The isoelectric point of eIF4a is 5.02. Students are given a sample of cell lysate containing eIF4A at pH 7.4. They are also provided with two buffers of pH 7.4 to use for ion exchange chromatography. One buffer has a very high salt concentration (1 M), the other has a low salt concentration (0.1 M). Mariela decides to use an anion exchange column, while Ashok chooses a cation exchange column. Who made the better decision? Provide a detailed explanation of why one student will end up with a purer sample of eIF4A. Which buffer will you use while washing away impurities (high or low salt), and which would you use to remove eIF4A from the column? Explain your choice.

The isoelectric point of eIF4a is 5.02. Students are given a sample of cell lysate containing eIF4A at pH 7.4. They are also provided with two buffers of pH 7.4 to use for ion exchange chromatography. One buffer has a very high salt concentration (1 M), the other has a low salt concentration (0.1 M). Mariela decides to use an anion exchange column, while Ashok chooses a cation exchange column. Who made the better decision? Provide a detailed explanation of why one student will end up with a purer sample of eIF4A. Which buffer will you use while washing away impurities (high or low salt), and which would you use to remove eIF4A from the column? Explain your choice.

Curren'S Math For Meds: Dosages & Sol

11th Edition

ISBN:9781305143531

Author:CURREN

Publisher:CURREN

Chapter21: Heparin Infusion Calculations

Section: Chapter Questions

Problem 1.1P

See similar textbooks

Similar questions

Paclitaxel is used to treat ovarian cancer by infusion at a concentration of 0.6 mg/mL over 24 hours. A dose of 135 mg/m² has been prescribed for Sero. Sero is 1.06 m tall and weighs 92 kg. Paclitaxel comes in vials of 150 mg/25 mL. Calculate the volume of 5%w/v glucose solution that would be required to dilute the concentrated solution to prepare an paclitaxel solution of the required strength.
Paclitaxel is used to treat ovarian cancer by infusion at a concentration of 0.6 mg/mL over 24 hours. A dose of 135 mg/m² has been prescribed for Sero. Sero is 1.06 m tall and weighs 92 kg. Paclitaxel comes in vials of 150 mg/25 mL. Calculate the volume of 5%w/v glucose solution that would be required to dilute the concentrated solution to prepare an paclitaxel solution of the required strength. Answer: You did not give the correct unit. The correct answer is: 333 mL X
A 5% dextrose in 1/2 normal saline (D5 1/2 NS) solution is commonly administered to patients needing post-operative IV fluids. How could you prepare 500 mL of this solution? Dextrose is 5% (m/v) and the NaCl is 0.45% (m/v).
Guanosine (C10H13N5O5) in solution has a maximum absorbance at a wavelength of 275 nm. The molar extinction co-efficient at this wavelength is 84M−1cm−1and the path length is 24.7 cm. Through the use of a spectrophotometer, it is found that the that A275= 1.48. What is the concentration of the guanosine solution in grams/litre? Molecular weights (g/mol): C-12, H-1, N-14, O-16 Select one: A. 0.201869 g/L B. 0.435188 g/L C. 0.059919 g/L D. 0.294046 g/L E. 0.000713 g/L
Tirofiban (C22H36N₂O5S MWt = 440.6) is present as tirofiban HCI monohydrate (C22H36N2O5S.HCI.H₂O MWt=495.1) at 0.281 mg/mL in a concentrated solution. A solution for infusion is prepared by extracting 50 mL from a 250 mL bag of 5% glucose solution and adding 50 mL of concentrated solution. Sofia who weighs weighs 87 kg requires a tirofiban dose of 0.1 mcg/kg/min for 12 to 24 hours. What would the infusion rate be (mL/h)? (Answer to 1 decimal place.) Answer:
In an experiment, separation of albumin from chicken liver was attempted at 31%, 58%, and 65% saturation with ammonium sulfate, (NH4)2SO4. After homogenization and centrifugation, 23 ml of the supernatant was obtained. What is the volume of saturated buffered (NH4)2SO4 (pH 7.0) that must be added to make the solution 31% saturated? 10.3 ml 8.33 ml 9.50 ml O 12.2 ml
What volume of 0.1M NaOH (reagent) needs to be added to increase your 7.5 pH (buffer) by 0.5 pH units. The goal is to further purify MOPs (see image). Protonated form = 6.6 x 10.3^-3 mol/L Deprotonated form = 1.32 x 10^-2 mol/L Show calculations.
Quinine ( C20 H24 N2 O2) is the most important alkaloid derived from cinchona bark. It is used as an antimalarial drug. For quinine, pK, = 5.1 and pK, = 9.7 ( pKp = – log Kp). Only 1 g quinine will dissolve in 1920.0 mL of solution. Calculate the pH of a saturated aqueous solution of quinine. Consider only the reaction | Q+ H2O= QH+ + OH- described by pK, where Q = quinine. pH =
Calculate the concentration of Y4-ion in 0.0100 M EDTA solution at pH 6. α4 = 2.2 x 10-5 for pH 6.
N-(2-hydroxyethyl)piperazine-N'-(2-ethanesulfonic acid) buffer at pH 7 with 400 mM NaCl. A A purified protein is in a Hepes dialysis membrane tube holds a 5.0 mL sample of the protein solution. The sample tube floats in a beaker containing 0.50 L of the same Hepes buffer, but with 0 mM NaCl, for dialysis. Small molecules and ions (such as Na*, CI", and Hepes) can to diffuse across the dialysis membrane, but the protein cannot. Assume there are no sample volume changes during the dialysis. Calculate the final concentration of NaCl in the protein sample once the dialysis has come to equilibrium. Calculate the final NaCl concentration in the 5.0 mL protein sample after dialysis in 300 mL of the same Hepes buffer, with 0 mM NaCl, twice in succession. [NaCl] after a single dialysis: [NaCl] after a double dialysis: mM mM
The standard curve to determine the amount of betacyanin is shown below. You extracted a red pigment from a beet disc (the mass of a disc is 2 g) using 10 ml of 20% ethanol solution. You measured absorbance of the solution above the beet disc every minute for a total time of 20 minutes. The increase in absorbance was linear during a period of time from 1 min to 10 min. The absorbance at 10 min was 0.8. Calculate the amount of betacyanin extracted from 1g of a beet tissue per minute. Explain your calculations. You can use Excel or a calculator.
The glass electrode used in commercial pH meters gives an electrical response proportional to the concentration of hydrogen ion. To convert these responses to a pH reading, the electrode must be calibrated against standard solutions of known H+ concentration. Determine the weight in grams of sodium dihydrogen phosphate (NaH2PO4 · H2O; FW 138) and disodium hydrogen phosphate (Na2HPO4 ; FW 142) needed to prepare 1 L of a standard buffer at pH 7.00 with a total phosphate concentration of 0.100 M . See Problem 24 for the pKa values of phosphoric acid.