The drawing shows a hydraulic chamber with a spring (spring constant = 1140 N/m) attached to the input piston and a rock of ma 32.0 kg resting on the output plunger. The piston and plunger are nearly at the same height, and each has a negligible mass. By ho much is the spring compressed from its unstrained position? fun

The drawing shows a hydraulic chamber with a spring (spring constant = 1140 N/m) attached to the input piston and a rock of ma 32.0 kg resting on the output plunger. The piston and plunger are nearly at the same height, and each has a negligible mass. By ho much is the spring compressed from its unstrained position? fun

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter15: Fluids

Section: Chapter Questions

Problem 43PQ

See similar textbooks

Similar questions

The lintel of prestressed reinforced concrete in Figure P12.27 is 1.50 m long. The concrete encloses one steel reinforcing rod with cross-sectional area 1.50 cm2. The rod joins two strong end plates. The cross-sectional area of the concrete perpendicular to the rod is 50.0 cm2. Youngs modulus for the concrete is 30.0 109 N/m2. After the concrete cures and the original tension T1 in the rod is released, the concrete is to be under compressive stress 8.00 106 N/m2. (a) By what distance will the rod compress the concrete when the original tension in the rod is released? (b) What is the new tension T2 in the rod? (c) The rod will then be how much longer than its unstressed length? (d) When the concrete was poured, the rod should have been stretched by what extension distance from its unstressed length? (e) Find the required original tension T1 in the rod. Figure P12.27
Because atmospheric pressure is about 105 N/m2 and the area of a persons chest is about 0.13 m2, the force of the atmosphere on ones chest is around 13 000 N. In view of this enormous force, why dont our bodies collapse?
A host pours the remnants of several of wine into a jug a party. The host then inserts a cork with a 2.00-cm diameter into the bottle, placing it in direct contact with the wine. The host is amazed when the host pounds the cork into place and the bottom of the jug (with a 14.0-cm diameter) breaks away. Calculate the extra force exerted against the bottom if he pounded the cork with a 120-N force.
A horizontal pipe 10.0 cm in diameter has a smooth reduction to a pipe 5.00 cm in diameter. If the pressure of the water in the larger pipe is 8.00 104 Pa and the pressure in the smaller pipe is 6.00 104 Pa, at what rate does water flow through the pipes?
A copper rod with length 1.4 m and cross-sectional area 2.0 cm2 is fastened to a steel rod of length L and cross-sectional area 1.0 cm2. The compound structure is pulled on each side by two forces of equal magnitude 6.00 104 N (Fig. P14.57). Find the length L of the steel rod if the elongations (L) of the two rods are equal. Use the values Ysteel = 2.0 1011 Pa and YCu = 1.1 1011 Pa. FIGURE P14.57
In about 1657. Otto von Guericke, inventor of the air pump, evacuated a sphere made of two brass hemispheres (Fig. P9.89). Two teams of eight horses each could pull the hemispheres apart only on some trials and then with greatest difficulty, with the resulting sound likened to a cannon firing. Find the force F required to pull the thin-walled evacuated hemispheres apart in terms of R, the radius of the hemispheres, P the pressure inside the hemispheres, and atmospheric pressure P0. Figure P9.89
The left ventricle of a resting adult's heart pumps blood at a flow rate of 83.0 cm3/s , increasing its pressure by 110 mm Hg, its speed from zero to 30.0 cm/s, and its height by 5.00 cm. (All cumbers are averaged over the entire heartbeat) Calculate the total power output of left ventricle. Note that most of the power is used to increase blood pressure.
In the figure, a spring of spring constant 2.30 x 104 N/m is between a rigid beam and the output piston of a hydraulic lever. An empty container with negligible mass sits on the input piston. The input piston has area A₁, and the output piston has area 13.0A;. Initially the spring is at its rest length. How many kilograms of sand must be (slowly) poured into the container to compress the spring by 7.40 cm? Container Beam Spring Number i Units
In the figure, a spring of spring constant 2.20 x 104 N/m is between a rigid beam and the output piston of a hydraulic lever. An empty container with negligible mass sits on the input piston. The input piston has area A₁, and the output piston has area 13.0A;. Initially the spring is at its rest length. How many kilograms of sand must be (slowly) poured into the container to compress the spring by 7.60 cm? Container Number Beam Spring Units >
The drawing below shows a hydraulic chamber in which a spring (spring constant = 1620 N/m) is attached to the input piston (A1 = 12.7 cm2), and a rock of mass 38.2 kg rests on the output plunger (A2 = 62.8 cm2). The piston and plunger are nearly at the same height, and each has a negligible mass. By how much is the spring compressed from its unstrained position?
a spring of spring constant 3.00*10^4 N/m is between a rigid beam and the output piston of a hydraulic lever. An empty container with negligible mass sits on the input piston.The input piston has area Ai, and the output piston has area 18.0Ai. Initially the spring is at its rest length. How many kilograms of sand must be (slowly) poured into the container to compress the spring by 5.00 cm?
A light spring of constant 165 N/m rests vertically on the bottom of a large beaker of water.A 4 kg block of wood of density 649 kg/m3is connected to the top of the spring andthe block-spring system is allowed to come tostatic equilibrium.What is the elongation ∆L of the spring?The acceleration of gravity is 9.8 m/s2.Answer in units of cm.