the emf source E = 2,9 V, of the curcuit shown in the figure has negligible internal resistance.The resistors have resistances R1=1,2 ohm and R2=3,4 ohm. The capaccitance C = 3,1 uF.a) determine the constant r, in units of microseconds for charging the capacitor?b)what is the charge Q on the capicotor in units of microcoulomb ? (!) THE FOLLOWING QUESTIONS ARE BASED ON THE INFORMATION GIVEN HERE.R2wwThe emf source, E = 2.9 V, of the circuit shown in the figure has negligible internal resistance. The resistors have resistances R =1.2N and R2 = 3.4 . Thecapacitor has a capacitance C = 3.1 µF.CR1A) Determine the time constant T, in units of microseconds for charging the capacitor.Answer:B) What is the charge Q on the capacitor in units of microcoulomb?Answer:

The time constant of a RC circuit is given by

the emf source E = 2,9 V, of the curcuit shown in the figure has negligible internal resistance.The resistors have resistances R1=1,2 ohm and R2=3,4 ohm. The capaccitance C = 3,1 uF. a) determine the constant r, in units of microseconds for charging the capacitor? b)what is the charge Q on the capicotor in units of microcoulomb ?

the emf source E = 2,9 V, of the curcuit shown in the figure has negligible internal resistance.The resistors have resistances R1=1,2 ohm and R2=3,4 ohm. The capaccitance C = 3,1 uF. a) determine the constant r, in units of microseconds for charging the capacitor? b)what is the charge Q on the capicotor in units of microcoulomb ?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 55P: An ECG monitor must have an KC time constant lessthan 1.00102s to be able to measure variations...

See similar textbooks

Similar questions

An ECG monitor must have an KC time constant lessthan 1.00102s to be able to measure variations involtage oversmall time intervals, (a) If the resistance of the circuit (duemostly to that of the patient's chest) is 1.00kTwhat is the maximum capacitance of the circuit?(b) Would It be difficult in practice to limit the capacitance to less than the value found in (a)?
Consider a circuit that consists of a real battery with an emf and an internal resistance of r connected to a variable resistor R. (a) In order for the terminal voltage of the battery to be equal to the emf of the battery, what should the resistance of the variable resistor be adjusted to? (b) In older to get the maximum current from the battery, what should the resistance variable resistor be adjusted to? (c) In order for the maximum power output of the battery to be reached, what should the resistance of the variable resistor be set to?
The label on a battery-powered radio recommends the use of a rechargeable nickel-cadmium cell (nicads), although it has a 1.25-V emf, whereas an alkaline cell has a 1.58-V emf. The radio has a 3.20 resistance.(a) Draw a circuit diagram of the radio and its battery. Now, calculate the power delivered to the radio (b) when using a nicad cells, each having an internal resistance of 0.0400 , and (c) when using an alkaline cell, having an internal resistance of 0.200 . (d) Does this differenceseem significant, considering that the radio's effective resistance is lowered when its volume is aimed up?
A 160F capacitor charged to 450 V is dischargedthrough a 31.2k resistor, (a) Find the time constant.(b)Calculate the temperature increase of the resistor, given that its mass is 2.50 g and its specific heat is 1.67kJ/kg °C,noting that most of the thermal energy is retained in the short time of the discharge, (c) Calculate the new resistance, assuming it is pure carbon. (d) Does this change in resistance seem significant?
An automobile starter motor has an equivalent resistance of 0.0500 and is supplied by a 12.0-V battery with a 0.0100- internal resistance, (a) What is thecurrent to the motor? (b) What voltage is applied to it? (c) What power is supplied to the motor? (d) Repeat these calculations for when the battery connections are corroded and add 0.0900 to the circuit. (Significant problems are caused by even small amounts of unwanted resistance in low-voltage, high-current applications.)
A 1,00-?O voltmeter is placed in parallel with a 75.0kresistor in a circuit, (a) Draw a circuit diagram of the connection, (b) What is the resistance of the combination? If the voltage across the combination is kept the same as it was across the 75.0-kresistor alone, what is the percent increase in current? (d) If the current through the combination is kept the same as it was through the 75.0-kresistor alone, what is the percentage decrease in voltage? (e) Are the changes found in parts (c) and (d) significant? Discuss.
Consider the circuit shown in Figure P28.21 on page 860. (a) Find the voltage across the 3.00-0 resistor, (b) Find the current in the 3.00-12 resistor.
a). A circuit consist of five resistors connected as below, determine the effective resistance in the circuit. RI R2 Given that R1, R,Rs,RA and Rs are given respectively as 50, 25, 30, 60 and 70Q, what is the current in the circuit if the potential aeross the resistors is 24 V?
() THE FOLLOWING QUESTIONS ARE BASED ON THE INFORMATION GIVEN R2 HERE. R1 The emf source, E = 4.7 V, of the circuit shown in the figure has negligible internal resistance. The resistors have resistances R = 2.5 N and R, = 4.1 N. The capacitor has a capacitance C = 3.1 µF. A) Determine the time constant T, in units of microseconds, for charging the capacitor. Answer: B) What is the charge Q on the capacitor in units of microcoulomb? Answer:
For the circuit shown in Fig.1 below, C1 = 5μF, C2 = 4μF, C3 = 6μF and ∆V = 65V. Find:(a) the equivalent capacitance, (b) the charge on each capacitor and (c) the potential differenceacross each capacitor.Figure 1: Problem 2.Problem 3For the circuit shown in Fig.2 below, determine the resistance R such that the current in R is0.50 A, with the sense from a to b.Figure 2: Problem 2.Problem 4A straight wire of length 0.40 m, carrying current I = 7.0 A is oriented at angle θ = 27◦ toa uniform magnetic field B = 1.2 T. The field is in the positive x-direction. Determine themagnitude and direction of the magnetic force on the wire.1
O 0:07 Regarding the connection of ammeter and voltmeter, choose the correct circuit diagram for Ohm's law. а. R (A Ob. R C. A R d.
a) A battery having an emf (ɛ) of 6V and an internal resistance (r) of 0.32 is connected to a load of 302 as shown below. What will be the readings in the ammeter and the voltmeter? [2 marks] 3 A RLOAD V. i) The ammeter reading will be = A