Answered: The range of an experimental result is…

The range of an experimental result is 12 – 18. If these numbers represent the minimum and maximum reading as well, what is the mean experimental result and the uncertainty?

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter1: Units And Measurement

Section: Chapter Questions

Problem 86AP: The length and width of a rectangular room are measured to be 3.9550.005m and 10500.005m . Calculate...

See similar textbooks

Related questions

Q: For the data 69.65, 69.63, 69.64, 69.21, calculate the 95% confidence limit. A 69.6 ± 0.5 B 69.7 +…

A: In this question we have to find the 95% confidence limit. Please give positive feedback if the…

Q: Calculate the minimum uncertainty in the position of the 25-g bullet from Sample if the uncertainty…

A: Heisenberg's uncertainity principle is a mathematical inequation that provides the limit to the…

Q: 1. A student measures values 9.83 m/s?, 9.79 m/s?, 9.85 m/s?, 9.65 m/s?, 9.86 m/s2 and 9.77 m/s2 for…

Q: If the weight used in the experiment is having an uncertainty of 1.5+ 0.02 N, the initial height is…

A: Given data: Uncertainty in weight, W=1.5±0.02 N Uncertainty in initial height, H1=50±0.05 cm…

Q: Find the uncertainty in a calculated electrical potential difference from the measurements of…

A: Given The mean current is I = 4.8 Amps. The resistance is R = 93.9 Ω. The uncertanity of current is…

Q: Water at 20°C flows past a half-body as shown in Fig. Measured pressures at points A and B are 160…

Q: When the accepted value of g= 9.8 m/s2, what is the % error in the experimental value of g?

Q: 2.1 Calculate the % Error (accepted value 9.80 m/s?) for the following measurements: 9.87 m/s? 9.93…

A: % Error is given as% error=Experimental value-Realor acceptedvalueAccepted valuex100

Q: Question 2: Complete the error calculations If the weight used in the experiment is having an…

Q: An angle is measured to be 109.0±0.6deg. What is the absolute uncertainty in the sine of the angle?

A: Given data: Angle θ=109.0±0.6°

Q: If the weight used in the experiment is having an uncertainty of 1.1± 0.02 N, the initial height is…

Q: Calculate the minimum uncertainty in the speed of a ball of mass 500 g that is known to be within…

A: According to uncertainty law, mΔvΔx=h4π m=500 g=0.5 kg Use the given values, 0.5Δv1.0×10-6…

Q: If we subtract two measured values, A and B, with uncertainties Ha and Ho, respectively, how would…

A: Uncertainties in Experimental physics is an unavoidable reality. Uncertainties can arise from…

Q: The first question finds the expected value, variance, and standard deviation for the values below…

A: The given data: 1, 11, 29, 18, 4, 5 2. Number of data: 7

Q: Determine the values of /, and I, that satisfy the following two equations. 9.25 + 3.30/, - 2.35/2 =…

Q: For the following data (21, 24, 23, 21, 27, 20, 10, 26, 22), the standard deviation is

A: Solution: Calculate the mean of the given numbers. Mean, μ=21+24+23+21+27+20+10+26+229=1949=21.56…

Q: An electron is confined to a 1 nm wide region. What is the range in velocities (uncertainty) in the…

Q: A proton is known to be within an interval ±6 fm (the radius of a large nucleus). Roughly what is…

A: Given data: Position uncertainty ∆x=±6 fm

Q: If an electron has an uncertainty in its velocity of 4.10 m/s, what is the uncertainty (in meters)…

Q: An electron is located on a pinpoint having a diameter of 2.5 µm. What is the minimum uncertainty in…

Q: Find the expected value of the inf luencer ħ|0 1 |10 For the case represented by the function

Q: In an experiment to understand the concepts of potential and kinetic energies, as shown below,…

Q: 7.4. Four measurements are made of the wavelength of light emitted by certain atom. The results, in…

A: The weighted average of measurements is,

Q: Suppose the position of a chlorine ion in a membrane is measured to an accuracy of 0.75 μm. a) What…

Q: An electron is located on a pinpoint having a diameter of 7.71 um. What is the minimum uncertainty…

Q: An electron is located on a pinpoint having a diameter of 2.5 um. What is the minimum uncertainty in…

A: From uncertainty principle, the minimum uncertainty in the speed of the electron is given by

Q: In an experiment to understand the concepts of potential and kinetic energies, as shown below,…

Q: Starting from Ax 10- and decreasing, the error from the finite difference approximation will…

Q: In expressing experimental error or uncertainty, when should (a) experimental error and (b) percent…

A: solutionaExperimental error→Experimental error is used when comparing an Experimental result E with…

Q: A rectangular object has length l=32.4±0.5, width w=21.1±0.2. What is the absolute uncertainties in…

A: Given,Length of the rectangular object, L = 32.4 ± 0.5Width of the rectangular objectw = 21.1 ±0.2…

Q: An experiment subject only to random fluctuation within a normal distribution collects the following…

A: In this question we are given that an experiment subject only to random fluctuation within a normal…

Q: The figure, shows the dot and whisker plot of measured values and uncertainties from Group A and…

A: Required : What can be said about the data sets.

