urfaces A and B are concentric cylindrical tubes with diameters of 275 and 300 mm, respectively. Determine the overall interchange factor of surface A to B if the emissivities of the surfaces are 0.37 and 0.81, respectively. Both surfaces ar

urfaces A and B are concentric cylindrical tubes with diameters of 275 and 300 mm, respectively. Determine the overall interchange factor of surface A to B if the emissivities of the surfaces are 0.37 and 0.81, respectively. Both surfaces ar

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter11: Heat Transfer By Radiation

Section: Chapter Questions

Problem 11.38P

See similar textbooks

Related questions

Q: Consider a blackbody at 300K with maximum emissive power. Calculate the wavelength (μm) of the…

A: In the graph of emissive power and wavelength of the radiation, it is observed that at a particular…

Q: The spectral emissivity and spectral reflectivity of a diffuse surface are given below: 1.0 0.2 0.2…

Q: wo parallel surfaces each 1.83 x 1.83 m square are spaced 0.91 m apart. Both are black surfaces.…

Q: 2. Calculate the view factor FBA for the following shape. The radii for the hollow circle, circle A…

A: Given that, Radius of hollow circle A, rA=8 m, and RA=10 m,Radius of circle B, RB=5 m,Vertical…

Q: A space satellite in the shape of a sphere is traveling in outer space, where its surface…

A: Given data: TS=315.2 KT∞=2 Kε=0.15 Need to determine the heat loss per m2 by radiation.

Q: Two parallel disks of diameter D = 0.8 m separated by L = 0.4 m are located directly on top of each…

Q: 13-56 Consider two rectangular surfaces perpendicular to each other with a common edge which is 1.6…

A: Given data:Length, L1 = 0.8 mLength, L2 = 1.2 mWidth, w = 1.6 mTemperature of horizontal rectangular…

Q: A horizontal opaque flat plate is well insulated on the edges and the lower surface. The top surface…

Q: Two large parallel surfaces (surface 1 and surface 2) kept at constant surface temperature of T= 300…

Q: 0.3 0.1 3. 7.

A: Any given surface at any given temperature (absolute) will emit thermal radiation in all possible…

Q: Consider a 20-cm x 20-cm x 20-cm cubical body at 750 K suspended in the air. Assuming the body…

Q: (a) Determine the radiant power from the heater, which is incident on the disk, q,1- What is the…

Q: Consider two coaxial parallel circular disks of equal diameter D that are spaced apart by a distance…

A: Considering the diameter of the two discs are equal. Thus, the radii of the two-discs are equal.…

Q: 13.18 A drying oven consists of a long semicircular duct of diameter D = 1 m. T; = 1200 K - T2 = 325…

Q: The variations of the spectral emissivity of two surfaces are as given: Surface 1: ɛ1=0.3 0 ≤ λ <…

Q: 1.5) Fill in the blanks: A body whose surface properties are independent of wavelength is said to be…

Q: 13–19 Determine the view factors F13 and F3 between the rectangular surfaces shown in Fig. P13–19.

A: It is required to determine view factors F13 and F23 between the rectangular surfaces of the given…

Q: The emissive power of a blackbody is P. If its absolute temperature is doubled, the emissive power…

A: Solution: Given dataEmissive power of black body (Eb)1 = P T1=TT2=2T

Q: A small disc-shaped earth satellite, 1m in diameter, circles the earth (radius 6250 km) at a…

A: Given details: d=1 mε1=ε2=0.3Tsatellite=-18°CT2=27 °Cσ=5.67×10-8 w/m2k4 here σ=stefan boltzman…

Q: Calculate the view factor FBA for the following shape. The radii for the hollow circle, circle A…

A: Given: DA=10 mdA=8 mDB=15 m

Q: A directionally emitting surface has an emissivity of 0.7 for angles up to 45° from vertical and 0.2…

A: Solution: Emissivity = 0.7 for angles upto 45 degrees Emissivity =0.2 for rest of the angles

Q: Two coaxial parallel disks of equal diameter 1 m are originally placed at a distance of 1.5 m apart.…

Q: A spherical particle of diameter DI = 10 mm is suspended by a thin wire within a cylindrical tube of…

A: Given: Length of the tube→L=0.5 m=500 mm Inner Diameter of the tube→D2=30 mm=0.03 m Diameter of the…

Q: Two parallel disks of diameter D=0.8 m seperated by L=0.4 m are located directly on top of each…

A: As per given question Determine the net rate of radiation heat transfer from the disks to the…

Q: Determine the overall interchange factor from surface A to B where surface A is a spherical shell…

Q: Consider a cylindrical furnace with ro = H = 1 m, as shown in the figure. The top (surface 1) and…

Q: 13.26 A furnace is constructed in three sections, which include insulated circular (2) and…

Q: Determine the view factors from the very long grooves to the surroundings without using any view…

A: The schematic view of the geometry

Q: 12.37 Consider the metallic surface of Example 12.7. Addi- tional measurements of the spectral,…

Q: 2) A small metal object, initially at T; =1000 K, is cooled by radiation in a low- temperature…

A: As we know that the rate of heat transfer will be higher in the body have greater emissivity.…

Q: A flame from a match may be approximated as a blackbody at the effective surface temperature of 1700…

A: Given Effective surface temperature of flame Tflame = 1700K Effective surface temperature of…

