26) Determine the output voltage for the network of figure rd = 40 kn. Figure (5) Good Luck H '40 ΜΩ 1015 9 30V 3.3 ΚΩ F VGS(Th) = 3 V k=0.4×10-3

Q: Please ans this question as soon as possible : Draw a detailed circuit diagram to implement the…

A: given here a boolean function and asked to implement it with the 4×1 multiplexer.

Q: In a series resonant with a 15 Ω resistor, 20µF capacitor and a coil inductor of 15mH, calculate the…

A:

Q: Solve the question by hand do not using computer, explain each step please Example 3.8: ELECTRICE…

A:

Q: 5- convert 38.347)10

A:

Q: (a) Figure 2.1 shows the circuit of a silicon transistor amplifier. The amplifier is to have an…

A:

Q: 7. The substrate of MOSFET is normally connected to the Drain terminal. 8. In the actual…

A: Given  True or false question based on MOSFET and BJT. Please find the below attachment for clear…

Q: In the diagram below, C₁ = 6.65 mF, C₂ = 1.29 mF, and C3 = 7.36 mF. The potential difference across…

A: In this question we need to find a potential difference between A and B

Q: on -10 -15 -20 20 15 10 5 1 2 3 I 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 t (ms)

A: The given waveform is shown below:  The average value of the waveform is determined from the area…

Q: 6. A Thevenin de equivalent circuit always consists of an equivalent.. a. AC voltage source b.…

A: Network theorems are very useful in analysis of various circuits.

Q: A 220 V DC series motor is running at a speed of 800 rpm and draws 100 A. Calculate at what speed…

A: Given data, The value of voltage is V = 220 V. The value of speed is N1 = 800 rpm. The value of…

Q: Rin (emitter), Av, A₁, Ap

A: The required parameters can be calculated by using the DC analysis and AC analysis of the amplifier…

Q: The power in a series R-L-C circuit will be half of that at resonance when the magnitude of current…

A:

Q: Apply Thevenin's Theorem to find Vo in the circuit below. j5 Ω 12/0° V Z +5 ww 15 Ω -j30 Ω + )…

A: In this question,  We need to determine the voltage Vo as shown the circuit using the Thevenin…

Q: Q1) A 1200 strain gauge used to measure the strain and has a gauge factor of 2.5. It connected to a…

A:

Q: Q5: A 50-Hz, 3-phase, 100-km long line delivers a load of 40 MVA at 110 kV and 0.7 p.f. lag. The…

A: Given  A 50-Hz, 3-phase, 100-km long line delivers a load of 40 MVA at 110 kV and 0.7 p.f. lag. The…

Q: 28. Find the magnitude of a curl of the vector at point (1,1, −0.2); F = 30 ax + 2xy ay + 5xz² a₂ a.…

A: 28.  Find the magnitude of curl of the vector at point (1,1,-0.2) ; F=30 ax+2xy ay+5xz2 az Options…

Q: Question 14 The rms value of half wave rectified sine wave is 100A. Its maximum value is 199 A 202 A…

A: Q.14) ans:( d) 200A    For half wave rectifier, RMS value of load current = Io(RMS)  = Jpk /2

Q: 23. If the impedance of the circuit is 50ohm and the resistance is 8ohm. Find the power factor  A.…

A: 24.  Given: Impdedance,Z=50ΩResistance,R=8Ω

Q: If the impedance of the circuit is 500 and the resistance is 80. Find the power factor.

A: In AC circuits, the power factor is defined as the ratio of Active power to Apparent power. It is…

Q: Question 9 Find the reluctance of a magnetic circuit if a magnetic flux = 4.2 x 10-4Wb is…

A: Given, Magnetic flux, φ=4.2×10-4 Wb Magnetomotive force, MMF=400 At

Q: Suppose that the z-transform of x[n] is 1 X(z) = (1 + 4z-2)(1+3z-¹) Sketch all possible ROC…

A:

Q: For the circuit shown: 1. Find the value of "R" that makes the circuit in resonance. 2. Determine…

A: Given figure,

Q: A conductor has a conductance of 70μS is used to supply a load. Find its equivalent resistance.…

A: Q.21) ans  (d) 14.3 K ohm  Since conductance is defined as reciprocal of resistance . R = 1/G

Q: Determine i, in the circuit below ΤΩ www.t 10 sin(t-30°) V % F 252 www 24 V + 2 H 2 cos 3r A Y +2

A:

Q: Find v.(t) in the circuit of Fig.3 if the current i, through the 12 resistor is 0.5sin200t A. 10 202…

A: Given here a electrical circuit and asked to find the voltage source Vst.

