Show your work. 2. An experiment was carried out in which the volume of a quantity of helium gas was measured at several temperatures and constant pressure. Plot this information using Excel graph and determine the following: a. The equation of the line b. The R square value c. The mathematical equation supported by this data Volume (L) Temperature (K) 200 8.0 12 16 20 24 300 400 500 600

Q: The step-acration activated-sludge system  is to be analyzed as a series of continuous-flow…

A:

Q: DRAW 2D SCHEMATIC WITH A DETAIL A first order irreversible reaction is conducted in an 800 L…

A: A first-order irreversible reaction is conducted in a continuous stirred tank…

Q: Can you answer the last part please

A:

Q: A gas is heated (or cooled) at constant volume from 98 degrees Celsius  to 57 degrees Celsius .…

A: The objective of the question is to find the final gauge pressure of a gas that is cooled at…

Q: The following three dialysis units are set up to purify urea from the raffinate stream. For these…

A: The following parameters are given,,Total area, Permeability, Number of stages for scenario 1,

Q: 1. [Flow equalisation, effect of equalisation on BOD mass loading rate]. Consider the volumet…

A:

Q: Q2/ A-For zero slip condition ,show that: AP! ΔΡΙ V VX = =(1-x)+x² By assuming that Cm Cn where C is…

A: A zero slip condition is given.Assumption is made that :,where, is two phase friction factor,and is…

Q: A 1000 micrometer water droplet falling through ambient air which contains 5micrometer particle with…

A: It is given that: water-droplet falling through ambient air.Particle size, Density

Q: onvert the following- A molar flowrate of 2600 ???? ℎ?−1 to a mass flowrate in ?? ℎ?−1 , assuming…

A: Defi

Q: B: Samples collected from industrial wastewater with (500 ml) at nine o'clock, expected to contain…

A: Given Data:characteristicsSulfatephosphorusLength of the light path in the sample5544The…

Q: pressure drop in an ion in depth) and bed for turbulent flow water through the bed? The bed is made…

A: Given Data:

Q: Two moles of an equimolar mixture of CO and H₂O (i.e., on ne mole of water vapor) is placed in an…

A:

Q: -63. Equation describen flow of Compressibe fruid (real gas) Steady state flow which requires that…

A:

Q: Water with density 1000 kg/m³ and viscosity 1.0 x 10-3 kg/(m.s) is flowing at a constant average…

A: Given,The  density of the water is, The viscosity of the water is, The average velocity of the water…

Q: i. Determine the mass (in g) of 1 m3 ethylene glycol at 1150 K and 70 bar. Use the Nelson-Obert…

A:

Q: Q3: Derive the transfer functions H₁(s)/Q(s) and H₂(s)/Q(s) for the liquid level system shown in…

A: Liquid level system is given as shown below,

Q: (b) (c) Page 5 of 6 Calculate the gain, in percent transmitter output (%TO) per variable unit…

A:

Q: Simulate the time response of p’(t) for each controller mode i.e., parallel PID controller with…

A:

Q: A feedback control system has the following open-loop transfer function: 0.5Kce-3s 10s +1 (a) GOL…

A:

Q: Current Attempt in Progress a large supply line carrying A rigid tank whose volume is 0.5 m³,…

A:

Q: i) ii) What effects will this unique lipid structure have on the rigidity, density, and fluidity of…

A: A structure of one of the lipids of anammoxosome is given and ladderane structure is…

Q: * Your answer is incorrect. A rigid tank whose volume is 4 m³, initially containing air at 1 bar,…

A:

Q: Milk is pasteurized if it is heated to 63°C for 30 min, but if it is heated to 74°C it only needs 15…

A: The given data:

Q: Methane gas is compressed to 40 bar and precooled to 280 K. The expander and throttle exhaust to a…

A: It is given that,methane is compressed at temperature,  and pressure, throttle exhaust pressure,,

Q: The motion of a damped spring-mass system as give is described by the following ordinary…

A: Given data: The mass (m) = 10 kgThe damping coefficient (c)=200 N s/mThe spring constant k = 15 N /…

Q: An industrial cold room has four 200 mm thick walls made of concrete. The walls are insulated on the…

A: The objective of the question is to determine the heat energy gained per hour through all 4 walls of…

Q: For a basis of 100 moles of Aromatics, the component balance for benzene can be written: ? = 0.05F +…

A:

Q: Q.2: The combustion analysis using ORSAT apparatus, where the analysis indicated as 15% CO2, and…

A: Given data:In the dry stack gas, the composition of CO2 is 15 %.The fuel is C4H9OH.

