Answered: Using bundled conductors, corona effect…

Engineering

Electrical Engineering

Using bundled conductors, corona effect will ______________ 1- increase 2- not change 3- decrease 4- become zero

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter15: Dryer Outlet, Lighting, And Receptacle Circuits For The Laundry, Powder Room, Rear Entry Hall,and Attic

Section: Chapter Questions

Problem 10R

See similar textbooks

Related questions

Q: 8. Where the nameplate of an air-conditioning unit specifies the minimum ampacity required for the…

Q: For installing directly in a concrete slab, (armored cable), (non metallic-sheated cable), (rigid…

A: For installing directly in a concrete slab Rigid metal conduit (RMC) can be used. A rigid metal…

Q: If a 1 1/4-in. EMT raceway containing three conductors is already filled to 20%, what is the…

A: Need to find cross sectional area of raceaway

Q: When calculating a dwelling lighting load on the "volt-ampere per ft" basis, the receptacle load…

A: Given: Receptacle loads used are Floor and table lamps. When dwelling loads are calculated what must…

Q: Describe what the following conductor designation means when it is printed on the insulation;…

Q: Equipment Grounding 13. A metal elbow is a part of a nonmetallic, underground raceway. The elbow…

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: How can you calculate the maximum short-circuit current that can pass when the A-B ends of an outlet…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: Please read the following questions carefully and then elaborate on cach of 1-Describe wireless…

A: Some technical challenges that a wireless communication faces are i)multipath propagation…

Q: 9. How is equipment containing ungrounded electrical systems required to be marked? A. With green…

A: An ungrounded system is a system that is not grounded intentionally. The neutral wire of an…

Q: The minimum size raceway for the following branch circuit conductors is: Twelve, 6 AWG conductors…

A: The transmission of power from one place to another is very necessary, usually, the voltage level of…

Q: A 15-ampere, 120-volt lighting branch circuit would be 12 amperes maximum connected load. true or…

A: Since generally loading can not be more than 125% of maximum load, so we can load this system upto…

Q: 11. Which of the following statements about the use of structural steel as an equipment grounding…

A: We are authorized to answer the first question since the exact one wasn’t specified. Please submit a…

Q: Question 5 If a building or structure is supplied by a feeder from an outdoor separately derived…

A: Given statement, If a building or structure is supplied by a feeder from an outdoor separately…

Q: QUESTION 5 a) What is the difference between neutral and earth? b) Differentiate between…

A: In a three phase system, there are two ways to connect a three phase load. Star/Wye Connection.…

Q: 1. What is the proper size copper grounding electrode conductor for a 100-ampere service that…

A: Given-Rating of service conductor=100 ASize of phase conductor= 3/0 AWG

Q: 5. How many system bonding jumpers normally are there for a separately derived system that's…

A: We are authorized to answer only 1 question at a time since you have not mentioned which question…

Q: 12. What is the conduit and wire equivalent to a 400A bus duct with both copper and aluminum?…

A: The National Electrical Code (NEC) is a collection of rules for the secure electrical wiring wiring…

Q: Restrictions on types of conduits used for installing service, sub panel, emergency service panel.

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: List the methods by which an equipment grounding conductor is connected to a device box

Q: The white wire of a cable may be used to connect to a "hot" ungrounded circuit conductor only if ?

A: A "hot" ungrounded cable is the wire that carries major power from the source terminal to the…

Q: A conductor with continuous white or gray covering shall be used only for the grounded circuit…

A: According to article NEC 200.6, the facts about the identification of the Grounded conductors are…

Q: How far can a 230V, 50A, three-phase load be located from a panelboard if it's fed with 3 AWG…

A: The Length of the load from the panel board is calculated as shown below

Q: installing

A: From NEC 517-160A5 color code for isolated power conductor.orange with stripe→conductor 1Brown with…

Q: Basically, ______receptacles are required to be installed if an equipment grounding conductor is…

A: Article 406 of NEC covers the installation of receptacles of both grounded type and non-grounded…

Q: What type of bonding jumper connects the grounded circuit conductor and the equipment grounding…

A: In a power system , Main bonding jumper connects the grounded circuit conductor and the equipment…

Q: mast-type service entrance

A: The service raceway according to NEC is defined as an enclosed channel specially designed to hold…

Q: How many conductor volume allowances should be applied for the equipment grounding conductors in the…

A: We need to answer how many conductor volume allowances should be applied for the equipment grounding…

Q: What type of electrical conductor is used for underground applications?

