R14. Two sequence components and the corresponding phase voltage of 3ø system are ollowing, Va0=0.6L90° la1=1L30 and Ja= 0.20L18.86° - The negative sequence component is calculated as a. -0.8L60 b. 0.8L60 c. 0.8L-60 d. 0.6L90

Q: three phase load has a phase voltage of 240 V and a phase current of 18 A. What is the apparent…

A:

Q: OWER SYSTEM ANALYS The following currents were recorded under fault conditions in a three-phase…

A: In this question, choose the correct option What is angle of negative sequence current I2.  We know…

Q: hree single-phase transformers are connected in delta-delta to step down a line voltage 138 kV to 80…

A: Given that  Real power (Active power ) P= 24 MW power factor cosϕ = 0.89 (Lagging)  Although formula…

Q: Find out the zero-phase sequence components of the following set of three unbalanced voltage…

A:

Q: Three phase star connected system has I = 1040, I = 104270 c=154135 determine the Symmetrical…

A:

Q: Problem 3.1: Determine the rms value of voltage induced in an 80-turn coil on a 30 cm × 25 cm…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: A delta connetion has a voltage of 560V connected to it.  How much voltage is dropped across each…

A: Write the given value of the line voltage in the delta connection.

Q: 10.If the number of poles is constant, how to control on the generated frequency of 3 phase…

A:

Q: Give example problems for impedances and admittance.    Equation: Z = R ± jX or Z2 = R2 + X2

A: Please refer the attached images for the complete answer..

Q: Pin = 920 W n the per-phase equivalent circuit he slip at pull-out torque, and find e.

A: An induction motor is an asynchronous motor in which the stator winding is connected to a…

Q: For a three-phase circuit following an "abc" sequence, which of the following statements about phase…

A: First we will draw phasor diagram with abc as phase sequence than we will select correct option from…

Q: Q21-The Line Volta8es at the terminal ofabalanced Yeomected Lood 1S VAB-12066Each phase of the Lood…

A:

Q: In a 10 km long three phase conductor diameter of 2.5 mm the conductors are arranged symmetrically…

A:

Q: Q6/B: A three-phase double circuit line is shown below, the diameter of each conductor is 2 cm. F…

A:

Q: What is minimum and non minimum phase system. Draw its phase characteristic curve.

A: Transfer function is ratio of output signal to input signal. It is the given as ratio of Laplace…

Q: The p.u. impedance value of an alternator corresponding to base values of 13.2 kV and 30 MVA is 0.2…

A:

Q: n phase margin why the phase go down for first time then go up?

A: As electronic amplifiers the phase margin (PM) that is the difference between the phase lag φ (<…

Q: star connection, the line voltages leads the phase voltages by

A: Star connection :- (Phasor Diagram)

Q: eq V 12 10-"(0-5 + 2 log, Deq{r") -7 -- Inductance/phase/m %3D Inductance per conductor per metre =…

A:

Q: Single phasing happens when one phase of a three phase source becomes unavailable.  True  False

A: Given  A true or false question based on single phasing condition. Please find the answer below.

Q: mcq single-phase unidirectional AC chopper is fully controller chopper   Semi controller chopper…

A: Half wave controlled rectifier are unidirectional AC coplper.

Q: Derive the equation for impedance and phase shift for series RLC circuit connected to the AC…

A: A series RLC circuit is formed by connecting a resistor, inductor, and capacitor in series across a…

Q: Problem 2 - A 1000 – MVA, 20 – kV, 60 – Hzthree-phase generator is connected through a 1000 – MVA,…

A:

Q: A1 heee hee ll ee B2 ll A2 To three-phase load

A:

Q: Explain why the phasor and the impedance have the same angle

A:

Q: "If Ibc is equal to 646.0552109 and la is 373angle;19, the phase sequence is:" O POSITIVE O NEGATIVE

A: We need to find sequence of given system

Q: In DC choppers the wave forms for input and output voltages are respectively a. both discontinuous…

A: As it is DC chopper  so input woupd be dc and output would be dc

Q: Find the phase angle between i = -4 sin(377t + 25°) and iz = 5 cos(377t – 40°) %3D Does i lead or…

