QUESTION 13 F, 10 B, 14 E, 6 H, 2 A, 8 C, 10 D, 8 G, 12 For the network diagram shown above, what is the critical path? O a. A-C-D-G-I O b. A-B-E-G-I OC. A-B-F-H-I O d. A-C-E-H-I 1,7

Q: A cohesive soil deposit is considered soft if the unconfined compression strength in kPa is between…

A:

Q: P7.39. Solve Problem P7.12 by the conjugate bea method.

A: As there are two different questions posted, according to the guidelines, only the first one is…

Q: A confined aquifer has a source of recharge. The hydraulic conductivity of the aquifer is 40 m/day…

A:

Q: Problem Number 2: A soil profile is shown in the figure below, a uniformly distributed load (A6) at…

A:

Q: The beam is loaded by one couple at each of its ends, the beam cross-section shown below (Figure…

A:

Q: Calculate the runoff (cm) from a rainfall of 3 hours. The intensity of the rainfall is 2 cm/hr. The…

A:

Q: 405n03 SIUI 100 m R1 R2 R3 R5 R4 R8 R7 R6 R9 Dry Cleaner Gas Station Oil UST R10 If aquifer…

A:

Q: Problem 2) Determine the reactions at A and G, and then determine the force in each member. State…

A:

Q: what is confined and unconfined aquifer? What are their differences?

A: A confined aquifer is condition where the ground water table of water mass is confined between two…

Q: The channel consists of an unfinished concrete section (n=0.014) and overflow regions on each side…

A:

Q: 3-6. Determine the force in each member of the truss. Indicate if the members are in tension or…

A: Determine the force in each member of the truss. Indicate if the members are in tension or…

Q: Given the following data for three pipes in parallel: Pipe 1: D1 = 450 mm, L1 = 800 m ; Pipe 2: D2 =…

A: Given: Three pipes in parallel Length of pipes  Diameter of pipes  Total discharge  Friction factor…

Q: Q3. For a closed end cylinder where the inner radius is 20 mm and outer radius is 40 mm, and the…

A:

Q: Consider a cart weighing 4,905 N, is moving to the left due to the application of force P = 100 N to…

A:

Q: The following data were collected during a stream-gauging operation in a river. Com: pute the…

A: Solution-The given table is shown below, To Determine Compute the Discharge

Q: Derive an expression of the maximum statical moment of area, Q and its location from the given…

A:

Q: Give three of the advantages of an S-curve in the field of construction, with an example for each.

A: The mathematical graph that covers all project data is known as the S-Curve. The strong similarity…

Q: A fabric used in air-inflated structures is subjected to a biaxial loading that results in normal…

A: Determine the change in length of: (a)side AB (b)side BC (c) diagonal AC

Q: PROBLEM 1. A simple beam loaded as shown. Determine the following: (1) reactions @ support; & (2)…

A:

Q: Consider the mechanism shown. Members PQ and QR are joined by a hinge at Q. End P of member PQ is…

A: Option (D) is correct

Q: Draw the shear, moment, elastic curve, and axial diagram. 1SP (6) P (6/4) 0-8P (b/ft) 2ft 2ft 2件

A:

Q: The beam supports the loads as shown in the figure. Using E = 200 GPa, w = 16KN/m, P= 16KN and M=…

A:

Q: ds and . Use LRFD and determine whether this

A:

Q: the intersection point is 6427.464 m and pegs are required on the centre line of the curve at exact…

A:

Q: (c) A horizontal curve is designed for a two-lane road in mountainous terrain. The following data…

A:

Q: Points 1 3. 4 A 113.7 113.2 113.5 112.15 112.3 112.7 B 112.2 110.6 109.3 109.9 110.7 112.8 C 112.7…

A:

Q: To obtain friction factor, f, we need to know the Q, D, and kg in a given fluid flow. But if Q is…

A: When Q is unknown we cannot get Reynolds number Re. Hence we cannot deduce friction factor f from…

Q: A lap joint consists of two the same plates with a width of 75 mm and a thickness of 11  mm. it is…

A:

Q: PROBLEM 6 A 3-ft-diameter welded steel pipe (f = 0.0135) is carrying 15 cfs of water at 60°F. At…

A: The given data is as follows: Diameter of pipe=3 ftf=0.0135Discharge=15…

Q: 2.116 A manufacturer is studying the effects of cook- ing temperature, cooking time, and type of…

A: Given data, number of different temperatures obtained = 3 Different cooking times = 4 different oils…

Q: How useful are concrete hollow blocks in construction and why is it important?

A: These are standard sized blocks which are hollow in the centre and are used to reduced the dead…

Q: CALCLULATE THE FEM OF THE FOLLOWING USING THREE MOMENT EQUATION. /2- L/2-

A: Solution-Determining the FEM The diagram is shown below

Q: How does gypsum affects the performance of concrete?

A: Context: Gypsum in concrete

Q: Given a cantilever beam, determine the slope and deflection at point A. El is constant. 30 KN/m A B…

A:

Q: Given: a square footing (BxB) shown in figure. If the allowable consolidation settlement (Sc = 25…

A:

Q: Determine the design strength of a T-Beam with the following data: bf = 700 mm bw = 300 mm he = 100…

A:

Q: Please complete the solution

A:

Q: Som

A:

Q: Valuation of real properties may be done in many ways. a.) We expect that on a per-square foot…

A:

Q: A 3-ft-diameter welded steel pipe (f = 0.0135) is carrying 15 cfs of water at 60°F. At this…

A:

Q: Define index of wetness.

A: Index of wetness

Q: Calculate diameter in m. of a cylindrical water tank for a subdivision that has 500 lots if fully…

A:

Q: A pipeline 2.5 km long and 150 mm diameter supplies water from a reservoir to a small town storage…

A: Given: Length of pipeline Diameter of pipeline Friction factor  Difference between water level  To…

Q: (b) The road-base layer which consists of limestone aggregate has been completely constructed.…

A: A tack coat is generally applied to an existing pavement surface before any new layer is placed on…

Q: Determine the normal stress in MPa in members FE, BE and BC of the truss and state if the stresses…

A:

Q: Moment of inertia of the column & Moment of inertia of the beam

A:

Q: P6.5. Compute the support reactions and the maximum tension in the main cable in Figure P6.5. The…

A:

Q: A canal is 80 km long and has an average surface width of 15 m. If the evaporation measured in a…

A: Given data: Stretch of evaporation, L = 80 km = 80000 m Average surface width, B = 15 m Evaporation,…

Q: determine the shear force and bending moment at point 1 (P1) in the figure.

A: Asked: To determine the shear and bending moment at point 1 (P1).   Let us write the shear force and…

Q: C9 × 20 PL를X 12 KL = 6.5 m W8 × 21 F,= 290 MPa MC 13 x 5 - F, = 345 MPa JKL = 4.8 m (a) (b)

A: Given, Section -a Fy=345 MPa KL=4.8+28×0.02=5.36 mProperties of w8×21Aw=4000 mm2Ixxw=31.34×106…

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.