i need the answer quickly Q3: For the Single Line Diagram shown below, draw the reactance diagram andspecify all reactance in . u.. Take Sb = 100 MVA, V = 33 kVM.) 40 MVA. x,-0.20 pu30 kVT₁60 22G38110MVA100 MVA.33 kV= 0.15 pu110 MVA110/33 kV(M) 20 MVA * = 0.20 pu30 kV33/110 kVX₁, -0.08 pux=XT2= 0.08 pu

In this question, We need to draw the single line diagram for the base voltage VB and SB ?…

Q3: For the Single Line Diagram shown below, draw the reactance diagram and specify all reactance in .u.. Take Sb = 100 MVA, Vb = 33 kV M. 40 MVA. x,-0.20 pu 30 kV T₁ T₂ 60 Ω 38 38 110MVA 100 MVA. 33 kV % = 0.15 pu (M) 20 MVA x = 0.20 pu 30 kV 33/110 kV X₁, -0.08 pu 110 MVA 110/33 kV X1₂ = 0.08 pu

Q3: For the Single Line Diagram shown below, draw the reactance diagram and specify all reactance in .u.. Take Sb = 100 MVA, Vb = 33 kV M. 40 MVA. x,-0.20 pu 30 kV T₁ T₂ 60 Ω 38 38 110MVA 100 MVA. 33 kV % = 0.15 pu (M) 20 MVA x = 0.20 pu 30 kV 33/110 kV X₁, -0.08 pu 110 MVA 110/33 kV X1₂ = 0.08 pu

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.
2. Refer to the Figure 2. a) Determine the total impedance of the circuit in polar form. b) Determine the voltage v(t) and current i(t) sinusoidal forms. Sketch one cycle of the waveforms in the same x-axis. Clearly indicating the peak value and the period of each waveform and the phase difference (in milliseconds) between the two waveforms. c) Determine the values of resistance R and inductance L. d) Determine the phasors V,, VR and Vc. e) Sketch the phasor diagram showing Vs, Vr, Vr, Vc and I.
Let's say you measure t1/2 to be 0.037 seconds and the resistance in the circuit is 68 Ohms. Then what is the capacitance in micro Farads? Answer in micro Farads.
A generator rated at 30MVA, 11kV has a reactance of 40%. Calculate its p.u. reactances for a base of 50MVA and 10kV. O 0.606 p.u. O 0.506 p.u. O 0.806 p.u. O 0.706 p.u.
3-10 A0.25-F capacitor has a current waveform i(t) as shown in Figure P3–10. Determine and plot the voltage waveform v(t) as a function of time. The capacitor is initially a and plot the voltage waveform v(t) as a function of time. The capacitor is imu uncharged. FIGURE P3-10 ilt) 4 A 6. -4 A
a) We assume that the switch is on. Calculate the reactance values and find the charging current in the circuit below. Is the circuit capacitive or inductive? Show that the voltage across the capacitance can be slightly larger than the source voltage U. (This is called the Ferranti effect and means that we can get a voltage rise beyond overhead lines with small loads. This is mostly relevant at the highest voltage levels. The frequency f is 50Hz, and assume voltage U= √2⋅24kV
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.
Determine the value that the unknown emf (E) must have so that the potential V12 = 9v
The current through a 15kohm resistor is given below, using Ohm’s Law to find the voltage, convert to polar form, complete the math, then convert back to the waveform at i1 = 3.5sin(2500t) mA and i2 = 2.3sin(200t – 60°) mA
A resistance RC and a 4 ohms capacitive reactance are in series and the combination isparallel to a 10 ohms resistance. What value of RC will yield a circuit phase angle of 450 ?.
a)For the inductive element of Figure 1 , the current in phasor form is B) the voltage in phasor form for figure 1 is C)the impedance of the inductor for figure 1 is