Answered: Q5: Determine the horizontal and…

Q5: Determine the horizontal and vertical components of force needed to hold the Y, shown in figure (4), in place. The plane of the Y is horizontal. Q. 0.23m/sec Qr0.34m/kec

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter1: Introduction To Statics

Section: Chapter Questions

Problem 1.31P: Resolve the 360-lb force into components along the cables AB and AC. Use =60 and =40.

See similar textbooks

Related questions

Q: 900 H 400 150 'B 100 E D 175 C 175 800 750 N 200 200 Dimensions in millimeters Determine the forces…

Q: A cable is loaded and supported as shown in Fig. The vertical distance yc is 4 ft. Determine The…

Q: Question 2A [Soalan 24/ The spring is placed between the wall and 10-kg block. If the block is…

A: To find: The work done by all the forces and sketch the free body diagram. Given: The mass of object…

Q: Q1: For the shown figure, find the height (h)? Air 1.5 bar 4.5 m oil 0.8 S.G= 13.6 h C Air water 3.2…

A: find the manometric height(h) in manometer.

Q: the force acting on a spring at any displacement is undeformed length is equivalent to the product…

A: k is the spring constant, in Newtons per meter (N/m), and x is the displacement of the spring from…

Q: An open tank, with bottom dimensions of 1 x 2 meters, is 9 meters high. It has oil with specific…

Q: In the given beam, determine the following: 60 Ib/ft 120 Ib 20 Ib/ft 3ft 6 ft 6 ft The horizontal…

A: When a push or pull act on the object, then it has the tendecy to change the the state of the object…

Q: A tripod supports the load W as shown in the figure. Determine the maximum load "W" (in pounds),…

A: Given Capacity of each leg, FC=87lbs

Q: An elevator car weighs 5500 N. If the car accelerates upwards at a rate of 4.0 m/s², what is the…

Q: If the perpendicular force of 1000 N, acting on a surface of area, 0.05 m^2, calculate the pressure…

A: Given F = 1000 N A = 0.05 m2

Q: 1. Let a = 4S m/ sec?, V. = 5 m / sec, find V and S at the end of 4 sec.

A: Given:- Acceleration (a) = 4S m/s2 Initial velocity (Vo) = 5 m/s To Find:- Velocity (V) and…

Q: A compressed air tank has a volume of 0.85 m3. When the tank is filled with a gauge pressure of 3…

Q: According to Archimedes' principle, the buoyancy force is equal to the weight of the fluid displaced…

A: Given dataRadius r = 1mDensity of sphere ρsphere = 200kg/m3Density of water ρwater = 1000kg/m3Volume…

Q: If 10 m3 of atmospheric air at zero degrees centigrade temperature are compressed to a volume of 1…

Q: 5 m/s 1 m Figure Q3

A: Answer: (a) The wooden box A speed just before the impact is 3.6370 m/sec. (b) After the impact, VA…

Q: Fill in all blanks before submission. Round the answer to the nearest integer. The post shown below…

A: Apply Equilibrium Conditions

Q: Compute the 3 force, FAD, FBE, FCF using this 3 equation. FAD+FBE+FCF=230x10^3 eq.1…

Q: 1. Solve for the tension in each cord for the systems shown below in lbf. ////// 30° 50° 77. T2 T3…

A: Disclaimer:-Since you have asked multiple questions, we will solve the first question for you. If…

Q: An increase in pressure of 2 bars decreases the volume of a liquid by 0.01 percent. Find the bulk…

A: Introduction: "The bulk modulus of elasticity is defined as the ratio of change in pressure to…

Q: 2. Question : For the given three bar support system, determine the internal forces at the point p,…

A: Given: The system is shown below:

Q: Determine T1 and T2 in N. 45 Tz 50 N

A: Given Weight, W = 50 N Angle = 45o Find Tension in the cable T1 and T2

Q: 1. A 25 m high vertical column of a fluid of density 1800 kg/m3 exists in a place where g = 9.6…

Q: 0.75Mg at exactly E; 600 Ibs. at 45°N of E; 4,000 dg at 85°E of N; 90 tons at 15°W of N; 350 gallons…

Q: Given the figure below. Find the momemt of F about O. 4 ft F, = {100i – 120j + 75k} lb 5 ft. 3 ft

Q: In the given figure, the 300 N load is balanced by a force F in both systems. Assuming efficiencies…

A: Draw FBD for both the pully system.

Q: Question 3: a Ina roller coaster the ride includes a vertical drop of 120 m. Sup has a speed of 4.0…

Q: A 500 – N box is pushed across a horizontal floor with a force of 250 N. The coefficient of kinetic…

A: Given:weight of box, W=500 NF=250 Nμk=0.4x=20 m

Q: 15 Two workers load identical refrigerators into identical trucks by different methods. One worker…

A: Given data: The height of the truck above the ground is; h=1.5 m. The length of the ramp used by…

Q: The trust is supported as shown in Figure Q1.1 5 kN 2 m

A: Free Body Diagram : It is a representation of the set of forces that is replaced by its support and…

Q: Given the sketch shown below, the diameter of the plunger Dp = 8 cm. The Ram diameter is Dr = 48 cm.…

A: GivenDiameter of plunger, Dp=8cm =D1Diameter of ram , De=48cm =D2efficiency =100%( no losses)Stroke…

Q: The process of splitting a force into a number of component forces is called Select one: Siding…

A: 1. Resolution of force helps in breaking the forces into components.

