3 The empty steel cylinder in Figure below floats in the position shown. What is cylinder mass in kg?3 cm8 cmWaterD=9 cm-O a. 0.45 kgO b. 4.99 kgO c. 0.75 kgO d. 1.00 kge. 0.51 kg

Answered: The empty steel cylinder in Figure…

The empty steel cylinder in Figure below floats in the position shown. What is cylinder mass in 3 ст 8 сm Water -D = 9 cm- O a. 0.45 kg O b. 4.99 kg О с. 0.75 kg O d. 1.00 kg e. 0.51 kg О е.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: The tank contains water and immiscible oil at 20°C. Calculate h if the density of the oil is 898…

A: Solution:

Q: In the following figure, the cylindrical body floats in the position shown. What is its weight in N?…

A: Given Data D=10 cm H=10+4 = 14 cm

Q: A5 gallon, cylindrical open container with a bottom area of 120 in? is filled with glycerin…

A: Given data:

Q: A crane is used to lower a 0.4 m³ concrete block (density, p= 2200 kg/m³) into the sea (density, p =…

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

Q: A tank contains oil (s=0.80), gasoline (s=0.90) and water (s=1). What is the pressure at a depth of…

A: Step-1Given:- (SG)oil=0.80 (h)oil=0.50m (SG)gasoline=0.90…

Q: In Fluid Mechanics 8th edition by Frank M. White there is a problem I'm not certain how to even…

A: Refer to the figure mentioned below.

Q: Capillary rise in the glass tube used for measuring water level is not to exceed 0.5 mm. Determine…

Q: A plane is fitted with pontoons for operation on lakes. As it taxies out for take-off, the plane…

Q: The tube shown below is filled with oil. Determine the pressure heads at B and C in meters of water.…

A: Given Data: The specific gravity of oil, 0.85

Q: A 0.75-m-diameter cylindrical mass, M, is connected to a 2-m wide rectangular gate as shown in the…

Q: 1610 m) Determine the weight (in Ib;) of an 160-lbm person at sea level (z = 0), in Denver (z = and…

Q: If an object sinks in a fluid_ O The density of the fluid is greater than the density of the object…

Q: 2. The gage pressure of the air in the -Oil tank is measured to be 65 kPa. Find SG = 0.72 the…

Q: Q2:- A wood cone floats in water in the position shown in fig.2.The specific gravity of the wood is…

Q: The hydrometer shown in Figure below is a device for measuring the specific gravity of liquids. The…

A: Given: The volume of the bulb, V’ = 20 mL The length of the stem, h = 15 cm The diameter of the…

Q: What percent of the volume of a piece of iceberg (sg=0.915) will float above the water?

A: Givenspecific gravity of the icebergsg=0.915

Q: An inverted cone is placed in a water tank as shown below. If the weight of the cone is 46 N, what…

A: Given: Weight of the cone (W)=46N Assumption: Density of water (ρ)=1000kg/m3Acceleration due to…

Q: The piston shown (Figure 1) is acting on a fluid whose pressure is P = 135 kPa (abs). What force, F,…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: 1. What is the relation do you find between the weights of the floating body and the weight of water…

A: NOTE:- As per our company guidelines we are supposed to answer only one question. Kindly repost…

Q: A body floats half and submerged in a certain liquid (s.g. = 1.25) and has a weight of 500 kN.…

A: The weight of the body will act downward and the buoyant force will act upward.

Q: An irregularly shaped object floats freely in water (y = 62.4 lbf/ft'), such that 20 of the volume…

Q: When floating in water (SG = 1.0), an equilateral triangu- 'ar body (SG = 0.9) might take one of the…

Q: plane is fitted with pontoons for operation on lakes. As it taxies out for take-off, the plane…

Q: P2.51 Gate AB in Fig. P2.51 is 1.2 m long and 0.8 m into the paper. Neglecting atmospheric pressure,…

A: Given : length of gate = 1.2 m SG of oil = 0.82

Q: A cylindrical tank 1m in diameter and 2m high contains water at a depth of 1.6m. If it is rotated…

Q: Cakulate the value of h. if the gauge pressure of air in the vessel shown bekow is 127 kPa, hy- 0.1…

Q: Measurements of pressure at the base and top of a mountain are 74cm and 60cm of mercury…

A: We know that measurement of pressure at the base and top of a mountain are 74 cm and 60 cm of…

Q: 1 What is the net force on a ball of mass 20 kg and volume of 0.2 m^3 when it is submerged…

Q: A certain metal has a volume of 0.025 cu.m and when immersed in water, it weighs 500 N. Calculate…

A: According to our guidelines In case of multiple questions, we are supposed to answer the first…

Q: The figure presented below is a 3- liquid system. The height difference between h₁ and h₂ is 370…

Q: In the figure shown, the steel block which has a mass of M=2.2 kg is placed on a piston that has a…

Q: A manometer using oil (density 0.900 g/cm3) as a fluid is connected to an air tank. Suddenly the…

A: Given data :- oil density = 0.900 g/cm3 Pressure rises to = 7.61 mm of Hg Mercury density = 13.6…

Q: Hydraulic balance. An m = 60.0 [kg] crate was placed on top of a 2.75 [m²] "massless" platform.…

Q: A crane is used to lower a 0.4 m³ concrete block (density, p = 2200 kg/m³) into the sea (density, p…

A: Given data: The volume of the concrete block, V = 0.4 m3. The density of the concrete block, ρc =…

Q: Q) Find the density of metallic body which floats at the interface of mercury of sp.gr 13.6 and…

Q: A 0.75-cm-diameter spherical object is completely submerged in water. The buoyant force acting on…

