Question: The current in the circuit will be D₁ (a) 5/40 A (c) 5/10 A 20 Ω www D₂ 20 92 wwww 30 Ω www 5 V (b) 5/50 A (d) 5/20 A
Q: 2. For a stable LTI system, its impulse response H(z) must satisfy A. the ROC of H(z) must be…
A: Given: For a stable LTI system, its impulse response H(z) must satisfy?
Q: total current
A:
Q: The reactance data for the power system shown in below figure in per unit on a common base is as the…
A:
Q: 3. Determine P1, P2, and P3 (Powers absorbed) for this circuit. Consider the following cases: a)…
A: Given: Voltage that is responsible for power P1is 8 V Voltage that is responsible for power P3 is…
Q: Ex: Compute the power dissipated in the 992, resistor by applying principle. All resistances are in…
A: Given: To find: Power dissipated in 9Ω resistance by applying superposition principle.
Q: 30 V | +1 4Ω 2Ω 8 Ω 4Α 6Ω ΜΕ M 3 Ω 1Ω
A:
Q: 3. The location of the sliding bar is given by x=0.2t, and the separation of the two rails is 20 cm.…
A:
Q: 4, Assume a sequence x(n) is real. And the 7-point DFT is the X(k). The value of DFT even points are…
A: The given problem is from Discrete Fourier Transform (DFT).
Q: What is the total b
A: Given data, Number of address pin n = 17. Data pin m = 4.
Q: The rectangular form of the complex number 32/-20 (6-18)(4+12) + -104724
A: Given data, Function is given as, z=32∠-2006-j84+jj2+12-10+j24.
Q: find the value of admittance Y on given circuit diagram
A: In this question We need to determine the admittance of the given circuit. We knows Admittance of…
Q: 1 1052 www 201 Determine the THEVENIN value of the according. ab terminals.
A:
Q: Three Phase Induction Motor Question 1: A wound rotor induction motor runs with a slip of 0.05 when…
A: Given- 3-phase induction motor- Wound rotor induction motor- Slip S=0.05, Rotor resistance = 0.45…
Q: d) Determine the total inductance for the connection shown in Figure 5.1 below.
A: The total inductance can be obtained by reducing the parallel connection first and then reduce the…
Q: what about the rest of the question ?
A:
Q: 、List four types of static-performance terms sensor index
A: Static qualities, which serve as the performance standards for the measurement of constant values.…
Q: 22. Radiation resistance of a small dipole current element of length at a frequency of 3 GHz is 3…
A: Given- Frequency f=3 Ghz, Radiation resistance = 3 ohms, Length is changed by 1%, To Find- The %…
Q: (a) Consider the circuit on the right. The resistor values are 2 2, and the inductance is 1 H. The…
A:
Q: Find voltage V1 using superposition principle + VI - 10 Q 220 V 20 Q w 60 Q 5 A www 60 V
A: In this question We need to determine the voltage V1 using the super position theorem. Here 3…
Q: 1 Specify the polarization states of the Jones vectors given below.
A: In optics and photonics, the Jones vector is a mathematical representation of the polarization state…
Q: 2. Some specific buses are usually used in system except ()
A: Some specific buses are usually used in systemexceptSPI busclock busUart busUSB bus
Q: Q1) The switch in the circuit below has been at position a for long time and at t=0 the switch moves…
A:
Q: D→ iP
A: Magnetic Field Intensity at the origin due to any part of the circle is given as B=μ0 I θ4 π Rθ=In…
Q: Explain the working of the Zener diode in detail. I just need explantion so i will undersatnd.
A: We will refer the concept of zener diode equivalent circuit for better understanding.
Q: 1. Using Routh method determine the range of values K in the following closed-loop control system…
A:
Q: What is the working principle of a half wave controlled three phase rectifier
A: Rectifier:- An electronic device called a rectifier uses one or more P-N junction diodes to change…
Q: 2. Determine the relative permittivity of dielectric for a square plate capacitor of 2.5 m² area and…
A: As per company guidelines,when multiple questions are posted,the first question needed to be…
Q: Topic: Kirchhoff’s Voltage Law and Current Law What will be the effect upon the solution of a…
A: The arbitrary consideration of direction of the current has no affect on MAGNITUDES of any other…
Q: Solve for VAB of the circuit shown below. Measure the resistance across the terminal where the…
A: Given: A circuit, To find: a) Equivalent resistance, b) Voltage across terminal AB.
Q: 6. Question 6 (a) Give the expression that relates the overall gain of an Operational amplifier, the…
A: In the given questions we need to discuss about the basic properties of operational amplifier.
Q: Please solve Last time Rejected. A current of 4 A flows through a non-inductive resistance in…
A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…
Q: Q4. Use the superposition theorem to find the voltage V. in the circuit of Fig. 3 and calculate the…
A: The superposition theorem state that the sum of response of individual sources acting alone is equal…
Q: Q: Find Z-transform x(n) = 2-"u(-n+1) +0.3 "(-n+2)u(-n)
A: Since you have asked multiple questions in a single request, we will be answering only the 1st…
Q: 、What’s the principle of the single-arm bridge strain gauge?
