Answered: Solve completely the given circuit…

Solve completely the given circuit below by applying two ac theorems discussed. , mesh analysis, and solve for the individual current and voltage drops.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.6P: (a) Transform v(t)=75cos(377t15) to phasor form. Comment on whether =377 appears in your answer. (b)...

See similar textbooks

Related questions

Q: Example-3: Determine the transfer function C/R for the block diagram Ha R G2 G3 H a G4

Q: QI. The figure below shows a one line diagram of a three-phase power network in which a load of 1.5 ...

A: given transformer 33/11 kV voltage at 33 kV side is maintained at 33.6 kV Hence voltage at 11 kV sid...

Q: I loved the film. It was fantastic

A: It is given that: I loved the film. It was________________.

Q: rotary variable transformer has following spec +-70degree linearity Error+-2.0% of full range. sens...

Q: Question 1: Explain the structure and the operation principle of one phase motors. Question 2: Why d...

A: It is asked to explain the structure and operation principle of one phase motors. Since no other spe...

Q: ) fit) in Fourier series in the interva) (-2, 2) when fct) = -2st <o %3D 1

Q: 1. Assume that a set of currents given by the equations below will be applied to the stator containi...

A: Here is your answer! I hope this will help you.

Q: (4-j5) (12+j11)

Q: Derive a Boolean expression for the following circuit. A X C

A: Given boolean circuit,

Q: the morning, the student plugs in a computer (240 W) to study physics, a microwave (800 W) to make b...

Q: The parallel plates have an area of 2000 cmz and are separated at 1.00 cm apart. The original potent...

A: Note: As per the guide lines of the bartleby we are supposed to solve 3 questions, when they are i...

Q: In the following circuit : Vout=2.8 V R| +1 Vo W 22 kM 22 kN R2 +1.8 VoW oVOUT 22 kN Select one: Tru...

Q: 6.Given the circuit below, use Kirchoffs Voltage and Current Law to solve I1, l2 3Ω 42 40V 452 64V 2...

Q: Why a diode act like an open circuit? In which circumstances this occur?

Q: 13 Obtain Fourier series where f0 = of period 2t for $c ), -下SYくO メ oく*くて

Q: find the transfer function model G(s) = Vo(s) / Vi(s) of a circuit if an input voltage vi(t) is plac...

Q: Answer the following. Use a detailed explanation. In clamping circuit, what is the value of the sum...

A: The upper or lower extremity of a waveform is clamped to a set DC voltage level by a clamping circui...

Q: A coil of resistance 20 ohms and inductance 200 microHenry is in parallel with a variable capacitor....

Q: The discrete time periodic signal has (2, 0, 0, 1} samples. The frequency domain samples of the give...

Q: In the figure, a 469.695 volts source delivers 46.9695 kVA at a power factor 0.953236 inductive thro...

Q: Theoretical Calculations: 1. What is the polarity of the input voltage Uin compared with the output ...

Q: A power conversion system having an impulse response h[n]={1,-1} accepts the input x[n]={1,-2,2, 1,3...

Q: 2. Find the frequency of an ac current when its period is (a) 0.01 s, (b) 0.03 ms, and (c) 0.006 ms.

Q: The value of Qe supplied by the generator for the specification E = 1.53 p.u, V = 1 p.u, 80 = 21.5, ...

A: Given, Generated voltage, E = 1.53 pu Terminal voltage, V = 1 pu Load angle, δ=21.5° Synchronous rea...

Q: electric units a & b are connected in parallel and its rms current is 15A. If the current in b lags ...

A: The solution is given below

Q: An R-L load connected to 250V supply is consuming 1.5kW. When a capacitor is connected parallel to t...

Q: Q10/ At room temperature (300 K) with the Fermi level located exactly in the middle of the bandgap, ...

Q: A polarity test is performed upon a 7,620/230-Volt transformer. If the input voltage is 220 Volts, ...

A: In the given question, we have a transformer having the voltages as; Primary voltage, VP=7620V Secon...

Q: Given an analog filter Ha(s) = designed from H«(s) by many-one mapping method, assuming sampling per...

Q: An RTD has R=D159 Q at -80C, what is the sensor resistor at 86 °C, let a = 1 x 10-4°C.

Q: ? She is very young. How is she

A: The given sentence is shown below: She is very young.How ........ is she?

Q: Consider a silicon pn junction at T 300 K. Assume the doping concentration in the n region is 1020 c...

Q: Impedances Z2 and Z3 in parallel are in series with impedance Z1 across a 100 V, 50 Hz ac supply. Z1...

A: Given Z1=6.25+j1.25Z2=5+j10Z3=5-jXc

Q: Question # 01: Apply the knowledge gained from the ac analysis of BJT to construct the AC equivalent...

A: Solve the first question, unless the student has asked for a specific question to be solved, subject...

Q: What value of capacitor is needed to compensate the reactive power of 1.5 kVAr fed by 230V, 50HZ АЗ ...

Q: Example:find the current through the 10 ohm resistor.

Q: Q1. A certain material has a conductivity of 5 x 10s/m and a permittivity of 5F/m. A total charge of...

A: We need to find surface charge density for given sphere at given time .

Q: 100KR

Q: An FM signal expressed as S(t)-1000cos[2*z*10°t+0.5cos(2* x*10*t)] is measured in an 50 N antenna. D...

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part y...

Q: Q1: a- Compute the voltage gain Gy and then the output voltage Vut for the inverting op amp circuit ...

A: Given inverting opamp with two different inputs. To calculate voltage gain Gv=Vo/Vin of inverting op...

