Using NSCP 2015 and Fy = 50ksi, determine the fcPn and Pn /Qc for the column shown. L C10X15.3 W8X24 KL = 12ft

Q: write a short litrature review on buoyant or floating houses

A: This question is related to the Building construction from Civil Engineering. In this question ask…

Q: 1. You are to design four sedimentation basins which operate in parallel. The total flow influent,…

A: Q- 24 MGD B- 30 ft  L- 240 ft d- 10 ft  μ= 2.73 ×10-5 lb/sec/ft2 T=50° ν= 1.41×10-5 ft2/sec s=1.6 To…

Q: 2. [Ac, 0c] Use conjugate beam method. (EI is constant) 30 ft B 15 ft 15 k C

A:

Q: Assume that an aquifer being pumped at a rate of 40 cubic feet per minute is confined and pumping…

A:

Q: Problem 7 A simple curve having a radius of 150 m. connects two tangents that meet with an…

A: Given data: Radius of curve, R=150 m Intersection angle, I=55o30' Using the general formula for…

Q: 4. The supported beam in Figure 4 is being tested for a bridge design. Knowing that the beam AB…

A: Simply Supported Beam: A beam that consists of two supports at each end of the beam and which is…

Q: The biggest economic advantage of CMU over concrete is: it is less labor intensive it can be…

A: CMU STANDS FOR CONCRETE MASONRY UNIT.

Q: A closely coiled helical spring made of 10mm diameter steel wire has 15 coils of 100mm mean…

A: Given: Closely coiled helical spring diameter, d = 10 mm Total number of coils, n = 15 Mean…

Q: 10f2 A toft etermine the vertical displacement of Joint C A = 0.5 in² E = 29 #10³ ksi F BO 4K 10 ft…

A:

Q: Q2. The beam supports a uniform dead load of 0.4 kft, a live load of 1.5 kft, and a single live…

A:

Q: Q1] The precast floor system consists of a 150-mm-thick concrete slab carry its self weight as well…

A:

Q: A square footing is to be constructed as shown in the Figure below. The design load, Qdesign is…

A:

Q: My book says the right answer was 90 kPa

A: Given data in question  Unit weight of dry bark clay 18 kN/m3 Saturated unit weight 15 kN/m3 and 21…

Q: 5. For the soil profile given below, assume that the primary consolidation settlement for the clay…

A: Answer  We know that secondary consolidation settlement for the clay layer is given by Ss =…

Q: efly describe the differences between the handcrafted versus machine production in design, craft and…

A: The Differences  between the handcrafted versus machine production in design, craft and architecture…

Q: 6 ft 2.5 ft O2.93 kips O 4.54 kips O4.84 kips (1) B 3 ft P 8 ft 1.5 ft (2)

A:

Q: Area by Triangle Sample Problem 1 LINE PA PB PC PD BEARING N 41°30' W N 38°10' W S 70°20' W S 60°15'…

A: This question is from Surveying.

Q: The relative compaction (RC) of a sandy road base in the field is 90%. The maximum and minimum dry…

A:

Q: Question Sadadae Sac A direct shear test was conducted on a cohesionless soil (c = 0) specimen under…

A: Given- Shear stress- τ=100 kPa, Nominal stress- σ=100 kPa, Cohesion C=0, It is needed to find the…

Q: A timber beam is 120 mm wide and 200 mm deep and is used on a span of 4 metres. If the stress due to…

A: Given data,  Length = 4 m Maximum bending stress = 7 N/mm² B = 120 mm D = 200 mm

Q: ΤΑ 9 kips/ft 10'- B 20 kips 6'- 6². 9 kips/ft C 10- D

A: To draw BMD and SFD using the Moment Distribution Method

Q: 6. Details of a retaining wall are shown in the figure below. The unit weight of the wall material…

A:

Q: 17 Calculate the number of degrees of freedom Figure 6

A:

Q: Assume that the flexural rigidity of the beam is constant. Given: w=6w0 Determine the reaction at…

A:

Q: A weight of 900N is supported by two metallic ropes as shown in the fig. The tension in OB rope is…

A: Given: Forces in members To find: Tension in the rope OB

Q: y Determine the moment of inertia of the beam's cross-sectional area with respect to the x and…

A:

Q: Find (a) Ix 3 (b) Iy for the composite

A:

Q: 3. Determine all of the reactions on the beam using Three Moment Equation. Provide free body…

A:

Q: Irrigation water is to be provided to a crop in a field to bring the moisture content of the soil…

A: Given data- Existing water content WP = 18%=0.18, Field capacity of the soil FC= 28%=0.28, The…

Q: 4. Use the manning's equation above to find the streamflow rate (Q) under the following conditions:…

A: Manning's Equation: Manning's equation is used to determine the velocity of the flow of the water…

Q: circular cylinder 400 mm in diameter and 750 mm long has 600 mm of its length submerged in kerosene…

A: Given data,  SG of kerosene = 0.823 L sub = 600 mm D = 400 mm L = 750 mm

Q: For the beam below, the support reactions at QA and B have deen calculated and given as below.…

A:

Q: A closed right circular cylinder has radius 2 units and height 17 units  A load of an unknown weight…

A:

Q: Determine the diameter of a circular sewer pipe (to the nearest inch) to accommodate a design flow…

A:

Q: William Rees and Mathis Wackernagel address the environmental consequences of urbanization. They…

A: Brief Concept Introduction- Environmental consequences of urbanization- The larger regional habitats…

Q: 2m B E Q-For the beam shown, draw influence lines for RAVE. ME. V. Me, MA, and VB F Im C 4m

A:

Q: Design a rectangular beam for the ultimate cesign moment M₁ = 500 kN m. The beam dimensions as shown…

A: Given : Mu = 500 kN-m h = 500 mm b = 350 mm Use - 400 MPa steel and 30 MPa concrete This is a…

Q: Void ratio of a soil is 0.9, its porosity shall be

A:

Q: spread-footed foundation has top area dimensions of 3 m by 1.5 m. The vertical depth (h) of the…

A: According to given data  A spread-footed foundation has top area dimensions of 3 m by 1.5 m. The…

Q: Which of the following is not a pleading? subpoena answer complaint motion

A: The major pleadings are the complainant, the answer, the cross complainant, and the reply.

Q: The plinth area rate and plinth area of a building is Rs. 5500 per Sq.m and 150 Sq.m respectively.…

A:

Q: stadia

A: This question is from Surveying.

Q: use Castigliano's Method for Beams and Frames Determine the slope and the displacement at the end C…

A: Young's Modulus of elasticity (E) = 200 GPa Moment of Inertia (I) = 70 x 106 mm4 E I = 200 x 103 x…

Q: A uniform rod KJ of weight w shown in the figure rests against a frictionless vertical wall at the…

A: A )  Given data : w = 10 kN  a  = 4 m b = 3 m  To Find : The min. coefficient of static friction…

Q: diagrams

A: This question is from Strength of materials.

Q: Wi 3 P₁ 1.5 | IM IM + 2m We 1.5

A: This question is from Strength of Materials.

Q: Determine the degree of determinacy. * O Unstable 02 O Determinate O 3

A:

Q: . Determine the rotation angle of pulley D with

A:

Q: Determine the weight of water (in kN) that must be added to a cubic meter of soil to attain a 95 %…

A: Given data : Degree of saturation = 95 % Dry unit weight = 17.5 kN/m3 Moisture  = 4 % Specific…

Q: Irrigation water is to be provided to a crop in a field to bring the moisture content of the soil…

A: Given data,  Permanent wilting point = 18% Field capacity = 28% D = 0.7 m Density of soil = 1.3…

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.