Shown below, Baker spotted the three-component mixture onto a TLC plate and developed it using the solvent system listed. Using the Molecular View of the TLC plate provided: a) draw each molecule analyte (3 in total) in the correct position on the TLC plate, b) draw three (3) solvent molecules interacting with either the plate or the analytes, and c) for all molecules, clearly show the relevant intermolecular forces that explain the TLC results.

Shown below, Baker spotted the three-component mixture onto a TLC plate and developed it using the solvent system listed. Using the Molecular View of the TLC plate provided: a) draw each molecule analyte (3 in total) in the correct position on the TLC plate, b) draw three (3) solvent molecules interacting with either the plate or the analytes, and c) for all molecules, clearly show the relevant intermolecular forces that explain the TLC results.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter34: Miscellaneous Separation Methods

Section: Chapter Questions

Problem 34.2QAP

See similar textbooks

Similar questions

A spot of crude plant extract was placed on a glass plate coated with C18 silica gel. The chromatogram was developed using an appropriate solvent. The result is shown below. Which of the following spot is the most soluble in water? Choices: Spot C Spot M Spot E Spot H
A spot of crude plant extract was placed on a glass plate coated with C18 silica gel. The chromatogram was developed using an appropriate solvent. The result is shown below. Which of the following spot is the most soluble in water?
How can you use ion exchange Chromatography to de-ionize water? Please shortly answer at your own words. Answer should be to the point (specific 4-5 lines).
Consider a mixture of the compounds shown below dissolved in hexane (C,H14). CH3(CH2)10CH3 CH;COOH CH,CH2CH2OH CH3COCH,CH3 IV The mixture is separated using the TLC technique. The solvent used as mobile phase is benzene (a non polar solvent) and the plate used as stationary phase consists of a coat of silica (SiO»). Which compound will move faster? O II O IV
PAPER CHROMATOGRAPHY Additional details: 20mL distilled water + 20mL 95% ethyl alcohol solution was used Main Question: Give the inferences (by color) of the following spots in the picture below
How can you use ion exchange Chromatography to de-ionize water? Please shortly write at your own words. (4-5 lines maximum ).
4) If the classification of the chromatography run is a reverse-phase chromatography, discuss the relative polarities of caffeine, aspartame and benzoate.5) Given the data of the diet sodas, which one would you recommend to be the healthiest? (You may need to research the functions of caffeine, aspartame and benzoate. Please add references if necessary.)
A tea bag containing 15 grams of tea leaves with 0.7% of caffeine was used in solid-liquid extraction with 200ml of distilled water followed by liquid-liquid extraction using DCM. If 50.0mg of caffeine requires 10 ml of water and 3.0ml of DCM to be dissolved, how much caffeine can be extracted using 70.0ml of DCM? a. 4.8 x 10^-2 b. 5.7 x 10^-2 c. 3.8 x 10^-3 d. 5.8 x 10^-3
Column Chromatography Alumina Chromatography Mixture 9:1 Hexanes:Ether 8:2 Hexanes:Ether 1:1 Hexanes:Acetone Amount Used 3.962 g 0.143 g 9.50 mL 9.50 mL 11.00 mL Additional Observations (Color, etc.) BIU X₂ X² → BI IU X₂ X² → BI IU X₂ X² → BI IU X₂ X² → BIU X₂ X² →
(2) Sally starts eluting her column with petroleum ether in hopes of separating her 50:50 ferrocene: fluorenone mixture. She notices her mobile phase getting low when there is limited separation between her two components. She eagerly adds more solvent to avoid her column from drying out. Sally then realizes she poured from her 1:1 petroleum ether: diethyl ether beaker rather than her petroleum ether beaker. (a) Using the molecular view below, explain how this would impact her product elution from the column. top of column H buret wall AI H H H H H H H H H H bottom of column buret wall (b) How does this error impact her experimental results? (c) Using pictures and words, how could Sally analyze the purity of her product? Fe
what are key reactions involved in seperation of liquid mixtures by simple and fractional distillation and gas chromatography? chemicals used: 10ml 1:1 mixture of ethyl and butyl acetate techniques: simple and fractional distillation, gas chromatography. target molecules: Ethyl acetate C4H8O2 Butyl acetate C6H12O2
10g coffee 4g sodium carbonate 40m dichloromethane 160ml distilled water coffee filter What are the principles behind caffeine being extracted from coffee using the above items? 1st sodium carbonate mixed with coffee then brought to a boil for 20min then solution/grinds are filtered. Then solution is added to a separatory funnel with 15ml of dichloromethane and two layers are observed so the bottom layer with DCM contains the caffeine, then this layer is collected in a beaker and dried out using molecular seeds. Then the solvent is brought to a boil with crude caffeine remaining and recystallized using 95% ethanol and brought to a boil again. Then the contents are vaccum filtered and allowed to dry resulting in 30mg caffeine.