Q: Find the maximum value of gm for FET with loss 10mA, V₂=-2V, VGs 5V? express answer in mS

A: To find the maximum value of gm for FET with IDSS = 10 mA , Vp = - 2 v and VGS = 5 v

Q: Vols) 3 5+85+18 How?

A:

Q: The parallel RL circuit is having quality factor of Q₁, when it is connected in series with R, the…

A: The quality factor, Q = 2π Energy storedEnergy dissipated In parallel RL circuit,…

Q: The steady-state tracking error to a unit step input R (s) = 1/s with Ta(s) = 0 is: a. ess= KIK₂ K₂…

A:

Q: Solve the question by hand do not using computer, explain each step please Example 3.8: Consider the…

A:

Q: Vo(s) = S 5+s 3(5+5) 3 V015) = *£$ = (5² +85+18) (5+) s²+85 3 How? 5+85+18 3 3 [S+2.4.5+ 4+2 (S+2)²…

A:

Q: Question 8: Given a continuous-time signal xa(t) with X₁ (F) = 0 for |F| > B, determine the minimum…

A: For the above given continuous time domain signal we need to calculate sampling rates under the…

Q: 03- The magnetic circuit is laminated with 0.93 iron factor and μ, 1200. Calculate the current…

A: Given, For a magnetic circuit,iron factor = 0.93μr=1200ϕ=0.5 mwbAndWe know,μ0=4π×10-7 H/m

Q: The superposition theorem is valid for

A: Superposition theorem states that in any linear bilateral network consisting of number of energy…

Q: (c) What is the electric field strength inside the conducting sphere? State ALL assumptions that you…

A: In the above given question we need to calculate the value of electric field inside the conducting…

Q: e electric field strength E, at a radius

A: Electric field lines are zero inside the perfect conductor. And permittivity of medium…

Q: Qs-For the circuit Shown in Fig (3) - SOKA loo 2mA 43 50 PF 3MA a) By using approximate Parllel…

A:

Q: Q1) A) What is bus? How many ways to construct bus system.

A: Advantages of bus system are: Simple Maintenance is easy Outage is minimized Optimization selection…

Q: 1. Thevenin's theorem is quite useful when the current in one branch of a network is to be…

A:

Q: A 480 V, 60 Hz, three-phase source is connected to a delta-connected load, in which each element has…

A: Given data, A three phase source is connected to a delta connected load. VL=480 Vf=60 HzZph=9+j3 Ω

Q: 1 H m + v (1) F 2u(1) V 4922 Figure 16.6 For Practice Prob. 16.1. Determine vo(t) in the circuit of…

A: we first transform the circuit from time domain to…

Q: For a Baudrate of 100 bauds/sec for a 4PSK signal, the bitrate is _bps. Select one: O a. None O b.…

A: Given, The baud rate of a 4 PSK signal is 100 bauds/s

Q: Find vo(t) in the circuit shown in Fig. 16.9. Note that, since the voltage input is multiplied by…

A: Given Circuit is:-

Q: A 3-phase, star-connected alternator has a resistance of 0-5 2/phase and a synchronous reactance of…

A:

Q: A half wave rectifier feeds a load of 10ohms in series with inductance of 20mH. The input supply…

A: Given  A half wave rectifier circuit along with its parameters.we need to determine the average dc…

Q: Sketch the polar plot for the system. having 10. G(s) H(s) = 2 (5+2) (5+4)

A:

Q: 5 Find the average value of the periodic function shown in figure. VIMA 0 π/3 2π/3 4/3 5/3 2π [Ans:…

A:

Q: Q3) An 880VA, 220V, 50Hz, load has a power factor of 0.8 lagging. What value of parallel capacitance…

A:

Q: - Assume you have a Frequency message signal as fi(t) = ky s(t) + fe where k, = 2 x 105 Hz/volt. If…

A:

Q: A 400/230V, 50Hz, single phase  transformer has 200 turns on high  voltage side. Find turns ratio,…

A: A transformer is an electrical machine which is used in AC circuit to either step up or step down…