The flow net around a sheet pile wall is shown in the sketch. The properties of the soil are: permeability coefficient = 0.09 m/day (isotropic), specific gravity = 2.70 and void ratio = 0.85. The sheet pile wall and the bottom of the soil are impermeable. The seepage loss (in m³ per day per unit length of the wall) of water is 10m 1.5m 3m

The flow net around a sheet pile wall is shown in the sketch. The properties of the soil are: permeability coefficient = 0.09 m/day (isotropic), specific gravity = 2.70 and void ratio = 0.85. The sheet pile wall and the bottom of the soil are impermeable. The seepage loss (in m³ per day per unit length of the wall) of water is 10m 1.5m 3m

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter11: Ground Improvement

Section: Chapter Questions

Problem 11.8P

See similar textbooks

Similar questions

A 3 m thick saturated soil stratum has a compression index of 0.25 and coefficient of permeability 3.2 x 10-3 mm/sec. If the voids ratio is 1.5 at vertical stress of 0.10 N/mm2, compute the voids ratio when the vertical stress is increased to 0.25 N/mm2. Also calculate settlement due to above stress increase and time required for 50% consolidation. Assume single drainage.
Estimate the total consolidation settlement (primary & secondary) after 2 years and 3 months after the completion of primary consolidation settlement of an over consolidated clay layer under the bridge pier as shown below. The pier's dimensions are (2 m x 3 m). Use Yw= 10 kN/m³ and note that the time for completion the primary consolidation is 3 years. | Qo= 960 kN G.W.L 1m Sand Ya=16.5 kN/m 2 m Ysat = 18 kN/m³ Silty Sand Ya=17.5 kN/m 3 m Ysat = 18.5 kN/m3 Clay Ya=20 kN/m , Ysat = 21 kN/m3 e, = 0.6 , Ae=0.04 , o= 78.3 kN/m2 4 m Cc= 0.4, Cs= 0.1, Ca= 0.02
The results of a laboratory consolidation test on a clay sample are given below: Pressure, p (kN/m²) Void ratio, e 23.94 1.112 47.88 1.105 95.76 1.080 191.52 0.985 383.04 0.850 766.08 0.731 (43) a) Draw an e-log p plot. (44) b) Determine the pre-consolidation pressure, p. . (45) c) Find the compression index, Ce. Appendix For ø=35°, N¸=57.8, N,=41.4, and N,=41.1. o,'=0;'tan²| 45°+ +2c tan| 45°+
1.16 Find out the time required for 50 % consolidation in a soil having thickness of 800 cm and pervious strata at top and bottom. What will be the value of coefficient of consolidation if coefficient of permeability is 0.0000001 cm/sec? Void ratio = 1.8, m,= 0.0003 cm?/gm, Y=1 gm/cc
The backfill material for a vibroflotation project has the following grain sizes: D10 = 0.11 mm, D20 = 0.19 mm, D50 = 1.3 mm. Determine the suitability number.
A clay specimen drained on both sides was tested. The data were obtained P1=50 kPa e1=0.92 P2=120 kPa e2=0.78 Time for 50% consolidation=2.5 min Tv=0.197 Determine the following 1. Coefficient of compressibility (Ans. 1.08x10-3 m2/kN) 2. Coefficient of consolidation (Ans. 1.23x10-5 m2/min) 3. Hydraulic conductivity of clay for the loading range (Ans. 1.31 x10-7 m/min)
A large building is to be built on a thick layer of normally consolidated clay shown in the figure below. The building is to be placed at the bottom of a 4 m deep excavation, which will correspond to 1 level of parking garages. The water table remains 4 m below the ground surface during the entire process. Find the OCR in the middle of the clay layer at Point A, a long time after excavation and before construction of the building. (Answer tolerance = 2%).
Q1 The two-way drainage clay layer of 6m thick, how long will it take for 75% consolidation to be over in the field? Given: cy= 0.24 cm²/min.
Answer the following questions: a- What is pre-consolidation pressure? Plot the consolidation curve and show it. b- In which region of the optimum water content of a dam clay core is desired to be, explain why.
The flow net around a sheet pile wall is shown in the sketch. The properties of the soil are permeability coefficient = 0.09 m/day (isotropic), specific gravity = 2.70 and void ratio =0.85. The sheet pile wall and the bottom of the soil are impermeable. 10 m 1.5 m 3m 4.20 The factor of safety against the occurrence of piping failure is
Q: For the soil profile shown in figure. Find: a) Final consolidation settlement. b) Time required for 60% consolidation. c) Pore water pressure after 18 months. d) Piezometer reading above point (A) immediately after applying the load. Surcharge Aq.= 100 kPa Sand y=15kN/m’ 7kN/ m® Piezometer t AT ol g thefity i
A- A layered sou nas the following: Top layer has the FC = 40%, PWP = 18% and depth = 50 cm. Initial water content = 26% by volume and PAD = 35%. Bottom layer has FC = 38%, PWP = 20% and depth = 60 cm. Actual water content = 30% by volume, PAD = 55%. Find the required depth of irrigation. Also, for each layer, show whether the irrigation was applied on time or not?