The mass of the uniform bar below is 20 kg. 1. Determine the magnitude of the reaction NB acting on the smooth uniform bar. 2. Determine the magnitude of the reaction Ax acting on the smooth uniform bar.   3. Determine the magnitude of the reaction Ay acting on the smooth uniform bar

Q: Member ABCD has the following weight and dimensions: Weight of ABCD = 150 N h1= 0.8 m h2= 1.8 m h3=…

A:

Q: GIVEN: Parameter s = 0.8 + 0.0003(487) = 0.9461 m REQUIRED: In the assembly shown, sags of s and 1.5…

A: Given: s=0.9461m g=9.81 m/s2 kBD=134 N/m Required “Since you have posted a question with multiple…

Q: Determine the reaction forces at the four contact points A, B, C and D. Small: Mass of 1.02 kg…

A:

Q: A spherical tank with a radius of 3.41m that has a mass of 28928.644kg was supported in the system…

A: β: 21.774° θ: 46.452° R = 3.41m cylinder mass, m = 28928.644 It is asked to calculate the…

Q: The 6 m uniform rod as shown below weighs 1000 N. Segment AB and BC is 4 m long. The cable acts at a…

A: To find: The reaction at point A, D and C. Given: The length of rod is l=6 m. The weight of the rod…

Q: If d=2m and F-200N and the mass of ball 30 kg Determine the forces in cables AC and AB in…

A: tanθ=22θ=45° tanα=2.52α=51.3° ∑FX=0-ABcosα-ACcosθ+F=0AB(0.625)+AC(0.707)=200 ......(1)

Q: A bicycle rider has mass M. The wheels of the bicycle are at distance l apart and horizontal…

A: The bicycle rider has mass M. The distance between the two wheels of the bicycle are L apart .

Q: 9) As shown by this image, the 89-lb crate is supported by three ropes as shown. The coefficients in…

A:

Q: Determine the reaction force at the bolted base O of the overhead traffic-signal assembly shown. B.…

A:

Q: A 90-kg smooth circular cylinder A with a radius of 0.6 m is held in equilibrium by a cord CD and a…

A: Apply the condition of equilibrium ∑Fx=0R2x=R3x ∑Fy=0R2y=W

Q: A block of wood having a volume of 0.034 m3 and weighing 300 N is suspended in seawater as shown. A…

A: Given:

Q: 2.0 m 100 kg 2.0 m 0.5 m 1.5m 1.5 m The pulley at E is frictionless. Point B is a pinned connection;…

A:

Q: 07 The 180-1lb tree surgeon lowers himself wit rope over a horizontal limb of the tree. If the c…

A: Givenμ=0.60θ=180°

Q: A wooden plank with a mass of 50.968 kg is supported by two cables at its ends. At what location…

A:

Q: A roller of radius r= 12 cm and weighs Q= 500 kN is to be pulled over a cub of height h = 6 cm by a…

A:

Q: The bar AC is supported by a joint at A and a pin B that is free to slide in the same direction…

A: Given; Length, L1 = 2.7 m Length, L2 = 1.7 m Angle, α = 13o Angle, θ = 25o The force, P = 68 kN

Q: Three masses, m, =3 kg, m2 = 5.5 kg, and m3 = 2 kg, are attached to springs, k1 = 50 N/m, k2 = 35…

A:

Q: The uniform bar is placed on a 9 - meter wall at an angle of 45 degrees from the smooth surface of…

A:

Q: (a) A shaft of negligible mass is held in bearings as shown in FIG. B3 and carries two gear wheels…

A: As there are multiple questions in a single window so we are providing solution for first question…

Q: Confused about #9. I’ve circled the question and diagram.

A:

Q: The force P on the handle of the positioning lever produces a vertical compression of 56lb in the…

A: the magnitude of the corresponding force exerted by the pin at O.

