• Show the voltage waveforms across each half of the secondary winding and across RL. • Find the average value of the full-wave rectified voltage in Figure. 120 Vrms ellle 4:1 allile D₁ D₂ www.li R₁ 1.0 ΚΩ
Q: A 100-KVA, 20/5 KV transformer has an equivalent impedance of 10%. Calculate the impedance (in…
A: It is given that: S=100 kVA=0.1 MVAV1V2=200kV5kVZpu=10%=0.1
Q: The following figure represents Host computer Machine PLC a. A machine control system example None…
A: Human machine interface or HMI connects a machine to a device or host. PLC is programmable logic…
Q: FIND THE TOTAL VOLTAGE OF THE CCT. 32 AMER IA 32 2.R 4/2 Le 2.2 22
A:
Q: 9. What is the purpose of companding? a. it is used to protect the lower frequency signals from…
A:
Q: An ac voltage source of V max = 120 V is rectified using a half-wave rectifier circuit, using the…
A: A Half- wave rectifier circuit works on the basic principle of " When a standard AC signal is passed…
Q: 46. An ac voltage source of V max = 120 V is rectified using a full-wave bridge rectifier circuit,…
A:
Q: A transformer has a rated output of 200 kVA at a power factor of 0.8. Determine the rated power…
A: In this question we will find transformer rated power output and reactive power....
Q: a) Design 5th-order low-pass FIR filter with cut-off frequency we using the rectangular window. b)…
A: Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: Write a Matlab code to sketch using plot function, y(t)=3 sin(t) for 3 periods
A: The required Matlab code can be written with help of a predefined sine function. In order to plot…
Q: 13) The transfer function of a system is given as 81/ (s^2 + 16s +81). Find the undamped natural…
A:
Q: In an ideal op-amp, which is not true?
A: The correct option along with the explanation has been provided in the following section.
Q: 1. A cylindrical capacitor is formed using two different circular metal plates and a dielectric…
A: Given parameters: A parallel plate capacitor with two circular plates Dielectric constant, k For…
Q: A single phase circuit with a given load 3 ohm resistance and inductive reactance of 4 ohms as…
A: The question is about active power, reactive power and apparent power, power factor.
Q: FIND THE LAPLACE TRANSFORM A.) f(t) =e^-2t u(t) B. f(t) = e^3t u(t) C f(t) = 2 s(t)
A:
Q: The speed of a 100 MW alternator drops by 4% from no load to full load. (a) Find the speed…
A: We have an alternator with, Rating = 100 MW Speed drops from no load to full load = 4% From this…
Q: Calculate the electric and magnetic fields produced by the radiation coming from 200W bulb at a…
A:
Q: 3. The ideal cycle time of an assembly machine is 4 sec. The parts feeder at one of the workstations…
A:
Q: 3. (a) Consider buck-boost converter with the following parameters: Vin=40 V, Vo =60 V, R=20 , and…
A:
Q: A generator is protected by restricted earth fault protection. The generator ratings are 13.2 kV, 10…
A: We have an generator which is protected by restricted earth fault protection. Given Data, VL = 13.2…
Q: An 8 pole, 3-phase induction motor is connected to 60 Hz supply. If it is running at 820 r.p.m. find…
A: We have an 3-phase induction motor with, Pole = 8 Frequency (F) = 60 Hz Rotor Speed (Nr) = 820…
Q: 1. The condition to use the simplified model is R network >> r av, and E network >> V k OR network…
A: The diode can be replaced with an equivalent model in order to make the analysis simpler. Based on…
Q: 7. ★★★ (a) Show that the equivalent inductance of two more inductors can be calculated as follows:…
A:
Q: Find Vout 10 ohms SVMM 100 ohms + • Vout
A:
Q: 19. Calculate the average power supplied by the source as shown below. + 2Ω www 60 V 3Ω 8Ω 0000 w 4Ω…
A:
Q: An impedance load consisting of 12 ohms resistance and 16 ohms inductance reactance is connected…
A:
Q: 12. This transformer 13. a. b. C. d. low-voltage transformer step-up transformer step-down…
A: Given data, Primary voltage Vp=120 V Number of turns in primary Np=100 Number of turns in secondary…
Q: In the figure, a particle moves along a circle in a region of uniform magnetic field of magnitude B…
A: It is given that: B=4.4 mTF=3.2×10-15 Nq=1.6×10-19 C
Q: A projectile is fired with initial velocity 95 m/s at an angle of 50 degrees from the horizontal.…
A: Step-1--> we have initial velocity(u)=95 sin(50degree)m/s time(t)=5 sec
Q: Q3. Use Laplace transform to solve the following differential equation y' - 2y = 4 ) y(0) = 1
A: Given, Differential equation y'-2y=4y0=1
Q: An alternating voltage is given by v=282.8 sin 314 t volts. Find (a) the RMS voltage, (b) the…
A: Given that Alternating voltage=282.8 sin(314)t voltsFrequency=314Peak voltage=282.8We have to find…
Q: 13) The transfer function of a system is given as 81/ (s^2 + 16s +81). Find the undamped natural…
A:
Q: You must design a circuit for a light emitting diode. The circuit must be powered by a 3.3V power…
A:
Q: a) An n-type extrinsic semiconductor is formed by the deliberate addition of a small number of…
