Show the correct graph and Find the Q-point Values for the JFET network shown with voltage divider bias. Assume loss= 5mA and Vp=-4V. VDD +9 V www R₁ 10 ΜΩ R₂ 2.2 ΜΩ RD 4.7 ΚΩ Rs 3.3 ΚΩ

Q: Example1/ An open wire T-L with R=10 KQ/Km,L=3.7 mH/km, C-8.3x 10-9F/Km and G=0.4x 10-6U/Km, find…

A: The solution is given below

Q: 3- At full-load, the Cu and iron losses in a 100-kVA transformer are each equal to 2.5 kW. Find the…

A: Steps: Find the loading  percentage according to given load and full load. Then calculate cu loss…

Q: 1)For the above circuit, determine a) The value of a resistance Rv, so that there is maximum power…

A: The maximum power will transfer to the load only if the thevenin's equivalent resistance is equal to…

Q: Prepare a short list of the methods routinely employed for the characterization of the following…

A: Prepare a short list of the methods routinely employed for the characterization of the following…

Q: Draw the voltage vm as a function of time when Zo = Ro = 500 for figure shown 50Ω S3 个 502 Vs Vm…

A: In this question we need to draw Vm as a function of time

Q: A system is represented by the below transfer function: 3 G(s) = 2s² + 6s + 10 Sketch the Bode plot…

A: The transfer function of a system is given as Gs=32s2+6s+10.

Q: Two magnetized bars with intensity of Q =20 A•m and Q =10 A•m and (magnetic charges) at their north…

A: It is given that the two bar magnets are placed in parallel to each other  with there North and…

Q: Calculate the total energy and average power for the Y(t) signal shown below. Y(t)= 9, -12<t<12 5-t,…

A:

Q: 4. The last step is to let one bit f determine the function of an adder/subtractor output z+y iff 0…

A: Given                               x + y    if  f=0       Output =…

Q: Build a 16x4 encoder using two 8x3 encoders with enable.

A: The encoder is a digital electronic device which has 2n input lines, any one of them will be higher…

Q: 10/0° v w 452 W 852 um J252 9 ww 152 J³52 T ≤ IOR To 2/-90⁰ A 0 b Jon

A:

Q: Find the time domain expression v(f) for t>0 for the circuit shown in the below. Express answer with…

A: We redraw the given circuit into phasor domain

Q: 50) x y and z represent Boolean variables. If f = xy(z + 1) + xy, then one can simplify f So that f=…

A: We need to simplify the given Boolean expression

Q: (b) Using a synchronous binary counter as shown in Figure Q2(b), design and draw a counter to…

A: The synchronous counter is a electronic circuit which  is based on binary logic of signals. This is…

Q: A 600 kVA, 1-ph transformer has an efficiency of 92 % both at full- load and half-load at unity…

A: Given: Single phase transformer  Rating of transformer,  S = 600 KVA Efficiency = 92% at full load…

Q: A capacitive sensor in air measures 4.0 µF. It measures 10.0μF when placed in a non-conducting…

A: Given data, Capacitance in air, Ca=4.0 μF Capacitance in non-conducting liquid, Cl=10.0 μF

Q: EVALUATE EACH SIDE OF STOKE'S THEOREM FOR A REGION: 0<=p<=4 0<=<=2+ Z=0 If H= 3 pa

A:

Q: Q: RL-LPF, gives Vo=10v and Vin=30v, also Rs=R-10k, calculate the value of XL?

A: In this question we need to find a value of XL

Q: 11.40 In a balanced three-phase wye-wye system, the source is an abc-sequence set of voltages and…

A:

Q: Problem 3: Imagine you have a long straight wire running along the x- axis. Now imagine that…

A: According to the given information in the question, the diagram is shown below,

Q: Calculate the output voltage using the circuit below for resistor components of value Rf = 470 k…

A: The solution is given below

Q: OZ Draw S. F.G for the sys. shown in the figure below and fin Y/U + U A B +

A: In this question,   We need to determine the transfer function using Mason gain formula?  And draw…

Q: 2- Find the efficiency of a 150 kVA transformer at 25 % full load at 0.8 p.f. lag if the copper loss…

A:

Q: (b) Simplify the Boolean expression (5 + ac)(āb + c)(a+b) by Boolean algebra.

