Question 6 Using superposition, find the current I through the 6 9 resistor of Fig. 6. + E₁ = 20 V Z 30° voo X₁ = 60 I₁ Fig. 6 R = 60 2 AZ0° Xc= 80

Q: The instantenous electric and magnetic field intensities for a plane wave are given as The average…

A: Instantenous electric and magnetic field intensities for a plane wave are given        E = y^ 5sin…

Q: design a 4-2 multiplexer .

A: Multiplexer is a combinational circuit that selects between several inputs and forwards it into…

Q: 1 Iron core with r 2) Figure shown in the left consists of a long wire along +z axis, which carries…

A: SOLUTION: GIVEN DATA: F=50HZ a=5cm b=6cm c=5cm R=1Kilo-ohm I(o)=5A Turn-loop=100 turn Determine:…

Q: b) In another unity feedback system, the root locus is depicted in Figure Q.1 (b). If the system is…

A: The given root locus is shown below, The given value of damping ratio at which the system is…

Q: Q2: sampling an 8-point x(n) time-sequence and you want to sample "exactly three cycles" of a…

A: From the above DFT diagram we can write  x(m)= {0, 0, 0, 5.657+j5.657, 0, 5.657-j5.657,…

Q: Obtain the node voltages in the circuit in Fig. 3.4. Answer: V₁ = -2 V, 0₂ = -14 V.

A: It is given that:

Q: jo.53 1 j0.4 j0.3 3 20.07 j0.2 ammfo

A:

Q: H(s): 6s² + 18s +12 2s³ +10s² +16s+12

A:

Q: What tasks are performed by the controllers of the various devices?

A: The tasks performed by controllers of various devices depend on the specific device and its intended…

Q: The magnetic field phasor of a wave traveling in a medium with intrinsic impedance n = 120 2 is…

A:

Q: .H.W design 2-bit Flash ADC Using Diodes and digital XOR gates

A: We need to design a 2-bit Flash ADC using Diodes and digital XOR gates.

Q: QI. (a) (b) Signal y(1) is given as in Figure 1. Signal y(t) is going through an operation of time…

A: Given: A signal y(t) as,  To find: a) i) Sketch b(t)=yt2-3, ii) Explain the effect on the signal…

Q: 2. Determine V and I of a short transmission line, if Z is... a) 600+ j2002 and 200 + j300 are in…

A:

Q: Draw the positive, negative and zero sequence networks.

A:

Q: A current-source hias circuit like Figure I has the following values: To produce a 10 mA drain…

A: We need to find out the value of unknown resistor in the given circuit.

Q: RT(Q)= V1(V) = V2(V) = V3(V) = PE(W) = Is E = 400V Is(A) = 11(A) = 12(A) = 13(A) = + V₁- 11 R₁ (500)…

A: input voltage  E = 400 V  currents are IS, I1,I2,I3  voltage drops across the resistors R1, R2 an R3…

Q: Two three-phase alternators operate in parallel and the excitation is such that the induced emfs are…

A: The question is based on the parallel operation of alternators. It is solved using basic circuit…

Q: or the half-wave rectifier of Fig. 3-2a, R = 100 £2, L = 0.1 H, w = 377 rad/s, and Vm= 100 V.…

A: An uncontrolled diode rectifier with RL load having, Angular frequency ω=377 rad/s Maximum input…

Q: Q4: In frequency response,a nonlinear electronic device produces an output that is the cube of its…

A: Given Data: A Non-Linear device having, Yω=Xω∠9003 Where, Xω=Frequency response of the input…

Q: A current i(t) = 6 sin (2πft) A with f = 50 Hz passes through a coil with an inductance of 2 mH. The…

A: Given- A current equation: it=6 sin 2πft A. Frequency, f = 50 Hz. Inductance, L = 2 mH. Time…

Q: (5) For the feedback amplifier of Fig.5, derive an expression for the voltage gain (V./Vin).

A:

Q: Problem two Given the following open loop block diagram, determine Y(s) when R(s) is a unit step…

A:

Q: Write code using the 8085 microprocessor to control the movement of the servo motor

A: To control the movement of a servo motor using an 8085 microprocessor, we need to generate a PWM…

Q: 3. (17 pts) Find V. in the circuit. 42 +A 552 252 $62 120 1052 Vo J

A:

Q: Find Io using Thevenin's Theorem

A:

Q: (10) Find the equivalent impedance in phasor form for the circuit shown in Figure 2. Given: I = 5…

A: Source current Is=5cos377t+450 A. R=1 kΩ, L = 0.8 H, C=220 mF.