Q: A 57.3g ball moves at 28.9 m/s. If its speed is measured to an accuracy of 0.160%, what is the…

A: Heisenberg's uncertainity principle: ∆x.∆p=h4π (given) (m) Mass of ball = 57.3 g = 0.0573 kg (v)…

Q: If the weight used in the experiment is having an uncertainty of 1.5+ 0.02 N, the initial height is…

Q: Does a wider normal distribution plot indicate more or less uncertainty in the data ? Explain

A: The uncertainty in the observation is the measure of how far the value is located from the…

Q: If the weight used in the experiment is having an uncertainty of 1.9± 0.01 N, the initial height is…

Q: The figure, shows the dot and whisker plot of measured value and uncertainties from Group A and…

Q: Two quantities were measured: L = (37.64 ± 0.04) units and W = (5.30 ± 0.03) units and then used to…

A: Given, L = 37.64±0.04 W = 5.30±0.03 to find error in P = L-W

Q: How can errors, if not eliminated, be minimized? Identify the type and the suggested ways. Which…

A: Since you have asked more than three sub-parts of a question we'll only answer the first three…

Q: Compute the uncertainty of 1/x in terms of x and its uncertainty, δx .

A: Given y = 1/x and we have calculate its uncertainty

Q: The following (Attached image) is an external quantum efficiency of a CZTS solar cell with structure…

A: In this question we have to explain the losses. Please give positive feedback if the answer helps…

Q: Find the uncertainty in a calculated electrical potential difference from the measurements of…

A: The expression for the uncertainty in potential difference is:

Q: If the weight used in the experiment is having an uncertainty of 1.1± 0.01 N, the initial height is…

A: (1) Write the expression of the potential energy. PE=mgh

Q: An angle is measured to be 29.0±0.4deg. What is the absolute uncertainty in the sine of the angle?…

A: Solution: Calculate the absolute uncertainty in the sine of the angle.…

Concept explainers

Blackbody

Q.5 A blackbody radiates how much energy when the temperature of the body is elevated?

Question

The range of an experimental result is 12 – 18. If these numbers represent the minimum and maximum reading as well, what is the mean experimental result and the uncertainty?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

(a) A person’s blood pressure is measured to be 1202mmHg . What is its percent uncertainty? (b) Assuming the same percent uncertainty, what is the uncertainty in a blood pressure measurement of 80 mm He?
What is the volume and its approximate uncertainty of a sphere of radius 1.96 +- 0.0m?
Measured values are usually presented as mean plus or minus uncertainty. If two experimental valuesare (8.1 ± 0.5) and (7.9 ± 0.4), what is the uncertainty of their difference?
Find the uncertainty in a calculated electrical potential difference from the measurements of current and resistance. Electric potential difference depends on current and resistance according to this function V(I,R) = IR. Your measured current and resistance have the following values and uncertainties I = 4.8 Amps, SI = 0.1 Amps and R = 93.9 Ohms and SR = 0.5 Ohms. What is the uncertainty in the , SV?
Find the average, variance and the standard deviation for the following: 1.23, 1.24, 1.18, 1.19, 1.26, 1.21, 1.22, 1.25, 1.20, 1.27, 1.28
A function Fis given by / - 4 where y = (8.854 0.05) and x = (5.11 ÷ 0.03) What is the absolute uncertainty in F% Specifi vour answer up to three decimal places
In expressing experimental error or uncertainty, when should (a) experimental error and (b) percent difference be used?
A series of four measurements of the ratio of the circumference to diameter of a disk are made. The results of these measurements are: 3.140, 3.133, 3.132, 3.133. The average of the four measurements is the experimental value for Pi-Lab and the accepted value is Pi = 3.141. What is the percent error of these measurements? a) 1 % b) 2% c) 0.5% d)0.2%
Determine the absolute uncertainty for the calculated value in the following scenarios. Express as (computed result) ± (absolute uncertainty) (units). You measure the volume of a stainless steel sphere by placing it into a100 mL graduated cylinder with an uncertainty of 1 mL, with 20 mL ofwater initially. After the sphere settles, the graduated cylinder now reads22 mL. What is the volume with uncertainty? Please use the formula I posted ! Thank you!
1.26 An American golf ball has a mass of 1.62 +0.01 oz and a nom- inal diameter of 1.68 in. Determine the precision that the diameter of the ball must be measured so that the uncertainty of the density of the ball is ±1 percent.
The measurement error is defined as AX=X-Xo.where Xo is the true value of a physical quantity. X is the measured value of the physical quantity, AX is also known as "absolute error" What is the correct understanding to absolute error? Select one: O a An absolute error indicates the absolute value of the error. Ob Absolute error is the difference between the measured value and the true value. O e Absolute error indicates that the error is always positive. Od. Absolute eror indicates that the magnitude of an error is certain.
You repeat a measurement that contains random error many times, construct a histogram of your measurements and determine that the FWHM of the histogram is equal to 1.9. What is the uncertainty in one measurement, δn, equal to?