State the difference between triggering thyristor in R circuit and triggering thyristor in RC circuit.

Q: a Ix A,079( 2Vx 12 be HE 10 I3 I2 -jia I4 jia 12 2Ix Vx I1 e all

A:

Q: A capacitor is made with a dielectric layer of mylar film that is 12μm thick. The effective area of ...

A:

Q: From the circuit below solve for the current of D1 and D2 as practical diode.

A:

Q: A charge located at the origin in free space produces a fields for which Ez=2kV/m at point P(-2, 4, ...

A:

Q: Explain the difference between transformer equivalent circuit and IM equivalent circuit.

A: Equivalent circuit- An equivalent circuit is a simplified circuit (or model) that is easier to analy...

Q: design a circuit for a digital lock that unlocks for all the even numbers put in as a 4-bit input.

A: As per our guidelines we are supposed to be answer the first question only. Kindly repost the other ...

Q: Which of the following is true about the collector current? it approximately equals the emitter curr...

A:

Q: Theoretical calculations: 5. How does the bandwidth change in relation to increasing signal amplitud...

A: Bandwidth: It is the range of the frequency in which the signal has some information. It is measured...

Q: Determine the capacitor size in micro farad necessary to increase the power factor by 20% if the loa...

A: The solution is given below 

Q: 3. How dose the bandwidth change in relation to increasing signal amplitude? FM

A:

Q: which of the following does not increase resistance.

A:

Q: 1. Differentiate DC and AC voltage sources in terms of a) value of voltage, b) direction of current ...

A: Given: We need to differentiate between AC and DC voltage in terms of value of voltage,direction of ...

Q: How are: a)  FM signal is generated b) PM signal is generated c) Angle Modulated signal is demodu...

A: Signals- Signals are information of variation one variable/parameter depending on another variable. ...

Q: a) Set up the supernode equation b) Set up the supernode auxiliary equation. c) Set up the equation ...

A:

Q: Use R1 = 330Ω, R2 = R3 = 1kΩ Construct the circuit below using Proteus Simulation Software and meas...

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: 3. Find Pa, the average power absorbed by the 4-2 resistor c absorbed by the same elements due to vw...

A:

Q: 5- prove that z transform of nu(n) zl>1 - 1)? z sin(a) 2- 22 cos(a) +1 sin(an)u(n) z|>1

A:

Q: Theoretical calculations: 3. How dose the bandwidth change in relation to increasing signal amplitud...

A: Bandwidth of the signal : There are mainly two type of Bandwidth of any signal that are the passband...

Q: 3. When the bandwidth of x(t) is Qn , find the bandwidth of x²(t).

A:

Q: Using only source transformation and without eliminating ix, reduce the circuit in Figure to a singl...

A:

Q: E,(s) of the electrical system. E¡ (s) Obtain the transfer function R2 ww R R ww R2 R2 ww

A: As per company guidelines, we are supposed to answer the first 3 subparts of the question. Kindly re...

Q: 24. For the network of Fig. 7.96, determine: a. VG. b. VGS, and Ipe o 20 V c. Ip. d. IB. e. Vp. f. V...

A:

Q: 4. Show that for all R>0, C>0, and w>0, the power factor of a series RC circuit and of a parallel RC...

A: Power factor: It tells how much active power is utilized by the circuit from the apparent power.    

Q: A Y-connected, 3-phase, 50 Hz, 6-pole, slip ring induction motor has following data: Rating: 400 ...

A: Given Rs=0.08 Ω,   Rr'=0.1 Ω,   Xs=Xr'=0.3 Ω J=10Kg·m2 N=960 rpm P= 50 kW f=50 Hz

Q: 5. Indicate how a NAND gate can be used to implement: (a) Inverter or NOT Gate

A:

Q: What are the types of FM?

A:

Q: What is the need for modulation? Justify with examples.

A: MODULATION: Modulation is critical branches of electronics science that is widely used in communicat...

Q: 1- Explain the operation of the PCM encoder used in module ED-2960F. 2- Discuss the advantages and d...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: Note: Value of X=1. Value of Y=3 For the circuit in the figure, set up the supernode equation, the a...

A: In this question,  We need to write the node voltage equation,  Here 3 nodes are consist.  One node ...

Q: Theoretical calculations: 3. How dose the bandwidth change in relation to increasing signal amplitud...

A:

Q: 3. For the power system shown, find short circuit level and short circuit current at the F1 & F2 poi...

A:

Q: What do you mean by over modulation?

A:

Q: 5. Three alternating currents are given by i, = 141 sin(wt + 45°); iz = 30 sin (wt + 90°); iz = 20 s...

A:

Q: Determine the capacitor size in micro farad necessary to increase the power factor by 20% if P1 and ...

A:

Q: K Q3: For the unity feedback system with G(s)= (s+3)(s² +4s+5) Do the following: a). Find the locati...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts f...

Q: Draw a plc ladder diagram for blinking lights with timer (1 second interval), start and stop button

A: To draw plc ladder diagram

Q: For the combinational op-amp circuit A. Identify the connection/application of each op-amp: A1, A2,...

A:

Q: defined by -2 n< -4 -4 <n<1 4 g[n] = 1sn

A:

Q: *25. For the combination network of Fig. 7.97, determine: a. VB and VG- b. VE. p16 V c. IE, Ic, and ...

A:

Q: 3. How dose the bandwidth change in relation to increasing signal amplitude? FM

A: Brief description: Frequency modulation is one of the modulation technique which is the class of ang...

Q: loaded zener regulator, has the following parameters: Vin= 16V; the ener rated voltage 10V, series r...

A:

Q: 3. How dose the bandwidth change in relation to increasing signal amplitude? FM

A:

Q: Fig. 7.48(c), with Ve = 5 V and R, = 3 k2. The transistor has V, = 1 V and k, = 2 mA/V. What bias cu...

A: We need to find percentage change in drain current for given circuit

Q: Theoretical calculations: 3. How dose the bandwidth change in relation to increasing signal amplitud...

A: Let Am be the signal amplitude Δf be the frequency deviation  fm be the signal frequency  β be the m...

Q: ) The switch is opened, so the output voltage increases. What is the time constant that describes ne...

A:

Q: What is the approximate voltage amplitude and frequency of the waveform below? Trig Vertical Pos Hor...

A:

Q: When a resonant circuit has delivered power of 50W. Determine the power in the cutoff frequency. Ch...

A:

Q: The Laplace inverse for the following * equation is equal to T2 C(s) = + - T. sti

A: Given equation, Cs=Ts2+T2s-T2s+1T

Q: Explain in detail about current harmonics.

A: The harmonics are the current of the voltage waveform that have the frequencies in the multiple of t...

Q: Determine the following when it is subjected to a waveform shown below: a) The first five non-zero t...

A: Given the circuit, as shown below: Given the input signal as shown below: a) We need to determine ...

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.