Q: Yi RG VDD 3RD www- ☆ RS (3 2G= 10mn 25=150 RD = 15k~ VDD = 201 JDSS= 121 Vp=-4v ID=? VOS =? Vs=?

A:

Q: Determine the output voltage waveform for each circuit +10V OV- -10V 1.0 kn Vou +10 V V OV -10 V (b)…

A:

Q: A single-input, single-output system is described by 1 - x = [-26 -²₁ ]x + [ 1² ] 4. -a y=[ 10 ]x…

A: Here , single input, single output system is given  We need to find a value for the system exhibits…

Q: 4. ABC + ABC + ABC = A (B+C). 5. AC + ABC=C(A + B). 6. AC + ABC + ACD+CD= A + CD.

A:

Q: How much longer is an individual, without hearing protection, permitted to work at a location where…

A: How much longer is an individual, without hearing protection, permitted to work at a location where…

Q: What type of filter the following amplifier represents? Ignore transistor high frequency parasitic…

A:

Q: Draw convergent and divergent positive characteristic lines on an x-t plane. Indicating the time and…

A: The objective is to draw the convergent and divergent positive characteristic lines on an x-t plane…

Q: Determine the Fourier series expansion of the waveform f(t) shown below: 500 A 12 AÑA. -4 -2 0 2 4…

A:

Q: Which of the following statements about Laplace transformations are true? Select one or more: O a.…

A: a. Reverse Laplace transformation means moving from the Laplace domain to the time domain. The…

Q: In the circuit below, where RD=1k0, RD4=2kN, (W/L)1=(W/L)2=(W/L)3= 2(W/L)4=2, kn=1mA/V2, VTH=0.7V,…

A:

Q: An 8 bit Analog to Digital (A/D) Converter is capable of accepting an input voltage of 0-10 volts.…

A:

Q: Find I.Z.T for the system a) z> 0.33 b) z <0.25 X[2] = 3-0.83z (1-0.25z-¹)(1-0.33z-¹)

A: In this question we need to find the inverse Z transform of the given system for the given values of…

Q: Question A 3-phase full converter, fed from 3-phase, 400 V, 50 Hz source is connected to load R = 10…

A: 3-phase full converter- 3-phase, 400 V, 50 Hz source- R=10 ohm, Output current is ripple free,…

Q: 1. Determine the equivalent impedance across 'a' and 'b'. j12Ω 5Ω W Cod 4Ω j9Ω ad be W 4Ω (0) j13Ω…

A:

Q: 2- In the circuit shown in fig. (2), calculate the current through the resistor R when its…

A: In this question,  We need to determine current in the resistance R.  We are solving this problem…

Q: The output y(k) of a discrete-time system is given by y(k)= u(k+2)-u(k-2) where k is an integer…

A: Given Data: An output of a system is, yk=uk+2. uk-2 Where, uk=Discrete Unit Step Sequence To…

Q: A brushed DC motor has a permanent magnetic field of 1.3 T. The armature radius is 0.05 m. The…

A:

Q: use the following z parameter matrix with. The network is driven by an ideal sinusoidal source V₂ =…

A:

Q: c. If both terminals of a PN junction are grounded (V₁=0) the electrostatic potential A must equal…

A: If both terminals of a PN junction are grounded the electrostatic potential ∆ϕ must equal zero. In…

Q: What is meant by Power Conversion Efficiency.

A: Power conversion efficiency is an important parameter used to measure the efficiency of a power…

Q: (i) For the following 4-bit input bit sequences in the ordered format (EN_L,N3, N2, N1,NO),…

A: According to the question, for the given 74x138 based ROM decoder as shown below (i) For the…

Q: Y- PARAMETERS

A: we are allowed to give handwritten solutions only.  It is given that:

Q: Solve the following questi Find A, for the following frequencies. Assume fotol) = 200 Hz and Aomid)…

A:

Q: Consider two incandescent light bulbs, with resistances of 240 2 and 480 How much power do they each…

A: It is given that: V=120 VR1=240 ΩR2=480 Ω

Current Division Method

The generalized current divider formula is given by the following relation below,