The water pressure at the base of the water tower shown in the figure is 3.2 bar. The water level is L = 25 m above the tower base. Thedensity of the water is 103 kg/m³ and g = 9.81 m/s².g=9.81 m/s²Pwater = 10³ kg/m³WaterPAirLDetermine the pressure of the air trapped above the water level, in bar and in lbf/in².

Name: The water pressure at the base of the water tower shown in the figure
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: The water pressure at the base of the water tower shown in the figure is 3.2 bar. The water level is L = 25 m above the tower base. Thedensity of the water is 103 kg/m³ and g = 9.81 m/s².g=9.81 m/s²Pwater = 10³ kg/m³WaterPAirLDetermine the pressure

GivenP=3.2bar=320kPaL=25mρwater=103 kg/m3g=9.81m/s2

Answered: The water pressure at the base of the…

Engineering

Mechanical Engineering

The water pressure at the base of the water tower shown in the figure is 3.2 bar. The water level is L= density of the water is 103³ kg/m³ and g -9.81 m/s². Air

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

As shown in the figure below, the tank contains water and immiscible oil at 20C. What is h in cm if the density of the oil is 898 kg/m3? h 6 ст 12 cm Oil Water 8 cm
A closed tank (of height 5 m) is partially filled with a liquid as shown. If the pressure of the air above the fluid is 2 bar, find the pressure at the bottom of the tank. Assume the density of the liquid to vary according to the following relation: p = 900 + 2 kg/m³ where y is the height from the base P= 2 bar 5 m 2 m Liquid Select one: O 2 12 O 2.15 O 2.18 O 2.5 A beaker half-filled with water is exposed to the atmosphere. If the pressure at points A, B and C as shown are Pa, Pb and Pc respectively, which one of the following will be the relation connecting the three? A. Pat A>Pat B=P at C B. Pat A>Pat B>P at C C.Pat A
The water pressure at the base of the water tower shown in the figure is 3.2 bar. The water level is L = 25 m above the tower base. The density of the water is 103 kg/m3 and g = 9.81 m/s?. Air g = 9.81 m/s? Pwater = 103 kg/m³ Water Determine the pressure of the air trapped above the water level, in bar and in Ibf/in?.
At the beach, atmospheric pressure is 1025 mbar. You dive 20 m down in the ocean and you later climb a hill up to 350 m in elevation. Assume the density of water is about 1000 kg/m³ and the density of air is 1.18 kg/m³. What pressure (in kPa) do you feel in each place?
As shown in the figure below, a piston-cylinder assembly contains 1 kg of water at T1=200° C and P1 = 1.5 bar holding the piston against the stops. The atmospheric pressure is 1 bar, and you can assume the piston's weight is negligible. The water is slowly cooled until the piston just begins to move downward in the cylinder. What is the pressure (P2), temperature (T2), and volume (V2) of water at this point? (°C), V2 = P2 = (m³) The cooling continues until water has entirely turned into saturated liquid. What is the pressure(P3) and temperature (T3), and volume (V3) of water at this point? (°C), V3 = P3 = (bar), T2 = (bar), T3 = Qtotal Calculate the total work done on the moving boundary of this system during the two processes. W total (kJ) Calculate the total heat transfer during the two processes. (kJ) On paper draw the P-v diagram for water going through the above processes. Show your detailed work on paper. hint: you must also find v1, u1, and u3. Patm = 1 bar Piston (m³) Stops
Balloons are often filled with helium gas because it weighs only about one-seventh of what air weighs under identical conditions. The buoyancy force, which can be expressed as Fb = ? airgVballoon, will push the balloon upward. If the balloon has a diameter of 12 m and carries two people, 70 kg each, Determine the maximum amount of load, in kg . Assume the density of air is ? =1.16kg/m3, and neglect the weight of the ropes and the cage
A small solid ball is released from rest while fully submerged in a liquid and then its kinetic energy is measured when it has moved 4.10 cm in the liquid (if it moves). The figure gives the results after many liquids are used: The kinetic energy K is plotted versus the liquid density plig, and Kg = 1.70 J sets the scale on the vertical axis. What is the volume of the ball in m3? K, 1 3. Pliq (g/cm³) K (J)
A town has a 0.5-million-gallon storage capacity water tower. If the density of water is 62.4 lb/ft3 and local acceleration of gravity is 32.1 ft/s2, what is the force, in Ibf, the structural base must provide to support the water in the tower? F = i 133875150.4 Ibf
Thermodynamics (Ideal Gas) In a certain non-flow process, the internal energy decreases 20 Btu/lb and 77800 ft-lb/lb of work done on the substance. Find the heat added or abstracted in Btu/lb
In the figure below, the tank contains water and immiscible oil. What is h in cm if the density of the oil is 900 kg/m3 ?
m and 5 Kg Kg 2. Three liquids of different qualities, p1 = 1500 , V2 = .002 m3' Liters of water, are poured together into a 30 gallons tank, filling it. If Kg the resulting density of the mixture is 1,200 m3' find the respective quantities of liquids. Also, find the weight of the mixture.
Q1/ In the Figure below all fluids are at 20 C. Determine the pressure difference (Pa) between points A and B. Kerosene Air Benzene B 40 cm 9 cm 20 cm 14 cm cm Water Mercury