Answered: The volume flow rate of a given fluid…

The volume flow rate of a given fluid is 0.002 m/sec. What is the mass flow rate of that fluid having a density of 13600 kg/m' OA 186 kg/sec OB 00014 kg/sec OC 207 kg/sec D 27.2 kg/sec

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A liquid discharged from a container through a circular orifice having a diameter of 10 mm that is located 5 m. from the liquid surface to the center of the orifice. Evaluate the theoretical discharge through the orifice in liters per second if the container is moving upward at an acceleration half that of gravity.A.0.80liters/secC.0.90liters/secB.0.85liters/secD.0.95 liters/sec
Problem 1. (10 points) What is the mass in grams and the weight in dynes and in gram-force of 12 oz of salt? Local g is 31.66 ft/s. Problem 2. (20 points) A spherical tank with a radius of 3 ft is filled with fluid whose density is 650 kgm/m. Determine: a. Total volume of the fluid in ft b. Its mass in slugs and Ibm (Ibm is pound-mass) c. Its specific volume in ft/lbm d. Its specific weight in N/m where g=31.9 ft/s? Problem 3. (10 points) Determine the mass in kgm, and weight in Newton of the air contained in a room whose dimensions are 6m x 6m x 8m. Assume the density of the air is 0.72 lbm/ft and local gravity at 32.1 ft/s?. Problem 4. (10 points) The pressure at the bottom of a certain mountain is 965 mm-Hg and at the same time at the top of the mountain is 845 mm-Hg. Assuming the unit weight of air is equal to 12 N/m2, determine the height of the said mountain. Problem 5. (20 points) In the figure, if the atmospheric pressure is 101. 03 KPa and the pressure at the bottom of the…
PROBLEM 3: An in-line flow nozzle is to be used to measure the flow of ethyl alcohol (v = 1.52 x 10-6 m²/s; p = 789 kg/m³) through a 50 mm diameter pipe inline. The nozzle diameter is 28 mm, and the pressure drop across the nozzle is 4,000 Pa. a. Determine the volumetric flow rate. b. Determine the average velocity of the fluid. c. Determine the mass flow rate.
A liquid (sp.gr= 1.2) flows through a 150mm diameter pipe at a velocity of 4.5m/sec. Find (a) the volume flow rate in cubic meter per seconds and liter per seconds; b) the mass flow rate in kg/sec and; c) the weight flow rate in N/sec
1 pts A certain fluid has a specific gravity of 1.25 flows through a 150mm pipe with mean velocity of 1.50 m/s. Determine the weight flow rate in N/s O 325 O 532 O 523 O 235 30°C 93% LC
A certain liquid (SG = 11) flows through a 315-mm diameter pipe at a velocity of 5.3 m/s. Find the mass flow rate in kg/s. Round off to the nearest whole number.
An oil of density 892 kg/m³ is flowing in a pipe having an internal diameter 5cm. This pipe is connected to another one with diameter 7.5cm which branches into two smaller pipes each one having a diameter of 3.75cm. If the flow rate in the first pipe is 1.388 x 10³m³/s, calculate: a- The mass flow rate in the first pipe and in the branches of the second pipe. b- The average velocity in the first pipe and in the branches of the second pipe. 3.75 cm تفرع فرعب واد من مرا
Problem: A 1-m diameter and 1.6-m height cylindrical drum is filled with a fluid whose density is 850 kgm/m3. Determine the following: 1. Volume of the fluid in ft3. 2. Mass of the fluid in Ibm- 3. Specific volume in ft3/lbm- 4. Specific weight in Ibf/ft3.
AAAAAAAAAAAAAAAAAAAA 2 Pa oil with density 706kgf/" and viscosity 4-7×10 7³9 flows out of storage tank below: Determine the minimum diameter that results in a flow rate of 18 litres per minute. Provide answer in cm H = 1.4m L = 7m
1. The reading of an automobile fuel gage is proportional to the gage pressure at the bottom of the tank. The tank is A deep and is contaminated with B of water. The specific volume of gasoline is 0.00147076 m /kg and that of air is 0.0008313 m³/kg. Unit weight of water is 9790 N/m3 a. Determine the gage reading when the tank is full of gasoline b. How many cm of air remains at the top when the gage indicates full if the tank is A deep and is contaminated with B of water. c. Determine the pressure at the interface of the gasoline and water when the gage indicates full A = First name in inches Vent B = A/10 in inches Air h A Gasoline Pgage Water B
Q3: A pitot-static tube is used to measure the flow velocity of turpentine flowing in a pipeline if the manometer reading is 8 cm of mercury, calculate the average velocity, pressure drop, and volumetric flow rate at that point in the pipe line. Also evaluate Reynold number for turpentine and which type of flow in the pipe. Ph J Re Density of turpentine is 850 kg/m³, density of mercury is 13600 kg/m³, cv = 1, D=10 cm, turpentine 0.001375 and 0 = 45°. =
A fluid flows at 0.002 m³/s through a 150- mm - diameter pipe. Determine whether the flow is laminar or turbulent if the fluid is: a. Air (v = 1.48 x 10³ m²/s) b. Ans. laminar Water (p = 8.90 × 10^ Pa-s) Ans. turbulent Mercury (u = 1.53 x 10³ Pa-s) Ans. turbulent Glycerin (v = 1.18 x 10³ m²/s) d. e. Gasoline (v = 4.06 x 107 m²/s) Ans. laminar Ans. laminar