Q: B. 2. A cable goes over a frictionless pulley at B and supports a block of mass m. The other end of…

A: Given data: - The vertical distance between point A and B is h = 5 m. The horizontal distance…

Q: 2 m 1 m 2 m This is not your bproperty so do oS any www 37 1.5 m your www kAC kBp 1.5 s In the…

A:

Q: 6/20 The force P is applied to (a) the 60-lb block and (b) the 100-lb block. For each case,…

A:

Q: A block of mass m¡ = 1.50 kg is placed on a frictionless horizontal tabletop. The left end of this…

A: Given Data: The mass m1=1.5 kg. The mass m2 = 2.00 kg. The mass m3. The extension of the spring is…

Q: A 90-kg smooth circular cylinder A with a radius of 0.6 m is held in equilibrium by a cord CD and a…

A: a. FBD.

Q: 5. A smooth inclined plane has a gradient of 1 in 6. Calculate the mass of a body that can be held…

A:

Q: In reference to the figure below, if uk = 0.7 at the rear drive wheels B of the 1550 lb race car…

A:

Q: The uniform bar is at rest on a smooth half-sphere with radius R = b / 2. In A there is a ball joint…

A:

Q: Three identical steel balls, each of mass m=80kg, are placed in the cylindrical ring which rests on…

A: Solution.jpg

Q: The mass center G of the 1300-kg rear-engine car is located as shown in the figure. Determine the…

A:

Q: 3. Determine the largest force P for which the 18 kg uniform bar remains in equilibrium. M= 0. 20…

A:

Q: Determine the tensions in cables AB, AC, and AD. 1.65 m 2.30 m 1.35 m 0.60 m B D 2.9 175 kg Answers:…

A:

Q: 6/16 The force P is applied to (a) the 60-lb block and (b) the 100-lb block. For each case,…

A:

Q: 6. A 12-m bar of negligible weight is acted upon by a vertical load P= horizontal load T 200 N and a…

A:

Q: Part A: Determine the horizontal component of the reaction that the pin at A exerts on the frame.…

A: Emb=0 cy X =TX1.7 Cy =T+by  500.31-294.3=206.01 N

Q: 4. 90-kg smooth circular cylinder A with a radius of 0.6 m is held in equilibrium by a cord CD and a…

A: a) Draw free body diagram Determine required angles using properties of triangle, Distance d can…

Q: Determine the maximum mass m of the suspended block so that the force on the members of the…

A: This question is solved with the help of the method of joint  To find out the maximum mass of the…

Q: The hanging mobile pictured above consists of two masses, m1 and m2, suspended from a uniform 10 cm…

A: Given data as per the question mass m1 = 0.02 kg mass of rod = 0.01 kg

Q: Two crates, each of mass 350 kg, are placed as shown in the bed of a 1400-kg pick-up truck. Draw the…

A: Given data as per question Mass of pick up truck =1400 kg Value of mass at point C and D =350 KG…

Q: L2 L3 E B. Lg L4 L5 L6 P. Find the magnitude of the force exerted on bolt E, given: P = 85 lbs, L1 =…

A: We will draw FBD for all parts:

Q: A 500-lb box is held at rest on a smooth plane by a force P inclined at an angle e with the…

A: Calculated force P and normal pressure force N exerted by the plane. Calculated the angle at which…

Q: Determine the magnitude of the forces in pins B and D of the four-member frame.     B = 56.3 lb, D =…

A:

Q: • F1- 10 lb @ -90° • a- 2 ft • b-4 ft • c-1 ft then, what is the magnitude of the vertical reaction…

A:

Q: Two crates, each of mass 400 Kg, are placed as shown in the bed of 1500 –kg pickup truck. Determine…

A:

Q: he elements of the spring loaded mechanism for the car tailgate are shown in the figure. For the…

A:

Q: Q.2) A car of mass 1200 kg is standing on a 20° incline with the horizontal. What are the components…

A: Hi. as you have posted multiple questions and have not specified which question needs to be solved,…

Q: Three identical steel balls, each of mass m=85kg, are placed in the cylindrical ring which rests on…

A:

Q: Determine the magnitude and direction of the angle theta of the force FAB that must be exerted on…

A: