Type of JFET which has greater conductivity O a. P-channel O b. N-channel O c. PNP O d. NPN

Q: Q1/A sinewave is shown in Fig. below. Determine its amplitude, periodic time and frequency I (mA) +5...

A: In step -2

Q: In N-channel JFET the Id is controlled by_______. a.Idss b.Vgs c.Vds d.Ig

A:

Q: Give the reason why a dielectric material increases capacitance compared with what it would be with ...

A: The solution is given below 

Q: The uniform electric field in a sphere of radius 3 m is given as E=-3a, + 5a, + 4a, V/m. Find the to...

A:

Q: Find the transfer function o

A: Open Loop System-  A system which is controllable in which input of the system does not depends on t...

Q: The voltage of a 100-KW, 250-volt shunt generator rises to 260 volts when the load is removed. What ...

A:

Q: Draw and explain the operation of half-wave and full-wave ( 4 diodes Bridge type ). How do they ope...

A:

Q: Express the switching circuit shown in the figure in binary logic notation (boolean expression) and ...

A:

Q: Problem [10] Obtain the Thevenin and Norton equivalent circuits with respect to terminals a and b. 1...

A:

Q: The mathematical relationship between the voltage and current in a J-FET is a _- a. sinusoidal O b. ...

A:

Q: Thevenin and Norton Equivalent: 15). For the circuit in Fig. 4.109, find Thevenin equivalent between...

A: We need to find out thevenin equivalent circuit and norton equivalent circuit

Q: The block diagram of a feedback control systems are shown in figures. Derive the transfer functions ...

A:

Q: A Fimd X[n] from frequency sigal by usingIf Engineering & numerical analysis

A:

Q: What exactly is the issue with NRZ? And, more importantly, how can it be fixed?

A: Microprocessor and microcontrollers are used for data processing. Logic and control are used for pro...

Q: In Fixed-bias configuration, the DC voltage across the Gate terminal is equal to ____. a.Vp b.Vgs c....

A: In Fixed-bias configuration, the DC voltage across the Gate terminal is equal to...

Q: 1) Consider the inductor core shown above. Draw a magnetic equivalent circuit for the device when 11...

A:

Q: A fixed bias n-channel JFET with Vdd= 12V, Rd= 1.2k ohms. Idss=12mA and Vp=-4V. Determine Vs. a.0 V...

A:

Q: 2. The input to a full-wave bridge type rectifier with silicon diodes is V, = 10 Vms- Determine: a.)...

A:

Q: (i) It is required to set the operating point by biasing with collector feedback resistor at Ic = Im...

A: It is given that: IC=1mAVCE=8Vβ=100VCC=12 VVBE=0.3V

Q: Consider two electrical components, A and B, with respective lifetimes X and Y in days. Assume that ...

A:

Q: 9. Using the below general expression for geometric mean radius, prove that the inductive geometric ...

A:

Q: Problem8:  A voltage divider has values of R1=10kΩ and R2=470kΩ. a.What is the attenuation? b.What...

A:

Q: For the circuit shown, if R1 > R2, then which of the following is true? R, R2 AV You cannot tell fro...

A: Given circuit:

Q: What is the maximum range of your radar if you require a S/N of 13 dB given the following: 7: System...

A: We need to find range for radar .

Q: The switch in the circuit has been in position x for a long time. Att= 0, the switch moves instantan...

A:

Q: The electric flux density in vacuum is D= sinx ax - 4zaz millicoulombs per square meter. Determine t...

A: Total charge: The total charge inside the volume is equal to the multiplication of the double integr...

Q: If power = .90

A: Statistical Power- The probability that test we are performing will reject hypothesis which is null ...

Q: For an N-channel JFET Idss = 8mA and Vp = -6V, if Vgs = -2V then what is the value of the Drain curr...

A:

Q: 3. Calculate the current through the Zener diode for the given values of load resistance in this cir...

A:

Q: The radiation intensity of an antenna is given by: = BIG sin(n sin 0) Find: Radiation power and Radi...

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for yo...

Q: FET has; a.all of the above b.a unipolar structure c.a P-channel type d.an N-channel type

A: We need to select correct option for fet .

Q: What is the phase sequence of a three phase motor for which Van=220∠-100V and Vbn = 220∠140V? Select...

A: Phase sequence is the sequence on which voltages are appeared. If phase sequence is ABC then we say ...

Q: For an N-channel JFET Idss = 8mA and Vp = -6V. If Id = 6mA then what is the value of Vgs? a.-0.8V b...

A:

Q: If A = 4a, + 3as – 5az, the component of A parallel to the surface o = 2n is; Select one: O -4ap О 4...

A: Brief description : In electrostatics mainly we have three type of co-ordinate systems such as Carte...

Q: Make a list of three analog-to-digital technologies. What was the rationale behind each transformati...

A: The digital circuits can be sequential or combinational circuits. The combinational circuits depend ...

Q: A uniform electric field intensity of E, =-2a, +4a, -6a, kV/m exists at z0. Determine: (a) The norma...

A:

Q: Find the transfer function relating the 0,(s) to T(s) for the rotational mechanical network shown. E...

A:

Q: Question 1: For the shown circuit; a) Find Norton equivalent circuit at terminals a-b. b) Use Norton...

A: In this question,  Depended and independed energy sources are consist.  Find the Thevenin equivalent...

Q: A fixed bias n-channel JFET with Vdd= 12V, Rd= 1.2k ohms. Idss=12MA and Vp=-4V. Determine Vs. O a. 4...

A:

Q: Determine the percent modulation for an unmodulated carrier of 80 Vp-p if the maximum and minimum vo...

A:

Q: Compute the total gain of the system. /A1 = 15 dB A2 = - 20 dB A3 = 35 dB %D

A:

Q: Q1/A sinewave is shown in Fig. below. Determine its amplitude, periodic time and frequency

A:

Q: Make a list of three analog-to-digital technologies. What was the rationale behind each transformati...

A: The digital circuits can be sequential or combinational circuits. The combinational circuits depend ...

Q: VDD = 16V, RG = 1M-ohm, RD = 1500 ohm, RS = 750 ohm, IDSS = 10mA, VP=-4V a. Determine the drain cur...

A: In this question,  The given parameters VDD = 16V, RG = 1M-ohm, RD = 1500 ohm, RS = 750 ohm, IDSS = ...

Q: 1- 0.9z¬1 – 0.1z2 1+ 0.3z-1 – 0.04z2 H(z)

A: Transfer function: It is the ratio of the output of the system and the input of the system.

Q: For a DSB-SC AM, if the message has a spectrum as shown below, MCH) a) Sketch the block diagram of t...

A:

Q: (c) Determine the peak output voltage and the average value of the output voltage for the given half...

A:

Q: The following is the response of a second-order control system to a unit-step input. Identify t, tp,...

A:

Q: Solve the following problems with complete solutions and units using two(2) decimal digits. 3. A 10...

A: The solution is given below 

Q: Е. Using a constant 4.5 V source, three bulbs, wires, and a double throw switch design a circuit tha...

A:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.