A: For the given question, we have to explain that, why at room temperature, deliberate addition of a…
Q: Multi-Source Circuit Analysis 3 Consider the circuit shown with the following parameters: 4₁ = 10 A…
A:
Q: 9. An electrical series circuit with resistance, inductive and capacitive reactance is shown below.…
A: Given:
Q: The figure below shows a simplified model of a cardiac defibrillator, a device used to resuscitate…
A: Given, The simplified model of a cardiac defibrillator is shown below, Here, When the switch S is…
Q: In the circuit given below, C = C1 = C2. Find the gain of the multiple-feedback band-pass filter
A: Given circuit,
Q: 7. ; Given the following transfer function for H(s) where it is under damped, for a unit step input…
A: In this question, We need to determine the time to reach first overshot peak i.e peak time Transfer…
Q: Find Vout
A: In this case, the output voltage of the following circuit is to be determined:
Q: Find F[e-t(sin wot)u(t)] Note: F.T(sin wot) = TU (8(w – wo) − 8(w + wo)) - - F.T(u(t))=π8 (w) +…
A: Given: signal s(t)=e-t(sinw0t)u(t) we have to compute Fourier transform of the above signal. It can…
Q: Q3) For the circuit shown below, Find the current in the resistor 692 using the Mesh method. Note:…
A: Given- Source voltages= 10 V and 5 V To find- Current in 6 ohm resistor=?
Q: Ex For the circuit shown below; if the input voltage is a sinusoidal wave, sinusoidal wave, find the…
A:
Q: B) 6-pole alternator running at 1000 r.p.m. supplies an 8- pole induction motor. What is the actual…
A: Given: Poles in alternator, Pa=6 Alternator speed, Nsalt=1000 rpm Poles in motor, Pm=8 Motor slip,…
Q: (c) A TV broadcast antenna transmits power of 3 kW at frequency of 200 MHz. The transmitter antenna…
A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…
Q: Answer the given problems. Submit your solution in pdf form. Activity no. 3. Combination of…
A:
Q: 3. Find total real power, reactive power and apparent power of the 3 phase load of figure 1. 4. The…
A: Since you have asked multiple questions in a single request, we will be answering only the 1st…
Q: Can you Briefly explain any four gaseous insulating materials.??
A: All gases are more or less insulators but air is the most important insulating material which is…
Q: i) A communications channel with a bandwidth of 4 MHz has a signal-to-noise ratio of 20 dB.…
A: Given: Bandwidth B=4 MHzSNRdB=20 dB
Q: LVDT is used for measuring the deflection of a bellows. The sensitivity of LVDT is 0 V/mm. The…
A: We have an LVDT that is used for measuring the deflection of a bellows. Given data, Sensitivity of…
Q: What is the value of Req? Req- 1Q 62 202 m 60 w
A: Given data, Given circuit diagram,
Step by step
Solved in 3 steps
- For figure (1)draw and calculate the voltages waveform across each half of secondary winding and across load when 100sin2π60t applied across the primary, then find PIV.please solve value of Capacitor with 0.1V Ripple. And draw output ripple waveform. Explain it one by one for me thanks..In the given circuit, a step down transformer with an RMS voltage as 110V /11-0-11 V is used with RL = 1 KO. Assume diode as Germanium and the input frequency is F= 50HZ. D, CT Vin RL D2 1- Name the given circuit. 2- Find The PIV. 3- Find Current trough load resistance. 4- Draw the Input and Output wave forms. all
- C5 What is the correct explanation for the voltage seen at Va in Figure C5? Va 1 Sost We will assume that the Vout Out Vb, capacitor is charged to a value determined by the feedback and the supply voltage +BVsat. Figure C5 A. The waveform on the capacitor looks like a discharge, and then a charging waveform to an equal but opposite magnitude voltage, B. The capacitor simply reverses its charge, with a charging waveform, C. The capacitor simply reverses its charge, with a discharging waveform, D. None of the above.A resistor R and a capacitor C are connected in series across a 400 V variable ac supply. When the frequency is 40 Hz, it draws 10 A current, and when the frequency is 50 Hz, it draws 15 A current. Find R and C.A sinusoidal voltage has a value of 100 volts at 2.5 milliseconds and completes one cycle.It takes 20 milliseconds. Then find the maximum cost and the time to reach it for the first time
- A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.Cascaded Wave Retarders. Show that two cascaded quarter-wave retarders with parallel fast axes are equivalent to a half-wave retarder. What is the result if the fast axes are orthogonal?Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
- A 5uF capacitor is connected across an emf of 50 Volts maximum value and frequency of 1000 cycles. What is the equation of the current?what is polyphasic Ac waveforms with diagramA capacitor in series with a 200 ohms resistor draws a current of 0.3 ampere from 120 volts, 60 hz source. What is the value of the capacitor in microfarad? a. 8.7 b. 9.7 c. 6.7 d. 7.7