9. If you were asked to separate the components of a mixture of sand and water,and further separate the components of water. What processes would youperform?c. filtration and distillationd. filtration and evaporationa. decantation and filtrationb. decantation and electrolysis10. The element X in a compound was involved in a chemical reaction. After thereaction was completed, which of these would likely happen to the mass ofelement X?a. It will increaseb. It will disappearc. It will be doubledd. It will remain the same

9) As we know, water and sand is heterogeneou mixture. So it can be separated by decantation. But…

Answered: tation and fiitra

Chemistry for Engineering Students

4th Edition

ISBN:9781337398909

Author:Lawrence S. Brown, Tom Holme

Publisher:Lawrence S. Brown, Tom Holme

Chapter4: Stoichiometry

Section: Chapter Questions

Problem 4.87PAE

See similar textbooks

Similar questions

Without consulting your textbook, list and explain the main postulates of the kinetic molecular theory for gases. How do these postulates help us account for the following bulk properties of a gas: the pressure of the gas and why the pressure of the gas increases with increased temperature; the fact that a gas tills its entire container; and the fact that the volume of a given sample of gas increases as its temperature is increased.
What mass of solid NaOH (97.0% NaOH by mass) is required to prepare 1.00 L of a 10.0% solution of NaOH by mass? The density of the 10.0% solution is 1.109 g/mL.
The present average concentration (mass percent) of magnesium ions in seawater is 0.13%. A chemistry textbook estimates that if 1.00 × 108 tons Mg were taken out of the sea each year, it would take one million years for the Mg concentration to drop to 0.12%. Do sufficient calculations to either verify or refute this statement. Assume that Earth is a sphere with a diameter of 8000 mi, 67% of which is covered by oceans to a depth of 1 mi, and that no Mg is washed back into the oceans at any time.
hat do the coefficients of a balanced chemical equation tell us about the proportions in which atoms and molecules react on an individual (microscopic) basis?
Assume that the radius of Earth is 6400 km, the crust is 50. km thick, the density of the crust is 3.5 g/cm3, and 25.7% of the crust is silicon by mass. Calculate the total mass of silicon in the crust of Earth.
Write a chemical equation representing the decomposition of water into two gaseous products. What are the products?
Many cereals are made with high moisture content so that the cereal can be formed into various shapes before it is dried. A cereal product containing 58% H2O by mass is produced at the rate of 1000. kg/h. What mass of water must be evaporated per hour if the final product contains only 20.% water?
Consider the iron alloy described in Question 19. Suppose it is desired to prepare 1.00 kg of this alloy, what mass of each component would be necessary?
Complete and balance the equations of the following reactions, each of which could be used to remove hydrogen sulfide from natural gas: (a) Ca(OH)2(s)+H2S(g) (b) Na2CO3(aq)+H2S(g)
What is the mass of fish, in kilograms, that one would have to consume to obtain a fatal dose of mercury, if the fish contains 30 parts per million of mercury by weight? (Assume that all the mercury from the fish ends up as mercury (II) chloride in the body and that a fatal dose is 0.20 g of HgCl2.) How many pounds of fish is this?
The units of parts per million (ppm) and parts per billion (ppb) are commonly used by environmental chemists. In general, 1 ppm means 1 part of solute for every 106 parts of solution. Mathematically, by mass: ppm=gsolutegsolution=mgsolutekgsolution In the case of very dilute aqueous solutions, a concentration of 1.0 ppm is equal to 1.0 g of solute per 1.0 mL, which equals 1.0 g solution. Parts per billion is defined in a similar fashion. Calculate the molarity of each of the following aqueous solutions. a. 5.0 ppb Hg in H2O b. 1.0 ppb CHCl3 in H2O c. 10.0 ppm As in H2O d. 0.10 ppm DDT (C14H9Cl5) in H2O

Recommended textbooks for you

Chemistry for Engineering Students

Chemistry

ISBN:

9781337398909

Author:

Lawrence S. Brown, Tom Holme

Publisher:

Cengage Learning

Chemistry: An Atoms First Approach

Chemistry

ISBN:

9781305079243

Author:

Steven S. Zumdahl, Susan A. Zumdahl

Publisher:

Cengage Learning

Chemistry

ISBN:

9781305957404

Author:

Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Chemistry for Engineering Students

Chemistry

ISBN:

9781337398909

Author:

Lawrence S. Brown, Tom Holme

Publisher:

Cengage Learning

Chemistry: An Atoms First Approach

Chemistry

ISBN:

9781305079243

Author:

Steven S. Zumdahl, Susan A. Zumdahl

Publisher:

Cengage Learning

Chemistry

ISBN:

9781305957404

Author:

Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Chemistry

ISBN:

9781133611097

Author:

Steven S. Zumdahl

Publisher:

Cengage Learning

Living By Chemistry: First Edition Textbook

Chemistry

ISBN:

9781559539418

Author:

Angelica Stacy

Publisher:

MAC HIGHER

Introductory Chemistry: A Foundation

Chemistry

ISBN:

9781337399425

Author:

Steven S. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS