The synchronous speed and the percentage slip of an AC motor are 900 rpm and 3 percent respectively. Determine the actual speed of the motor.

Q: 3. For an air dielectric parallel-plate waveguide of the dimension a = 10 cm find: A) all…

A:

Q: 1. For the following circuits, Find i. ii. iii. iv. Transfer Function Identify whether it is low…

A:

Q: For the circuit shown in the drawing, find (a) the current / through the 2.00-2 resistor and (b) the…

A:

Q: Question 14 lg to another question will save this response. Identify the type of passive filter…

A:

Q: In regard to using analog signals with PLC's, what is a transmitter? converts physical variables to…

A: answer is A     A transmitter is a device that converts physical variables such as temperature,…

Q: A motor car manufacturing company has manufactured a motor car protecting circuit to warn if there…

A: The truth table can be derived from the given condition and the required boolean expression to…

Q: A band-stop (notch) filter can be designed by using O an inverting amplifier O band pass summer…

A:

Q: Find In between A and B using mesh analysis

A:

Q: Find the transfer function X(s)/F(s). F(s) + 1 S s²+ 18s +80 1 s² + 12 1 s²-18s +80 1 s²+12s-8 1 s²…

A: In this question we need to find the transfer function of the given block diagram.

Q: 1. Describe in generic terms the type of unit you think this is based on your interpretation of the…

A: Mini Split heat pump : Mini-break up heat pumps are a not unusual form of smaller HVAC unit. They…

Q: A MOD 2 and a MOD 5 up counter when cascaded together results in a MOD counter.

A: it is asked to find the result when MOD-2 and MOD-5 counters are cascaded

Q: Q1 (b) (c) Write down Maxwell's equations in differential form. Show how these equations can be…

A:

Q: A radio transmitter supplies a current of 8.0 A to an antenna system with an impedance of 500 Q with…

A: The formula for the apparent power in an AC circuit is given by: S = VI* where S is the apparent…

Q: A capacitor of C = 30 µF is connected in series to a resistor R = 252 and an AC source operating at…

A: In this question We need to determine the all unknown parameters.  We know Inductive Reactance XL =…

Q: 7-A transistor circuit similar to Fig.1 has a collector supply voltage of 20 V, a collector…

A: We need to find out collector to emitter voltage, Vce for the given circuit.

Q: α. be M 1Ω 1Ω W 4Ω W 4Ω 8Ω 6.5 W W 4Ω 8Ω, 4Ω Μ 6Ω

A:

Q: For the circuit given below, where V = 14 V, what resistor connected across terminals a-b will…

A:

Q: a. In applying nodal analysis or mesh analysis to the circuit above, which method will result in…

A:

Q: Q4 b. An air-gap of 0.008m was cut on the rectangular cast iron core shown in Figure Q4a(ii) as…

A: As Relative permeability of iron core is not given so I solved the question by considering relative…

Q: Plot the sinusoid for t=0 to T, where A = 150 mA, f= 35 Hz and 0 = -30°: i(t) = A sin (wt + 0)

A: Given , a sinusoid which is lag with Asin(wt) by -30 degree. The graph of both Asin(wt) and…

Q: (5) Use algebraic manipulation to find the minimum POS expression for the function f(x1, x2, x3)=…

A: Given: A logical function expression as,  fx1, x2, x3=∏M0, 1, 5, 7, To find: a) The minimum SOP of…

Q: For the following switched capacitor integrator circuit, calculate the sampling frequency vout -…

A: The given circuit is a switched capacitor integrator circuit, Given C1=C=100 pF voutvin=-1000s It is…

Q: 1. For the following circuits, Find i. ii. iii. Transfer Function Identify whether it is low pass,…

A:

Q: Consider the system given by X AX + Bu, y = CX + Du = A = [ ²¹₂ ¹₁] B =[₁] C = [10] D = [0] Is the…

A:

Q: What is the equation to calculate space between transmission line?