A: Type SE or USE cables are used for underground application. This contain two or more conductors, is…

Q: L1. Boxes are classified by type, construction, and A. installation location. B. luminaire support…

A: 1) Boxes are referred as a electrical boxes are of plastic or metallic, Boxes are used in light…

Q: Which of the following is a term missing from the National Electrical Code but used by manufacturers…

A: ANSWER (1) Grounding Triad is the term which is missing in NATIONAL…

Q: When a service is supplies by a grounded system, the ________ is required to be routed from the…

A: System is said to be grounded if it is connected to the earth by any conductive path inorder to…

Q: In both exposed and concealed locations, where a cable or raceway-type wiring method is installed…

Q: The point of attatchment of the service drop conductors to a building must not be less than ______…

A: The point of attachment of the service drop conductors to a building must not be less than 10 feet.…

Q: What 3 colors are ungrounded conductors not permitted to be?

A: According to NEC, red or black wire must be used for ungrounded conductors. Red wire also use in…

Q: In an ungrounded electrical systems with conductors installed in grounded metal raceways and…

A: In an ungrounded system, the system has no direct connection with the grounding electrode. When the…

Q: rue or false : can broken wires or water cause a long circuit ?

A: When wires get broke , passage of electricity in that wire also breaks

Q: It is not uncommon for electrical designers to require an equipment grounding conductor to be…

A: True, Because for each and every equipment there is different grounding required according to the…

Q: Fuse and circuit breakers are the common household circuit. TRUE OR FALSE

A: Answer: TRUE Because Nowadays in every where we use these fuses and circuit breaker to protect our…

Q: 15 A certain type of Suspension Type Insulator is used to sustain heavy tensile loads of conductors…

A: Given that Suspension type insulator is used to sustain heavy tensile loads of conductors when the…

Q: Equipment grounding conductors that are permitted to be used to ground luminaires are found in NEC…

A: The NEC( National Electricity code) is a regionally acceptable standard safety code for electrical…

Q: Starting from the Core to the Serving, the proper order of the layers of the Underground Cable is O…

A: Power system requires transmission of power from generation end to the consumer end. The power…

Q: is the required size of THHN copper conductors for a feeder serving two 208Y/120V, four-wire,…

Q: The copper line with a total length of 20 meters operates in the 220 volt city network. If three…

Q: Are double locknuts an acceptable bonding method for Class 1, Division 1 Hazardous locations? If…

A: Double locknuts are not totally acceptable bonding method for the class 1, division 1 hazardous…

Q: What is the smallest size conduit that can fit 13 #8 RWU90 conductors?

A: Given: 13 #8 RWU90 conductors The diameter of one cable of the #8 RWU90 conductor is 0.306 inches.…

Q: Please provide Handwritten answer Question: NEC Reference Answer __________ __________ _____ is…

A: Although, Patient equipment grounding point is used ,to the eliminate the electromagnetic…

Q: List the type of insulators most suited for corners and bends. What is the purpose of connecting…

Q: 10.A. Which of the following is required in each separate service disconnecting means? A. Grounding…

A: In the given MCQ question, options are given and we need to choose the correct response.

Concept explainers

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.

Question

q1/

choose the correct answer

Using bundled conductors, corona effect will ______________

1- increase

2- not change

3- decrease

4- become zero

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

a) Determine total admittance and impedance. b) Draw admittance diagram and impedance diagram. c) Determine the values of C and L. d) Determine the voltage ?? ⃗ and the currents ?? (Se image ! last task)
What follows is a numeric fill in the blank question with 3 blanks. Figure 1 shows the three phases V-t graph in Turkey. Please write the indicated values with their units in boxes and Voltage - time function of each phase in table below. Please write the units in the second box. 1= _______________ V 2= ________________ms 3= _______________ms
When connecting a multiwire (3-wire) circuit to a single phase panel, one ungrounded conductor must be connected to the ____ phase and the other ungrounded conductor must be connected to the ____ phase. Select one: a. A, A b. B, B c. A, B d. doesn’t matter
If the critical commutation time is 2 ms but it was observed that the practical commutation took 2.5 ms. This is the case of __________a) under commutationb) over commutationc) critical commutationd) none of the mentioned
The total current in the figure is _________.
Good day, sir/ma'am. Here is the final question which I require assistance with. Thank you very much. Question: A power transmission line is made of copper 1 .80cm in Find the resistance of one mile of this line.
1. Alternating current systems of less than _______ volts are required to be grounded if they're installed outside as overhead conductors. A. 50 B. 100 C. 75 D. 120
Consider the circuit in the given figure. Assume R1 = 130 Ω and R2 = 310 Ω. Calculate current i in the given figure when the switch is in position 1. The current when the switch is in position 1 is ________ mA.
QUESTION 87 Unless otherwise specified, the applicable product standards evaluate the fill markings covered in 314.28(A)(3), based on conductors with Type _____ insulation. a. RHW b. THHN c. XHHW d. THHW
The ohms per 1000 feet measurements for conductors can be found in _____. Select one: a. article 100 definitions b. 310.15(B)(16) c. annex C d. chapter 9 Table 8
Fill in the blank The ___________ causes a low value of residual voltage which, in turn, causes a small current to flow in the field coils.
Q3/ Complete the blank In 3-phase system, the power consumed by star connected load is _______________times less than delta connected load.