A: A single-arm bridge strain gauge is a device that is used to measure strain, or the deformation of a…
Q: Explain single line diagram for residential power system
A: Single Line Diagram- Definition: A single-line diagram represents a power system using a simple…
Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…
A: Clipper Circuits:- A clipper circuit is used to clip the input voltage at a fixed higher and lower…
Q: suppose a FM signal, 20sin(2π × 9 × 107t + 5sin1.2π × 104t) is applied to a 50- antenna. Determine:…
A: It is given that: SFMt=20sin2π×9×107t+5sin1.2π×104t ...... 1R=50 Ω
Q: dt² $1 a2 dt d²x dt² + a₁ dx dt "Xn(t)" = Aest + aox = 0 -a₁ + √²-4a₂ao 2a2 =n(t) = A₁e³₁t + A₂eszt…
A:
Q: 9.66 For the circuit in Fig. 9.73, calculate Zr and Vab. 60/90° V +1 fo ZT 20 Ω -j5 Ω θα + Vab j10 Ω…
A: For the given circuit calculation of ZT and Vab.
Q: ductors, has a series impedance of (0.1826+j0.784) 2/km per phase and a shunt ca- pacitive…
A:
Q: (a) Determine the transmission line inductance per phase in H/km. (b) Determine the transmission…
A: Given: 3-phase transmission line having a bundled conductor. spaced symmetrically 30 cm apart in a…
Q: A、 x(n)=x*(−n) B、 x(n)=-x*(-n) C、 x(n)=x*(n) D₁ x(n) = -x*(n)
A: We need to select correct option for conjugate symmetry .
Q: a. For the resistors in series, is there a significant difference in the values of individual…
A:
Q: Q1. The shaft power output of 3-phase, 4 poles, 50Hz induction motor is 32 KW at 1420 rpm,…
A: “Since you have posted a question with multiple sub-parts, we will solve first three sub- parts for…
Q: Figure 2 The following equations for the system G₂ (s) and the controller K(z) are given; y(t) =…
A:
Q: Discussion: 1- Explain the properties of the following controllers: P, PI, PID. 2- Suggest an op-amp…
A: We have to explain the properties of the following controllers: P, PI, PID.
Q: Find I₁ in the circuit in the figure. 2 mA 3 ΚΩ Σ 9 mA 1₁ • 4 ΚΩ 6 mA
A: Given : Current flows from A to B, IAB = 9 mA, Let Resistance present between point A and D is…
Q: Explain the characteristics of a diode
A: Explain the characteristics of a diode.
Q: In the circuit shown in the given figure, the current through inductor is 10 Ω www 10 V 5H 5VT
A: Given circuit- To find- Current through the inductor.
Q: 3、The relationship between the signal frequency fc and sampling rate Ts is ( ) according to the…
A: The Nyquist-Shannon sampling theorem, also known as the Nyquist sampling theorem, is a fundamental…
Diode circuit
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 2 images
- Find V₁ and V₂ in the circuit below: 220° A ↑ V₁ = 5.2793 - j*5.4190 V₁ = 9.2793 - j*1.4190 V₂ = 9.6145 - j*9.1955 V₂ = 0.6145 - j*3.1955 V1 j4 Q + Vx - 5Q -j3 Q V₂ ↑ 3/45° AWhat is the power factor (P.F) in this circuit? 80MH 60H2 20F 28.8% O 72% 75.5% 43.2% 25% 57.6% O 14.4%Given R = 600 ohm and 86 = mH and C = 0.00012 F Find Zab
- Q5] find the current of the resistance 1892 if the value of the source is 7.4sin(100πt-44) volt HH 1mF R1 ww 18Q R4 •14Ω 3.9mF 13.100, 78.163⁰ mA O 14.100, 78.163⁰ mA O 15.100, 78.163⁰ mA 0.093H V1You are given the below parallel RLC circuit, answer the following questions showing the detailed steps 1.5 μF Li 300 mH 220 V 50 Hz R3 300 2 0.5 µF L2 120 mH C2 Figure 3: Parallel RLC Circuit a) Total impedance of the circuit b) The voltage and current Phase shifts of the total impedence. c) The voltage across C1 and the current flows through it. d) The voltage across L1 and C2. e) The currents flow through L1, R and L2.Determine Rin (in M2) in the figure. p 12 V Rp 2 kN RG C2 10 M2 1 µF D ID(on) = 6 mA VGs (on) = 8 V Vasm) = 3 V G %3D 1 µF
- I just want to verify my results. The R value to use is 841 ohm I get that fb = 837 Hz, V1= 2.99 V, and Omega1 = 14.9 degrees Also V2 = 0.951 V and Omega2 = -45.1 degreesSolve for the equivalent inductance at terminals a-b, if L1 = 39 mH and L2 = 98 mH. (Hint: You may add wires and flip the circuit) L1 60 mH 25 mH L2 a o ele ell 30 mH ell1.5 µF Li 300 mH 220 V 50 Hz 300 2 L2 120 mH C2 0.5 F You are given the below parallel RLC circuit, answer the following questions showing the detailed steps. Figure 3: Parallel RLC Circuit a) Total impedance of the circuit b) The voltage and current Phase shifts of the total impedence. c) The voltage across C1 and the current flows through it. d) The voltage across L1 and C2. e) The currents flow through L1, R and L2. Open Wc ell
- Given the following Resistances and Capacitors in Series and Voltage Source: R1 - 7 ohms R2 = 4 ohms C1 = 0.157 Farad C2 = 0.01 Farad Vs = 10,382 Volts Frequency = 86 Hz What is the Amplitude of the voltage across C1?نقطة واحدة the total resistance in the circuit * shown in the figure is R1 B |对 R4E 0.5 N E 10 V 40 R3§40 R150In a parallel circuit, ET = 120 V, R = 1500 $2, and XL 1000 2. What is the apparent power? O a. 17.31 VA O b. 24 VA O c. 29.6 VA O d. 34.40 VA D