The leading edge of a supersonic wing is wedge shaped, with a total included angle of 10°. (See Figure P6.4.) If the wing is flying at zero angle of attack, determine the lift and drag force on the front portion of the wing per meter of span. Repeat for an angle of attack of 3°. Assume that the wing is traveling at Mach 2.5. Leading edge of wing M, = 2.5 %3D 2.0 m

The leading edge of a supersonic wing is wedge shaped, with a total included angle of 10°. (See Figure P6.4.) If the wing is flying at zero angle of attack, determine the lift and drag force on the front portion of the wing per meter of span. Repeat for an angle of attack of 3°. Assume that the wing is traveling at Mach 2.5. Leading edge of wing M, = 2.5 %3D 2.0 m

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The Drag Polar Equation of an General Aviation Aircraft in clean configuration can be written as: C2 Cp = 0.0270+ %3D 32.787 Its weight is 2300 lb and the wing area is 155ft?, Calculate the (L/D)max and the Minimum Thrust Required (Unaccelerated Level flight and Sea level Condition)
Consider the Gulfstream IV flying at Mach = 0.35. Calculate thrust required given an altitude of 30,000-ft, assuming weight of 73,000-lb. Airplane data: S = 950 ft², AR = 5.92, Cpo = 0.015, and K = 0.08 Question 2 The thrust required at 30,000-ft. (in pounds)
A NACA 2412 airfoil with a chord of 0.64m is flying in an airstream of standard sea level conditions. The freestream velocity is 70 m/s. Given the lift per unit span is 1,254 N/m. By using the experimental data for NACA 2412 data plot in Figure Q1c, investigatethe angle of attack of the airfoil and the analyze the value of drag per unit spanof the airfoil. Given that at standard sea level, ?=1.789×10-5 kg/m.s.
If the pressure difference in the wind tunnel experiment is 50 mmH,0, the density of air is 1.2 kg/m in wind tunnel experiment, and the airfoil span is 204 mm, and the cord length is 98 mm, what is the lift coefficient if the lift force is L=13.4 N
Consider the Gulfstream IV flying at Mach = 0.35. Calculate thrust required given an altitude of 30,000-ft, assuming weight of 73,000-lb. Airplane data: S = 950 ft2, AR = 5.92, ??? = 0.015, and K = 0.08 a. The thrust required at 30,000-ft. (in pounds)
The lift curve for the 4 digit NACA 2421 airfoil is shown in the Figure. Consider a wing with AR = 8, sweep ? = 15 ???, and airplane flies at the Mach number equal to 0.3. The Oswald efficiency span number ?1 = 0.95 Calculate the lift slope for the finite wing. Clearly show the formula and explanations in the solution.
Ign, McGraw-Hill, this chapter) and by New York, 1999, for more information. EXAMPLE 6.18 Estimate the landing ground roll distance at sea level for the CJ-1. No thrust reversal = 0. The spoilers increase the zero-lift, used; however, spoilers are employed such that L drag coefficient by 10 percent. The fuel tanks are essentially empty, so neglect the wejehr of any fuel carried by the airplane. The maximum lift coefficient, with flaps fully em ployed at touchdown, is 2.5.
4- A thin plate 2 m wide is placed in a uniform air stream of velocity 100 m/s, (p = 1.2 kg/m'). If the skin friction drag force is 60 N, calculate the displacement thickness of the boundary layer at trailing edge of the plate. Assume that the velocity profile at all points in the boundary layer is: f(n) =n"6. [3.3 mm]
Icebergs can be driven at substantial speeds by the wind.Let the iceberg be idealized as a large, flat cylinder, D >> L,with one-eighth of its bulk exposed, as in Fig.. Letthe seawater be at rest. If the upper and lower drag forcesdepend on relative velocities between the iceberg and thefluid, derive an approximate expression for the steady icebergspeed V when driven by wind velocity U.
Assume the gross weight of the airplane is 600 lbs, what would be a reasonable estimate of its wing loading. *Use significant assumptions and solve this for propellers andjets.
A strong wind can blow a golf ball off the tee by pivoting it about point A, as shown in the figure. The golf ball has a radius of 22 mm and a mass of 47 g Assume a golf ball as a smooth sphere. The density of air is (p 1.22 kg/mn') and the viscosity is (u 1.8 10 (kg/m. s)). Calculate the wind speed (V) %3D %3D necessary to do this. V Radius - 22 mm Mass 47 g 6 mm tt
A fl at-plate airfoil with C = 1.2 m is to have a lift of30 kN/m when fl ying at 5000-m standard altitude withU∞= 641 m/s. Using Ackeret theory, estimate (a) the angleof attack and (b) the drag force in N/m.