A: Given: The phasor are i1=-4sin377t+25°i2=5cos377t-40°

Q: Three Impedances each of (14- j18)N are connected in mesh across a three-phase 415V ac supply.…

A: Introduction: The finished terminal of one winding is connected to the start terminal of the next…

Q: The following are the symmetrical components of phase B current. Positive sequence component = 10…

A: In this question positive sequence component of phase B current is given....We have to find out…

Q: An unbalanced 4 wire star connected load consisting of the phase impedances ZRS (15+j5)2, Zys…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: In a star connected three-phase balanced (RYB) system, the phase angle between phase voltage ( VR…

A: In a star connected three-phase balanced (RYB) system, the phase angle between each  phase is 120°.…

Q: The phase angle between magnetizing component current and core loss component current is 90° Select…

A:

Q: (b) Determine the inductance per km/phase of a double circuit three-phase line as shown in the given…

A:

Q: TSS a. Write the nodal equations for the eircuit shown; and solue for the nodal voltages, b.…

A: In this question we need find the node voltage by using Nodel voltage analysis  and voltage across…

Q: In a three phase, delta connection O a. Line voltage is square root 3 times phase voltage Ob. Line…

A:

Q: Given a delta wye circuit with L=265mH, C=27uF, f=60Hz, and R=100Ω, complete the table and find the…

A:

Q: CONVERT UNEBALANCE WYE TO UNBALANCE DELTA Solve Phase Currents, Line Currents, and S PQ powers.

A: "Since, you have posted a question with multiple parts. According to our guidelines, we can answer…

Q: A three-phase 50 Hz double circuit as shown below, assumed that the line is completely trasposed.…

A: Given transmission line circuit is 3-phase double circuit. Diameter of each conductor is 2.76 cm.…

Q: Find the phase angle between i = -4 sin(377t + 25°) and iz = 5 cos(377t – 40°) %3D Does i lead or…

A: Given current equations, i1=-4 sin377t+25°i2=5 cos377t-40°

Q: The type of the load whose current and voltage phasors are as shown in the phaser diagram is Im 90°…

A: -Consider the phasor diagram given:

Q: 1. A single phase overhead transmission line deliw and reactance per conductor are 0-15 Q and 0-0

A: According to question:

Q: Three unequal single-phase loads are

A: Given-Voltage rating= 230 VoltsFirst load takes connected across 1 and 2= 106A with 0.78 pf…

Q: Darrieus turbine does not requires guy wires to support. Select one: True O False

A: According to the question we have to discuss about Darrieus Turbine.

Q: For b) what is Vry, Vbr, Vyb? Why is Vyb phase -90 degrees and Vby phase 90 degrees?

A: In this question we will find line voltage phase angle with respect to phase voltage.....

Q: Find out the zero-phase sequence components of the following set of three unbalanced voltage…

A: In this question,  We need to choose the correct options What is the zero-phase sequence components…

Q: DEGREE: ELECTRICAL ENGINEERING SUBJECT: AC CIRCUITS The line current of unbalanced delta connected…

A:

Q: Van = 666∠-33°, Vbn = 666∠-153°, Vcn = 666∠87°" A   POSITIVE PHASE SEQUENCE B…

A: We need to find out the sequence of given phases .

Q: Calculate the inductance of the single-phase double circuit line shown in the figure, the diameter…

A:

Fault Analysis

In an electrical engineering system, a fault is an abnormal electric current flowing through the system, and fault analysis is the study of these faults. For instance, a short-circuit is a fault where the live wire touches the ground or neutral wire. If a circuit is interrupted by a failure of a current-carrying wire then an open circuit fault occurs. The open-circuit faults are also called series faults. One or more phases or ground may be involved in a three-phase fault or may occur only between two phases. Current flows into the earth in case of a ground fault or earth fault. For most situations, the prospective short circuit current of a fault that is predictable can be calculated. To limit the loss of service because of a failure, the protective devices can detect fault conditions and operate circuit breakers and also other devices. All phases equally can be affected in a poly-phase system which is known as symmetric electrical fault. The asymmetric fault becomes more complicated to analyze if only some phases are affected. By using methods such as symmetrical components, the power system analysis of these types of faults is often simplified. The main objective of power system protection is to design, detect, and interrupt power system faults.