Q: FIND THE VALUES INDICATED AND SHOW THE COMPLETE SOLUTION. Phase Angle Instantaneous Value RMS Averag...

Q: AL= JOL X, = Inductive Reactance w = Angular Frequency f = Frequency L = Inductance i = Imaginary un...

A: Problem 1 : An inductor of inductance 6 mH is connected with a supply voltage of 220 V 50 Hz supply ...

Q: 10. Given the characteristics of Fig. 9.78, sketch: a. The normalized gain. b. The normalized dB gai...

A: The given characteristic graph is shown below,

Q: In the following circuit : Vout=2.8 V R R1 +1 Vo W 22 kM 22 kM R2 +1.8 VoW 22 kN o VOUT Select one: ...

Q: FiND Vab: 152 ZA Vab 102

A: Using current division rule find the currents I1 and I2. Using kvl in right loop find the voltage Va...

Q: Q1. A) For the following system shown below: (s + 2)(s - 4) s2(s + 3)(s + 5) RS) Find: 1) Forward tr...

Q: (s+0.5)2+4 H(z) Iš designed from H«(s) by many-one mapping method, assuming sampling period T. Then,...

Q: 4. What is the polarity of the input voltage Uin compared with the output voltage Uout in Non-invert...

Q: 22. Most loads are either inductive or capacitive, which of the following is not reactive in nature?...

A: 22. Most loads are either inductive or capacitive, the load which is not reactive in nature are ligh...

Q: FIND THE VALUES INDICATED AND SHOW THE COMPLETE SOLUTION. RMS Phase Angle Peak Instantaneous Average...

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

Solve completely the given circuit below by applying two ac theorems
discussed.
mesh analysis,
and solve for the individual current and voltage
drops.
z,
Z3
1840° V
Given Z1 = 8+j8 2, Z = 6-j 10 2, Z3 = 8-j102 and Z, = 65+i120. V2= 30/-60°,
%3D

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

(a) Transform v(t)=75cos(377t15) to phasor form. Comment on whether =377 appears in your answer. (b) Transform V=5010 to instantaneous form. Assume that =377. (c) Add the two sinusoidal functions a(t) and b(t) of the same frequency given as follows: a(t)=A2cos(t+) and b(t)=B2cos(t+). Use phasor methods and obtain the resultant c(t). Does the resultant have the same frequency?
Three impedance Za= (3+j4) ohms, Zc= (4-j4) ohms and Zr=0+j3 ohms are connected in parallel. Solve for the pf of the combination.
DC-AC Circuits Express R1 using Rx, Ry, and Rz when performing wye to delta conversion R3 Rx Rz R2 R1 Ry O A. (Rx+Ry)(Ry+Rz)(Rx+Rz) Rx В. RyRz Rx+Ry+Rz O C. Ry+Rz RXRYRZ O D. RXRYRZ Ry+Rz OE. RxRy+RyRz+RXRZ Rx
2, Zs Z7 Solve for: Solve for: h.) S5 i.) P6 j.) Q7 Given: E = 1002 – 90 volts Z4 = 42450 Z1 = 1200 Z5 = 5453.13N Z2 = 2436.87N Z6 = 62 – 90N Z3 = 32 - 30N Z, = 72750
The picture shows three LC circuits, two of them with capacitors of capacitance C and the three with coils of inductance L, the three circuits are coupled by means of two capacitors Cc capacitors.L inductance coils, the three circuits are coupled by means of two capacitors of capacitance Cc. The currentscirculating through each mesh are those indicated in the figure: I1, I2 and I3. Using Kirchhoff's law for voltagesand taking into account the definition of current I = -dQ/dt, find the system of coupled equations for the systemand then find the angular normal frequencies of the system.
Three impedances, Z1 =10020.Q, Z2 =63.2518.43.2 and Z3 =1002-90•Q are connected in star. Convert the star to an equivalent delta connection. And draw the star network and also the equivalent of delta connection
Figure 2 shows three "LC" circuits, two of them with capacitance capacitors "C" and the three with inductance coils "L", the three circuits are coupled by means of two capacitance capacitors "Cc". The currents that circulate through each mesh are those indicated in the figure: "I1", "I2" and "I3". Using Kirchhoff's law for voltages and taking into account the definition of current I = −dQ / dt, find the system of coupled equations of the system and then find the normal angular frequencies of the system.
A) find Ztot in rectangular form B) find Ztot in polar form C) find V1 or VL in polar for. ( use voltage divider rule or ohm law).
Solve the power triangle at Z6 in the circuit diagram below.V1, V2, and V3 = 220∠0°, 50 HzZ1 = 7+j8 ohmsZ2 = 6+j3 ohmsZ3 = 5+j5 ohmsZ4 = 2+j3 ohmsZ5 = 8+j4 ohmsZ6 = 1+j9 ohms
H.W 2 An AC circuit includes two sections AB and BC in series. The section AB consists of two branches in parallel. The first of these is formed of resistance of 60 2 in series with a capacitor of 50 mF, while the second consists of a resistance of 60 2 having an inductance of 250 mH. The section BC consists of a resistance of 100 N having an inductance of 300 mH. The frequency of the current is 50 Hz. The voltage across section AB is 500 V. What is the voltage across the section BC?
4- A Circuit of zero lagging power factor behaves as a. A capacitive circuit b. An inductive circuit c. RC circuit d. RL circuit
-The Vollage V= 100210°V is 62 pplied across a capacilive 1oad . The 1-a kes ap paraal' Power Load of 500VA teading Power fracl-or. The reaclance (xc) of load 's---- 7