The system receives 500 kJ from the cold reservoir and discharges 400 kJ to the hot reservoir while delivering net work to its surroundings in the amount of 100 kJ. There are no other energy transfers between the system and its surroundings. Evaluate the performance of the system using either statement of the second law.

The system receives 500 kJ from the cold reservoir and discharges 400 kJ to the hot reservoir while delivering net work to its surroundings in the amount of 100 kJ. There are no other energy transfers between the system and its surroundings. Evaluate the performance of the system using either statement of the second law.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A pressure cooker containing some water with an internal energy of 300 kJ is heated by a gas burner. 0.5 kg of steam with an enthalpy of 1800 kJ/kg escapes through the safety valve. The average velocity of steam is 5 m/s. The heat loss through the wall of the cooker is 250 kJ. If the internal energy of the water and steam in the cooker is 500 kJ. Find the heat supplied to the cooker. Provide complete solution, with diagram
5. Water is being heated in a closed pan on top of a range while being stirred by a paddle wheel as shown in the figure below. During the process, 30 kJ of heat is transferred to the water, and 5 kJ of heat is lost to the surrounding air. The paddle-wheel work amounts to 500 N · m. Determine the final energy of the system if its initial energy is 10 kJ. 5 kJ 30 kJ 500 N-m
A gasoline engine is 30% efficient, which means it can transfer 30% of the energy heat provides the engine with useful success. If the engine consumes 0.8 L/h of gasoline with consumption index 3.5·104 kJ/L, find the amount of work done in kW and horsepower (hp)
A pump delivers 50 liters/sec of water. The intake to the pump is 75m below the final discharge. The inlet and discharge pressure is essentially atmospheric and the temperature of the water remains constant at 20 ⁰C during the process. Determine the power required by the Pump.
Q4/ An air compressor requires shaft work of 200 kJ/kg of air and the compression of air causes increase in enthalpy of air by 100 kJ/kg of air. Cooling water required for cooling the compressor picks up heat of 90 kJ/kg of air. Determine the heat transferred from compressor to atmosphere.
A reciprocating compressor draws in 500 cubic feet per minute of air whose density is 0.079 lb/cu ft and discharges it with a density of 0.304 lb/cu ft. At the suction, P1=15 psia; at discharge. P2 = 80 psia. The increase in the specific internal energy is 33.8 Btu/lb and the heat transferred from the air by cooling is 13 Btu/lb. Determine the work on the air in BTU/min and in Hp. Neglect the change in Kinetic Energy
A pump forces 1 m3/min of water horizontally from an open well to a closed tank where the pressure is 0.9 MPa. If the work done upon the water had been used solely to raise the same amount of water vertically against gravity without change of pressure, how many meters would the water have been elevated? What velocity would the water have reached in m/s? If the work had been used to accelerate the water from an initial velocity of 10 m/s, what would the final velocity have been in m/s? Please give the given value and formula we are use....
EX 3-2: A fan that consumes 20 W of electric power when operating is claimed to discharge air from a ventilated room at a rate of 0.25 kg/s at a discharge velocity of 8 m/s. Determine if this claim is reasonable.
A power station with an efficiency e generates W watts of electric power and dissipates D J of heat energy each second to the cooling water that flows through it. The cooling water increases its temperature by T degrees of Celsius. Find the mass of cooling water which flows through the plant each second. Specific heat capacity of water cw = 4,184 J/kgC e = 0.2W = 4.9 x 108 wattsD = 2.5 x 108 JT = 4 C Enter value in tons (1 ton = 1000 kg).Enter two digits after decimal point.
A pressure cooker containing some water with an internal energy of 300 KJ isheated by a gas burner. 0.5 kg of steam with an enthalpy 1800 KJ/kg escapesthrough the safety valve. The average velocity of the steam is 5 m/s. The heat loss through the wall of the cooker is 250 KJ. If the final internal energy of the water and steam in the cooker is 500 KJ, find the heat supplied to the cooker.
A water pump increases the water pressure from 15 psia to 80 psia. a. Determine the flow work, in Btu/lbm, required by the pump. Assume thatthe state of the water at pump inlet is saturated liquid and that the specificvolume remains constant during this process. b. Water enters this pump through a 1.5-in-diameter opening and exitsthrough a 2-in-diameter opening. Determine the velocity of the water at theinlet and outlet when the mass flow rate through the pump is 1.1 lbm/s
Define the energy equation of a uniformflow system reduces to that of a closed system when all the inlets and exits are closed.