam ABCDE below carries multiple loads as shown. A built-up section m...

A:

Q: Determine the moment capacity of the section, kN-m, if fbcap≤300 MPa.

A:

Q: 40 kN/m 15 KN/m 600 mm GOomm 600 mm

A:

Q: Determine the location of the horizontal neutral axis of the section (in mm) with respect to the bot...

A:

Q: THE THEE-HINGED TIED ARCH IS SUBJECTED TO THE LOADING SHOWN IN THE FIGURE. HEMBERS CH AND CB. MEMBER...

A: Given  Three hinge arch  Symmetric Calculate force in cb and ch

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?