A: Given: Diameter of the sphere, d= 0.75 cm The buoyant force acting on the object is calculated by…

Q: P2.116 The can in Fig. P2.116 floats in the position shown. What is its weight in N? 3 сm mil lo 8…

A: Draw free body diagram of can

Q: 6. Blue manometer fluid of density 925 kg/m3 shows a column height difference of one end attached to…

Q: Two tank with the same fluid at their base are separated by piston whose weight is (50 N) and (30…

Q: An object (SG = 7.3) floats in mercury (SG = 13.6) such that a certain portion is above the liquid…

Q: Find teh volume (m3) of teh water displaced for a wooden block of width 3.7 m and of depth D= 1.2 m,…

A: Calculate the volume of the block. V=LBD Here, V is the volume of the block, L is the length of the…

Q: 2 m Ø Par = 0.8 kg/cm? 8 m 6 m Oil; s 0.8

A: For solution refer below images.

Q: PROBLEMS : A cube of wood floats in oil with a relative density of 0,78 so that half of the cube is…

Q: Define the weight of a unit mass at sea level.

A: The weight of a unit mass at sea level is equal to the product of I kg of mass to the acceleration…

Q: Balloons are often filled with helium gas because it weighs only about one-seventh of what air…

A: Given Data Diameter of the balloon is: d=12 m Mass of each person is: m=70 kg Density of air is:…

Q: For the three-liquid system shown, compute h 1 and h 2 .Neglect the air density.

A: givenneglect air density

Q: In a hydraulic car lift, the input piston has a radius of 2 cm and a negligible weight. The output…

Q: A tank open to the atmosphere contains oil of sp. gr. = 0.80, gasoline sp.gr. =0.90 and seawater…

Concept explainers

Fluid Kinematics

The branch of science that deals with objects which are either in motion or stationary are studied under the branch of classical mechanics. Fluid mechanics is a subcategory of classical mechanics that deals with the behavior of fluids at rest (fluid statics) or in motion (posing some velocity). In fluid kinematics, studies focus on the associated motion of fluid particles or groups of particles, and its associated parameters like displacements, velocity, and acceleration without concerning about the forces that caused the motion. All the laws of classical mechanics are applied in the study of fluid kinematics.

Question

The empty steel cylinder in Figure below floats in the position shown. What is cylinder mass in kg?
3 cm
8 cm
Water
D=9 cm-
O a. 0.45 kg
O b. 4.99 kg
O c. 0.75 kg
O d. 1.00 kg
e. 0.51 kg

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1. x = Mass 20.15 (g) calculate iinto (kg). ; weight = 0.21 (N). 2. Mass = 45.83 (g) calculate into (kg); weight = 0.42 (N). After conversion plot, weight on y-axis and mass on x-axis. How to solve this equation?
1. Volume of sphere A in in^3 2. Pressure of sphere A in psia 3. Temperature of sphere A in R
A man who is 5ft 10 in. tall weighs 160lbs. What is his height in centimeters and his mass in kilograms?
3) When being pushed up a ramp, the motion is 35° up (sky-wards) from due West. If gravity pulls on the sliding object with 48N, how much word does gravity do as an outside force when the object slides 3.9m up the ramp? W = FAr.
Answer in 3 decimal places Two animals were placed on both end of a hydraulic lift system as show below. A mouse with a mass of m=9 g is placed on a smaller piston with a diameter of 10 cm. If an elephant with a mass of 4 000 kg is placed on the larger piston, how wide should the diameter of the larger piston be so that pressures at both ends are equal?
5. If the density of a gas is 0.003 slugs per cubic foot, what is the specific weight of the gas in N/m?.
A 15.4-lb piston is fitted in a cylinder with an area of 0.02 ft2. The cylinder contains gas. The piston-cylinder assembly is in a centrifuge that creates an acceleration of 20 m/s2 in the direction of piston motion towards the gas. Find the gas pressure in kPa. Assume standard atmospheric pressure outside the cylinder. Select one: O a. 176.67 O b. 25.63 O c. 26.80 O d. 184.70
1 0 Calculate the total volume of the cylindrical component below (not to scale): L1 D1- D1 = 1.12 cm D2 = 0.71 cm D3 = 1.58 cm L1 = 18.68 cm L2 = 15.36 cm L3=13.77 cm L4 = 9.77 cm Answer: Check L2 L3 L4 D2- What is the volume of the cylindrical component? (State your answer in S.I. units (m³), accurate to 3 significant figures) D3
Show complete solutions and figures The diameters of the two cylinders A and B in the figure shown are 80 mm and 750 mm, respectively. The face of the piston is 1.2 m above the face of the weight platform. The space in between the piston and the weight is filled with oil (s.g.=0.80). If F=75 N, Determine the following: the value of Wrequired to maintain equilibrium. a) 38.6 N b) 86.3 N c) 63.8N d) 83.6 N e) None
Find the location of the center of mass of a nonuniform rod 40cm in length if its density varies linearly from 1 g/cm at one end to 5 g/cm at the other end. Specify the center of mass location relative to the less massive end of the rod. Leave the values in g and cm. a) Find the mass of the rod in grams b) Where is the center of mass of the rod (in cm)?
2. A tank of carbon tetrachloride (CC4) has a mass of 500 kg and a vohme of 0.315 m², a. What is the weight of carbon tetrachloride in kN? b. What is the mass density in kg/m? c. What is the unit weigh in kN/ m²?
a.) If the specific weight of a liquid is 55 lb/ft³, what is its density? b.) If the specific weight of a liquid is 9.6 kN/m³, what is its density? c.) If the specific volume of a gas is 295 ft³/slug, what is its specific weight in Ib/ft?