Q: 2.2 An open vat in a food processing plant contains 600 L of water at 20°C and atmospheric pressure.…

Q: 1)7K P2 derive that Please Pi

Q: A pump lifts water at the rate of 6 m3/s to a height of 120 m and the friction loss in the pipe is…

Q: 5. Flow occurs over a spillway (Figure). Determine the horizontal force on the spillway per foot of…

Q: The horizontal component of resultant forces equals to 3000 lb 90 Ib /ft 9 ft 200 lb/ft Your answer

Q: Q1. The 1000 in figure 1, determine the value of P,q and C. N.cm clockwise is the resultant of the…

Q: 6. The force on the triangular plate that is submerged in water as shown below waters surface 6m 4m…

Q: A body weighing 2,225N is being dragged along a rough horizontal plane by a pull of 445N directed at…

Q: A certain college graduate, Sallie Evans, has $24,000 in student-loan debt at the end of her college…

A: To determine the months required by the Sallie, using the relation as: Amout+interest in T…

Q: Given the lifting table shown below, The diameter of the plunger DP 20 cm. The ram diameter DR 60 cm…

Q: 8. Two forces of equal magnitudes 6,6 Newtons act at a point. If the magnitude of their resultant is…

A: This question is solved with the help of the parallelogram law of vector additions Force acting at a…

Q: A cubic meter of a liquid has a weight of 9800 N at a location where g = 9.79 m/s2. What is its…

A: Data given- W = 9800 N g = 9.79 m/s2 If g' = 9.83 m/s2 Then W' = ?

Q: 2. If money is worth 6% compounded annually, what payment 12years from now is equivalent to a…

Q: HOW COMPLETE SOLUTION A 5kg block rests on the smooth incline (30 degrees above horizontal) and is…

A: To find: The total work done by all the forces acting on the block. Given: The mass of block is m=5…

Q: 3. Complete a table similar to that in Experiment No.3. Let weight of block equal to 5.60 N for the…

A: For solution refer below images.

Q: 12. Surface tension is caused by the force of . a the free surface. ....

A: Cohesion

Question

I need the answer as soon as possible

Q5: Determine the horizontal and vertical components of force needed to hold the Y,
shown in figure (4), in place. The plane of the Y is horizontal.
Q. 0.23m/sec
Qro.34m/hec
Ør 200 mm
Ø: 300mm
TokPa
twoter
Figure (d)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Resolve the 360-lb force into components along the cables AB and AC. Use =60 and =40.
If the intensity of the line loading is w=[(40xx2)/40]lb/in., where x is measured in inches, use integration to find the resultant.
Q1: Resolve the horizontal 600-lb force in Fig. into components acting along the u and v axes and determine the magnitudes of these components. 600 b
The cable BC carries a tension of 750 N. Write the force in the cable as a vecto 12m- C 0.7 m 1.6 m.
Q 1: Resolve the horizontal 600-lb force in Fig. into components acting along the u and v axes and determine the magnitudes of these components.
touch &O D 00:28 MENG250 - Practice Assign... •2–33. If F, = 600 N and $ = 30°, determine the magnitude of the resultant force acting on the eyebolt and its direction measured clockwise from the positive x axis. 60° F, = 500 N F = 450 N ... >
Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part Ropes AB and BC are two of the ropes used to support a tent. The two ropes are attached to a stake at B and the tension in rope AB is 625 N. 3m A 3 m 1.5m 0.38 m 0.08 in 0.16 m z Detail of the stake at B Determine the smallest angle between rope AB and the stake. (You must provide an answer before moving to the next part.) The smallest angle is
Q2 : Resolve the force ( 450 ) to its components along coordinates AC & AB ( nun perpendicular coordinate ) 30 7 450 lb B
QI5: Delermhe The resultant o. The forces shoan in figure () 4 KN 6.A 48KN CAKN 2 KN 54 KN Fy-(15)
Q1/ Two Forces Shown in Fig. (1) acts on the bracket, determine the effect of these two forces (using Parallelogram method). 100 F-150N F₁-200 N Fig. (1)
Determine the resultant of the four force acting on the body shown in the figure. 400 lb 30 Note: 1" x 1" 228 lb 398 lb
Three forces act on a hook. Determine the magnitude of the resultant of the force. Neglect hook bending. F2 - 1500 N - 1000 N 20 30 16 F3 - 750 N Select one: O a. 1250 N Ob. 1510 N C. 1140 N d. 989 N