Q: what is the difference between the emissive power and irradiance

A: **As per company policy we are supposed to do only 1 question if you need the rest question repost…

Q: Calculate the net heat flux per unit area and by radiation between two infinitely large parallel…

A: Introduction: Radiation heat transmission occurs in the form of electromagnetic waves, primarily in…

Q: (a) Two surfaces, A and B has a temperature of 4500 K and different spectral emissivity as shown in…

A: Given: The temperature, T = 4500 K The Stefan Stefan Boltzmann’s constant, σ = 5.67x10^-8 W/m^2.K

Q: A spherical particle of diameter D = 10 mm is suspended by a thin wire within a cylindrical tube of…

Q: A gray body with a constant surface temperature of 7000C and a surface area of 500cm2 radiates in a…

Q: determine the view factor, and the net heat transfer by radiation between two gray surfaces, A (εA=…

A: Answer: (d) Qnet = 5817.6 Watt ..... (for concentric cylindrical tube). (e) Qnet = 32616 Watt…

Q: An opaque surface at 1000 K if its spectral emissivity is = 0.4, 0.7, and 0.3 for 0 < < 2 μm, 2μm =…

Q: Consider a 20-cm-diameter spherical ball at 800 K suspended in air as shown in Fig. 12-12. Assuming…

Q: 21–120 The spectral absorptivity of an opaque surface is as shown on the graph. Determine the…

A: As per our guidelines we have to answer only one question. So, post the question that you want to…

Q: Calculate the view factor FBA for the following shape. The radii for the hollow circle, circle A and…

A: The shape factor of hollow circle A w.r.t circle B can be calculated by Subtracting the shape factor…

Q: The spectral emissivity and spectral reflectivity of a diffuse surface are given below: 1.0 0.2 0.2…

A: The diffuse surface in the radiation is defined as the surface for which the emissivity is not a…

Question

Surfaces A and B are concentric cylindrical tubes with diameters of 275 and 300 mm, respectively. Determine the overall interchange factor of surface A to B if the emissivities of the surfaces are 0.37 and 0.81, respectively. Both surfaces are gray.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

11.31 A large slab of steel 0.1 m thick contains a 0.1 -m-di- ameter circular hole whose axis is normal to the surface. Considering the sides of the hole to be black, specify the rate of radiative heat loss from the hole. The plate is at 811 K, and the surroundings are at 300 K.
Determine the total average hemispherical emissivity and the emissive power of a surface that has a spectral hemispherical emissivity of 0.8 at wavelengths less than 1.5m, 0.6 at wavelengths from 1.5to2.5m, and 0.4 at wavelengths longer than 2.5m. The surface temperature is 1111 K.
Two large parallel plates with surface conditions approximating those of a blackbody are maintained at 816C and 260C, respectively. Determine the rate of heat transfer by radiation between the plates in W/m2 and the radiative heat transfer coefficient in W/m2K.
11.68 Two infinitely large, black, plane surfaces are 0.3 m apart, and the space between them is filled by an isothermal gas mixture at 811 K and atmospheric pressure. The gas mixture consists of by volume. If one of the surfaces is maintained at 278 K and the other at 1390 K, calculate (a) the effective emissivity of the gas at its temperature, (b) the effective absorptivity of the gas to radiation from the 1390 K surface, (c) the effective absorptivity of the gas to radiation from the 278 K surface, and (d) the net rate of heat transfer to the gas per square meter of surface area.
1.28 The sun has a radius of and approximates a blackbody with a surface temperature of about 5800 K. Calculate the total rate of radiation from the sun and the emitted radiation flux per square meter of surface area.
Determine the rate of radiant heat emission in watts per square meter from a blackbody at (a) 15C, (b) 600C, and (c) 5700C.
1.26 Repeat Problem 1.25 but assume that the surface of the storage vessel has an absorbance (equal to the emittance) of 0.1. Then determine the rate of evaporation of the liquid oxygen in kilograms per second and pounds per hour, assuming that convection can be neglected. The heat of vaporization of oxygen at –183°C is .
Determine the overall interchange factor from surface A to B where surface A is a spherical shell 0.3 m in diameter, and surface B is a similar shell concentric with A and 3 m in diameter. The emissivities of the surfaces are 0.36 and 0.84, respectively. Both surfaces are gray.
The spectral emissivity function of an opaque surface at 800 K is approximated as: Determine the average emissivity of the surface and its emissive power.
A directionally emitting surface has an emissivity of 0.7 for angles up to 45° from vertical and 0.2 for the rest of the range. Determine the total emissivity of the surface.
Liquid nitrogen is stored in a spherical tank of 1-m diameter, where tank surface is maintained uniformly at 80 K. The spherical tank is enclosed by a 1.6-m diameter concentric sphere with uniform surface temperature of 273 K. Both spherical surfaces have an emissivity of 0.01, and the gap between the inner sphere and outer sphere is vacuumed. Determine the rate of vaporization for the liquid nitrogen.
Two coaxial parallel disks of equal diameter 1 m are originally placed at a distance of 1.5 m apart. If both disks behave as black surfaces, determine the new distance between the disks such that there is a 75% reduction in radiation heat transfer rate from the original distance of 1.5 m. (Round the answer to two decimal places.) D. L The new distance between the disks = 1.31