A: The equation to calculate the space between transmission lines depends on various factors such as…

Q: Find an expression fro the gain if Rin = infinity, Rout = 0, and Ao does not equal infinity.

A: The gain is the ratio of output voltage to the input voltage. The resistor can be replaced with its…

Q: Draw the output voltage waveform of the circuit shown. Do not forget to label the values.

A:

Q: What is con 2 in Orcad cadence?

A: "Con 2" in OrCAD Cadence refers to a type of connectivity constraint that can be applied to a net in…

Q: R1 20 R2 302 20A R3 20 Holi V1 48V R4 ww 602 R5 40 www

A: Using superposition theorem calculation of current flowing through 6 ohm resistor. According to…

Q: 3. For system shown below, write the state equations and the output equation for the phase- variable…

A: it is asked to write state and output equations for given transfer function

Q: The installation of plenum certified cabling above the ceiling tile is necessary because.

A: The installation of plenum certified cabling above the ceiling tile is necessary for fire safety…

Q: 10V (A)-10V (B) 40V (C)-40V (D)-30V SV 15V 100k www 100k ww 100k www 200kn www Vout

A:

Q: If the _ is bellow required the solder will joitn appear cold and silvery and will be_

A: Given: If the___ is below required, the solder joint will appear cold and silvery and will be ___.…

Q: QUESTION 4 Which is these is the BEST description of what the SCALING command does in a PLC? Allows…

A: The BEST description of what the SCALING command does in a PLC is: A) Allows the programmer to set…

Q: Consider the following circuit. If the required frequency for oscillation is 10 kHz, then the value…

A: The given circuit is a triangular wave oscillator and the frequency of oscillation is based on the…

Q: 1. Find the Fourier transform of each of the following signals. a. w(t) = tri (¹). b. x(t) = {3cos…

A:

Q: 3. Let x be a finite sequence with DFT X=DFT(x) = [0, 1+j, 1, 1-1 Using the properties of the DFT to…

A:

Q: Ex:1 Find the resistance that gives off 144 W of heat when the current through it is 2.0 A rms.

A:

Q: Problem 2: Determine the response of first-order system h[n] = (-5/6)"u(n) to each input: 1. r[n] =…

A: Given: The impulse response of a first-order discrete system is given as hn=-56nun. We shall use…

Q: Category: Electrical Engineering Question: Determine the pull down network of the given circuit.…

A: CMOS logic circuit have two part . Upper part of the CMOS logic circuit is known as pull up network.…

Q: The minimum SOP: (using Karnaugh's Map)

A:

Q: can you give out of SOP Y2 in equaltion and NAND and NOR from the schematic diagrame

A:

Q: What size ungrounded conductors do we need for the 60 amp load? All conductors have typeTHHN…

A: It is given that: I=60 A

Q: 2002 3 ww (1) (5 0000 [ (syr

A:

Q: Find the transfer function G(s)=X₂(s)/F(s) in the network below: 1 N-s/m 1 N/m oooo 1 kg 1…

A:

Q: 14.3.22 Find i(t), t > 0, in the network shown in Fig. Pl4.3.22. t = 0 1Ω ig(1) +)12v www 2Ω 4 Ω 1F…

A: In this given circuit , we need to find i0(t). It's a 2nd order RLC circuit . Circuit :

Q: the 2 pictures are identical is this correct?

A: NO, this is not correct. Because, The closed loop control system uses a feedback system.

Q: + 3ml ↑ 13 VS 1 1 Find Vs "square-law" device 2 (1.1) is = {A (US-V₂)² Vs = Vt O Vs K VE where V₂ =…

A: In this question We need to determine the voltage Vs in this circuit.  We are solving this problem…

Q: What kind 6 things antennas and antenna accessories you need for daycare business building?

A: Its asked to mention the 6 antenna accessories that are needed for daycare business building.

Q: Using the properties of the z-transform, find the z-transform for each of the following a. x(n)=…

A:

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.