The cable shown in Fig.distributed load of 25 kN per meter of horizontal length.The left support of the cable is located 50 m below the rightsupport. The angle between the cable and the horizontal atthe left support is 10°. Determinecarries a uniformlyThe tension in the cable at the right support.50 m10150 m-

Given: uniform distributed load w=25 kN/m Height of the distance between supports, h = 50 m angle,…

Answered: The cable shown in Fig. distributed…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Three pairs of flexible cables, spaced at 120° inter- vals, are used to stabilize a 1000-ft television tower. The tower and one pair of cables is shown in Fig. weight of the cables is 3.0 lb/ft. The horizontal component of the force exerted by each cable is 6000 Ib. At anchor A, the angle between cable AC and the horizontal must be 40°. Determine The The maximum tension in cable AC. 400 ft B 400 ft KKKKKKKKKKI
A 60,0-cm, uniform, 50,0-N shelf is supported horizontally by two vertical wires attached to the sloping ceiling. A very Small 25,0-N tool is placed on the shelf midway between the points where the wires are attached to it. Draw a free-body diagram of the shelf. Find the tension in each wire. |75.0 cm 25.0 cm Tool 20.0 cm,
As shown below, a sign weighing 121 N is hanging (via a wire) from a uniform 256 N beam of length L. Additionally, the beam is attached to a cable that makes an angle 0 (0 = 51°) with the beam. 0.9 L 0.7 L 501 OAK 8 X Determine the tension in the cable and the magnitude & direction of the force the hinge (the orange circle) exerts on the beam. Cable tension = Hinge force = Direction of hinge force = in quadrant - Choose quadrant - 21 CHER ° relative to the horizontal MacBook Pro kg ro from n. The o the ce tv
A oil rig tower is held in equilibrium by three ropes. The tension in cable AD is tightened until it reaches 4700 N. Values for the figure are given in the following table. Note the figure may not be to scale. Variable Value d₁ 5 m d₂ 11 m 13.5 m 27.5 m 5m 65 m D d3 d4 d5 de a. Determine the magnitude of the force/tension in cord AB, TAB. b. Determine the magnitude of the force/tension in cord AC, TAC. c. Determine the magnitude of the force developed along the tower, FAE. → i. Hint: FAE = (0 +03+ FAEK) N. Round your final answers to 3 significant digits/figures. The magnitude of the force/tension in cord TAB is N The magnitude of the force/tension in cord TAC is N The magnitude of the force developed along the tower FAE is N
Two weights are hung over two frictionless pulleys that are connected by a wire rope to a 500 Ib horizontal block that are in between and below them. The wire rope attached to the upper left end of the block and to the left pulley is at 45 degrees with the horizontal and the wire rope that connects the upper right end of the block to the right pulley is at 30 degrees with the horizontal. If the weight on the left pulley is 50 lb, fs= 0.30 and fk = 0.20 on the surface of block what weight W on the right pulley will cause the 500 lb block to just start moving to the right? *
1. A museum of modern art is displaying an irregular 426-N sculpture by hanging it from two thin vertical wires, A and B, that are 1.25 m apart. The center of gravity of this piece of art is 48.0 cm from its extreme right tip. a). Find the tension in each wire. Show the step by step and complete solution. Draw also the complete FBD (as seen in the figure).
A rigid bar AD is supported by a ball-and-socket at D, and the two cables are attached to the beam at A. A downward force of magnitude 5000 N is applied at A. Neglect the weight of the rigid bar AD. what is the magnitude of the tension AB, denoted by T1? And what is the magnitude of the tension AC, denoted by T2 АВ Let T %3D АВ = T, r AB АС Ťc=T2 АС I m 2 m m 2 m 4 m 5000 N
4 A ski resort chair lift has towers spaced 38 m horizontaly appart. The upper tower is 15 m higher than the previous tower. If the chairs are 12 m horizontally appart and the first chair is 5 m past the lower tower what is the tension on both ends of the cable? 1:37:01 Book The mass of each chair is 350 Kg and the height above the lower tower for each chair's attachment to the cable is 0.58537 m, 4 m, 9.4244 m. Lower Tower Cable Tension = Upper Tower Cable Tension = kN. KN.
In the 190.0 meter span cable and a horizontal load of 5.550 KN/m horizontal load, find the location of point C from point B = ____________m the lowest point in the cable system. Then Determine the maximum tension on the cable, Tmax = _____________KN and the diameter of the cable , Cable Diameter = _______________ if the maximum allowable stress is 1250 MPa for the cable. Find also the value of T1 = _______________KN given the specifics at the figure below which is the pulley at A, Then determine the volume of concrete Vconcrete = ___________m3 of the dead man’s load at point D of the figure if the unit weight of concrete is 24 KN/m3.
A 157-lb box is held at rest on a smooth surface (p = 12°) inclined by a force, 'P' making an angle '8' with the incline. If 8 = 59°, determine the value of the force, "P".
A 232-lb box is held at rest on a smooth surface (p = 14°) inclined by a force, P' making an angle e' with the incline. If 8 = 53°, determine the value of the force, 'P".
A chain weighing 3 Lb/ft has its lowest point horizontally located 8 ft from the left support and 10 ft from the right support. The difference in elevation between the lowest point on the curve and the right support is 12 ft. Determine the maximum tension of the chain. 35.50 Lb 52.40 Lb 45.60 Lb 55.75 Lb

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS