Q3 Bulk deformation processes are generally characterized by significant deformations and massive shape changes, and the surface area to volume of the work is relatively small. The Figure Q3 illustrates different bulk deformation processes. (a) Fill in the blank and elaborate on the process description (b) Discuss FOUR (4) major drawbacks of hot working. (c) Elaborate the term Extrusion Process with the proper figure

Q3 Bulk deformation processes are generally characterized by significant deformations and massive shape changes, and the surface area to volume of the work is relatively small. The Figure Q3 illustrates different bulk deformation processes. (a) Fill in the blank and elaborate on the process description (b) Discuss FOUR (4) major drawbacks of hot working. (c) Elaborate the term Extrusion Process with the proper figure

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Please I nead clear drawing, and find Lift force, normal force, axial force, drag force and please lable all the angels
Can you rewrite the above solution as I cannot read some of the numbers and sketch elements?
Which equation will yield a direct solution to problems involving force,velocity and time?
Describe Castigliano’s Second Theorem?
This is a single MCQ problem, Please answer and choose the right option. (The must be well explained)
Q3 contd. (d) The yield strength values of pure aluminium (Al) and pure copper (Cu) are 25 MPa and 20 MPa, respectively; whereas the yield strength values of cold rolled Al-Mn-Mg alloy and cast 60-40 Brass (60% Cu, 40% Zn) are 200 MPa and 105 MPa, respectively. With aid of schematics, explain the main mechanisms account for the increases in the strengths. (e) A cylindrical tie rod with a diameter of 18.4 mm is subjected to cyclic loading. The stress range is +/- 200 kN. Figure Q3.3 shows the S-N curve of the material of which the rod is made, how many cycles will this rod survive? Stress amplitude O₂ (MPa) 1500 1400 1300 1200 1100 1000 900 800 700 600 500 400 10² 10³ 104 4340 low-alloy steel Stress ratio = -1 Fig. Q3.3 105 106 Number of cycles to failure, Nf 107 108
Why the cupping test may not predict well the formability of sheet metals in actual forming processes? Cupping test uses square or rectangular specimens only. Strain in some forming operations is not axi-symmetric. Cupping test is mainly for compression Stress is rarely uni-directional in sheet metal forming.
Can you please help with the attached problem?
How can we apply the equations for plane-stress transformation, using a graphical procedure?
A do = 50 mm and ho = 75 mm billet of a 2017 Al alloy is to be compressed to a hi = 20 mm height in a hydraulic press (ram velocity 100 mm/s) at 500° C between unlubricated anvils. (a) For the end of the press stroke, calculate interface pressure and press force. (b) What increase in stress and force would occur if the workpiece were to cool to 400°C?
Describe the Castigliano's Theorem?
How did you get that first equation