The adjacent figure shows a sketch of Boyle's law opparatus similar to the one that was used inthe lob. if the otmospheric pressure Pa = 760 mmg and knowing that the length of the gas column L = 5.7 cm and the height of mercury h = l4 cm then the pressure (in mmg) of the entropped gas in the closed left-hand-side tube is: O a 862.0 Ob 770.2 Oc 980.0 d. 874.0 O e. 764.5

The adjacent figure shows a sketch of Boyle's law opparatus similar to the one that was used inthe lob. if the otmospheric pressure Pa = 760 mmg and knowing that the length of the gas column L = 5.7 cm and the height of mercury h = l4 cm then the pressure (in mmg) of the entropped gas in the closed left-hand-side tube is: O a 862.0 Ob 770.2 Oc 980.0 d. 874.0 O e. 764.5

Name: The adjacent figure shows a sketch of Boyle's law opparatus similar t
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: The adjacent figure shows a sketch of Boyle's law opparatus similar to the one that was used inthe lob. if the otmospheric pressure Pa = 760 mmg.and knowing that the lengthof the gas column L = 5.7 cm and the height of mercury h = l4 cm then the pre

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.122P: The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate...

See similar textbooks

Similar questions

A multifluid container is connected to a U-tube, as shown in the figure. For the given specific gravitles and fluid column heights. determine the gage pressure at A. Also determine the height of a mercury column that would create the same pressure at A. The column heighth of oil is 86 cm. The specific gravitles are 1.26 for glycerin and 0.90 for oll. We take the standard density of water to be Pw=1000 kg/m³ and the specific gravity of mercury to be 13.6. h 35 cm 18 cm Į Oil SG-0.90 Water Glycerin SG-1.26 90 cm 15 cm The gage pressure at A is kPa. The height of a mercury column that would create the same pressure at A is cm.
I.A U-tube manometer filled with Liquid A is attached to the underside of 4 inch pipe carying water, as shown in Figure 2. At a point directly above the inclined U-tube manometer tap, the upstream tap of an inverted U tube is located. The inverted-U-tube manometer is filled with a Liquid B. If the P:-17 psi, determine; (Note: I in (inch) - 25.4 mn, I atm - 101.325 kNiw - LO1325 har - 101.325 APa - 14.7 poi, g -9.8sims) (a) the differential manometer reading (psig), and (b) the value of X (inch). Liquid , SG-05 12 in. Water Liquid A, SG 16
As shown in the figure, an inclined manometer is used to measure the pressure of the gas within the reservoir. The manometer fluid is mercury, which has a density of 845 Ib/ft3. The manometer fluid rises a distance d = 12 inches along the manometer tube, which is inclined e = 20° from the horizontal. The atmospheric pressure is 14.7 Ibf/in? and the acceleration of gravity is 32.2 ft/s?. Patm = 14.7 Ibf/in.? Gas reservoir g = 32.2 ft/s? a 20 in. Mercury (p = 845 Ib/ft³) Determine the gas pressure, in Ibf/in?. Express the pressure as a gage or a vacuum pressure, as appropriate, in Ibf/in2.
Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. A U tubedifferential manometer is connected between the pipes. The center of the pipe A is 1 mabove the pipe B. The height of oil in right limb is 30 cm. Also, the mercury leveldifference is found in right limb as 10 cm. Find the pressure difference between these twopipes in kPa. Sketch the arrangement neatly.
Barometric reading at a place is 75 cm of Hg. Express the pressure intensity of 10 N per cm is: kN K abs. (i) m of water (ii) mm of mercury (ii)
The tank of an air compressor has a volume of 2m3 and is filled with air at a temperature of 40 degrees C. If agauge pressure on the tank reads 7.5 bars,what is themass of the air in the tank?
Two ends of an U-tube manometer which contains mercury, is connected between two pipes (A & B) that carries oil of specific gravities 1.05 & 0.8 respectively. The center of the pipe B (right limb) is 14 cm above the pipe A (left limb). The mercury level difference in the Left limb is 2 cm, and the height of fluid in the left limb is 5.95cm, find the pressure difference between these two pipes in Pascal. Draw the diagram.
The left limb of a U-tube mercury manometer isconnected to a water pipe line, with the mercury level inthe leg (specific gravity = 13.6) 19.685inches below thepipe line's center, and the right limb open to theatmosphere. The right limb's mercury level is 0.4374 yardhigher than the left, while the space above mercury in theright limb contains benzene (specific gravity = 0.88) to aheight of 0.2 m. Determine the water pressure in the pipe.
(1) The mercury manometer in the Figure below is connected to the inlet and outlet of a water pump (the left side to the inlet and the right side to the outlet). Assuming that the inlet and outlet are at the same elevation, determine the pressure increase for the pump. Inlet and outlet clevation Water hy =15 cm Mercury 13.9 keiul. Density of mercury = 13.6 g/cm3 = 13,593 kg/m3 Density of water = 1.0 g/cm3 = 1,000 kg/m3
A 12.5 kg block of metal measuring 12.0 cm by 10.0 cm by 10.0 cm is suspended from a scale and immersed in 5.60 cm below the surface of the water. Scale a b (a) What are the magnitudes of the forces (in N) acting on the top and on the bottom of the block due to the s significant figures.) Frop N N Fbottom (b) What is the reading of the spring scale (in N)? N (c) Show that the buoyant force equals the difference between the forces at the top and bottom of the block. ( II
A tank of water 4 m deep receives a constant upwardacceleration a z . Determine ( a ) the gage pressure at the tankbottom if a z = 5 m 2 /s and ( b ) the value of a z that causes thegage pressure at the tank bottom to be 1 atm.
A circular tank at a storage facility is 10 metres diameter andcontains transformer oil of mass density 885 kg/m3 to a depth of 6.5metres.(i) Draw the pressure distribution diagram for the side of thetank noting all significant values and showing the position ofthe force due to oil on the side of the tank relative to the oilsurface. (ii) Calculate the ground pressure under the full tank (in kPa)neglecting the weight of the tank.