A:

Q: Determine the characteristic impedance of a transmission line which has a capacitance of 30pF/m and…

A:

Q: A 10kVA, 230 Volts, single phase generator has synchronous impedance of 0.5 + j1.2 ohms per phase.…

A: The solution is given below

Q: Step2 b) 16 14 12 10 Voltage (V) 8 6 4 2 0.5 1.0 Slope of 1 is 18.5 Slope of 2 is 9.05 Slope of 3 is…

A: I have not given this slope but I can give you the method how to calculate slope..Exact coordinates…

Q: Find the output voltage Vo in the circuit below. Μ 6 ΚΩ 12V 6 ΚΩ 6 ΚΩ 41₁ + 6 ΚΩ to 6 ΚΩ + το

A: The solution is given below

Q: The minimum voltage along a transmission line is 260 volts, while the maximum is 390 volts. The SWR…

A: SWR (standing wave ratio) It defines the mismatch on the line Also it defines as the measure of…

Q: A universal series motor has resistance of 20 22 and an inductance of 0.6 H. When connected to a 200…

A:

Q: The single-phase half-wave controlled rectifier supplies a resistive load draws a average current of…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: A committee of three decides questions by majority vote. Each member can press a button to signify a…

A: Switching devices are elements of a circuit that are turned on when closed and provide a path for a…

Q: What is the inductor current if VL is 500 sin(50t + 20°)? 5 sin(50t - 70°) 5 sin(50t + 20°) 5…

A:

Q: given a system whose impulse response h[n]=δ[n]-δ[n-2]. find its difference equation with input x[n]…

A: The solution is given below

Q: Find the Fourier Series Representation of f(eitheta) = 1/13-12 cos(theta

A:

Q: Consider a continuous-time system with input x(t) and output y(t) given by y(n) = 4x²(n-2) + 1. This…

A: In this question we need to choose a correct option

Q: Question 1 a. Using the step-invariant method, obtain the discretized form of the state equation for…

A: The minimum time control problem involves finding a control policy that will drive the system…

Q: what is the benefits in power system of defining vector group of 3 phase transformer. ..

A: Vector group: Vector groups provide information about the winding of the high voltage side and low…

Q: 3- At full-load, the Cu and iron losses in a 100-kVA transformer are each equal to 2.5 kW. Find the…

A: In this question we will find transformer efficiency at full load with given data...

Q: (a) What must be the charge (sign and magnitude) of a 1.45-g particle be for it to remain stationary…

A:

Q: Give the electrical network below: Vin 5 + R1 10k sig Q2 Q1 RL 10 Vout

A: Here both the pmos and nmos transistors are off. See the analysis to get clarity.

Q: 15. A light bulb draws 300 mA when the voltage across it is 240 V. The of the light bulb is…

A: Given,  A light bulb draws current, I = 300 mA Voltage across it, V = 240 V

Q: A system has transfer function s²+35+6 (s²+1) (s³+4s²+7s+4) Use the Routh-Hurwitz technique to…

A:

Q: resistance of the light bulb

A:

Q: What is the transfer function of the system described by the state space equations below? *-[11²+- x…

A: The solution is given below

Q: 3- A transformer, when tested on full-load, is found to have Cu loss 1.8% and reactance drop 3.8%.…

A:

Q: Solve for Vo = Volts. =10 mA R₁ =2kQ w

A: In this question we need to find a voltage Vo

Q: What is the inductor current if VL is 500 sin(50t + 20°)? 4 5 sin(50t - 70°) 5 sin(50t + 20°) 5…

A: Given, In inductor VL=50sin50t+20°

Q: .. Define the Flip-Flop and what are the applications of Flip-flop?

A: Given question is belong to Digital electronics concept

Q: If the input voltage in the figure below is increased, the peak negative value of the

A: Diode- When diode is forward biased it is short circuited in a circuit ideally. When diode is…

Norton Theorem

In the current circuit law, the Norton theorem (also known as the Mayer-Norton theorem) is a simplification that can be applied to networks generated by a constant line of opposition, power sources, and current assets. In two network terminals, it can be switched on with a current supply and single resistor respectively.