Question :- A chimney of 16 m high is used for discharging maximum exhaust gases. (i) Find the draught produced by the chimney in mm of water. (ii) If the maximum temperature of the gases available is 350 degrees * C find the mass of air supplied per kg of fuel if the discharge mass is maximum. The atmospheric temperature = 20°C. %3D

Question :- A chimney of 16 m high is used for discharging maximum exhaust gases. (i) Find the draught produced by the chimney in mm of water. (ii) If the maximum temperature of the gases available is 350 degrees * C find the mass of air supplied per kg of fuel if the discharge mass is maximum. The atmospheric temperature = 20°C. %3D

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A 750 bhp diesel engine uses fuel oil of 30oAPI gravity, fuel consumption is 0.75 lb/bhp-hr. Cost of fuel is P17.95 per liter. For continuous operation, determine the minimum volume of cubical day tank in m3, ambient temperature is 45oC.
A converqunt - dierput nozele has an enit Mach number of le8 when operating isentrop ically A exit if the back presuve is increased Such thaten Pback 0.8 ashock appeans in the divergent portion.. What is (Aenit/Asheck) ?
Calculate the height of chimney required in a boiler in which natural draught is 25 mm of water. The flue gases are at temperature of 600K , atmospheric air temperature is 25 C and 15 kg air per kg of fuel is required in boiler.
Using Marshall method to design an asphalt mix, the data in theTable below were obtained. The bulk specific gravity test were conduct at 25°cwhere γ water=1gm/cm³. The values of corrected stability (kN), flow (mm) and theoreticalmaximum specific gravity of asphalt mixtures for each asphalt cement percentare given in the Table below. If the value of bulk specific gravity ofaggregate mixture is(Gbam= 2.655), determine the optimum asphalt content andcheck if the value of Marshall properties at O.A.C satisfied the Iraqi StateCommission for Roads and Bridges (SCRB) requirements? What are you suggest ifone property not satisfied the (SORB) requirements?
Derive a formula for the bulk modulus of an ideal gas, withconstant specifi c heats, and calculate it for steam at 300° Cand 200 kPa. Compare your result to the steam tables.
isnt the mass Mg? so 10^6?
The values of Cp for the consu Ammonia in air is a toxic mixture when the ammonia is 0.45% by volume. Calculate how much leakage from an ammonia compressor can be tolerated per 1000m³ of space. The pressure is 1bas and the temperature is 15 °C. The molar mass of ammonia (NH3) is 17kg/kmol, and it may assume to act as a perfect gas in this case. and 70 °C. The vessel is A perfect insulated vessel having three compartments A, B and C of volume 1.3m³, 1.2 m³ and 1.0 m² respectively are separated from each other by thin membrane. Compartment A is filled with ritrogen having a pressure 3bar, at a temperature 25 °C, compartment B is filled with hydrogen having a pressure of 20bar at a temperature -40 °C and compartment C filled with carbon (IV) oxide at a temperature 175 °C and pressure 6bar. If the thin membrane are punctured and the three gases allowed to mix freely, calculate: (i) The final temperature of the mixture The final pressure of the mixture (iii) The change in entropy of the…
An air-standard Dual eycle has a cos cXISsion ratio of 10. The pressure and temperature al the beginning of con conm con are 1 bar and 27 °C. The max im pressure Is, md is 42 bar and che maximum tes ature is 1500 °C. Determine (1) thiky Aperature at the end of constant (o (0) ait off ratio (m) work done per kg of air and (iv) (he cycle elliciencV. Assme C ie heat addlition 1001 KJ/kg K and C 0.717 kJ/kg K for air.
A closed rigid container has a volume of 1 m3 and holds air at 344.8 kPa and 273 K. Heat is added until the temperature is 6000K. (Rair = 0.287 kJ/kg K), (kair = 1.4). a. What is the mass of air?, b. What is the final pressure? , c. What is the change in enthalpy? and d. What is the value of heat added to the system? JUST ANSWER ONLY THE LETTER D.
A closed rigid container has a volume of 1 m3 and holds air at 344.8 kPa and 273 K. Heat is added until the temperature is 6000K. (Rair = 0.287 kJ/kg K), (kair = 1.4). a. What is the mass of air?, b. What is the final pressure? , c. What is the change in enthalpy? and d. What is the value of heat added to the system?
plzzz help me right nowww Air (its gas constant is 287 J/kg.k) escapes from a tank at a temperature of 55 0C and specific internal energy of u= 3588 J/kg, what will be its enthalpy (J/kg)?
Which characterizing terms are in Bernoulli equation?