Q: Q19: It is defined as a component in the plant cycle that consists of a closed vessel that uses the…

A: A boiler is a closed vessel that uses combustion heat to turn water into steam or hot water. This…

Q: Four process units are in the plant. The units have FARS of 1, 0.5, 3, and 5, respectively. i) What…

A: Given data:Number of process units: 4The units have FARs of 1, 0.5, 3, and 5.

Q: Consider the level control loop shown in Figure Q3 below. The steady state operating conditions are…

A: Level control loop is given with inlet low rate, Fi(t) and outlet flow rate, Fo(t). There is a level…

Q: Demonstrate the process of manufacturing of portland cement.

A: The objective of the question is to explain the process of manufacturing Portland cement, which is…

Q: You wish to separate two proteins, A and B, using precipitation with ammonium sulfate. Protein A has…

A: Two proteins A and B are given and are separated using precipitation with ammonium…

Q: Problem 1 (50%) Two empty tanks of the same size (Area = 5m², Height = 10 m) are arranged as shown…

A:

Q: A gas mixture of 25% CO, 55% H₂ and 20% N₂ is fed to a reactor where methanol gas phase synthesis is…

A: Reaction,Composition,Data,

Q: With reference to the P-x-y phase diagram in Figure 2.1 below, consider the following experiment:…

A: The objective of the question is to understand the phase changes that occur when methanol is added…

Q: A first order irreversible reaction is conducted in an 800 L continuously stirred tank, in liquid…

A: A first-order irreversible reaction is conducted in a continuous stirred tank…

Q: Calculate the mass reduction (in kilograms) attained if aluminum (density = 2.70 Mg/m³) is used in…

A:

Q: 2. 100 mol/hr of an ethanol/H₂O mixture containing 10 mol% ethanol is to be produced as the liquid…

A:

Q: 1. [Flow equalisation, effect of equalisation on BOD mass loading rate]. Consider the volumetric…

A:

Q: you can do the assumptions in Required data or values  The goal of this question is to see the steps…

A: The objective of this question is to conduct an energy balance for the stages of the wheat starch…

Q: A fluid with a density of 2 slug/ft3 flows steadily between two stationary flat plates as shown in…

A: The objective of the question is to determine the normal stress throughout the fluid using the x and…

Q: 6) 1) check the dimensionless homogeneity of the following 2g (Pm-P)z P U= where, u-velocity,…

A: The homogeneity of the given expression for velocity  can be checked by verifying that all the terms…

Q: 03:0.75 lbm/min of C3H8 is burned at 77 °F with 150 percent excess air that enters the furnace at 40…

A:

Q: Write the oxide composition limits of OPC and explain their necessity

A: The objective of the question is to understand the oxide composition limits of Ordinary Portland…

Q: P.9 Assume that a sealed vessel at constant pressure of 1 bar initially contains 2.00 mol of NO₂(g).…

A:

Q: Complete the question by hand calculation(please show every step):- Do the mass balance and energy…

A: The following syngas gas conditions and composition are givenComponent Composition (mol%)Carbon…

Q: N-Ti Temperature C 3500 3000 2500 2000 1670°C? (STI) 1500- 1000- 500 882°C 0 Ti 10 L 14.0 (aTi) 20…

A: A phase diagram for N-Ti is given.There are four phases given, that are,L

Q: a. The aromatics are analysed and found to contain 33.2 mol% pseudocumene, 1 mol% diphenyl, 20 mol%…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: Q4. In the mid-nineteenth century the entomologist Henri Fabre noted that French ants (garden…

A: Given data:u150160230295370T1316222428