Q1:Put the true or false in the statements following. 1-Density is measuring in (m/kg). 2-Mass flow rate is (A=nr^2). 3-Pressure is measuring in (Pascal's). 4- Mass is measuring in (Kg). 5- K.E is formulas K.E=1/2mu^2. 6- P.E is formulas P.E=mgv. 7-dynamic viscosity =m/s. 8- Minor losses occur in loss of pressure. 9- Minor losses occur in Head pipe. 10. Minor losses occur in Solution of pipe flow.

Q1:Put the true or false in the statements following. 1-Density is measuring in (m/kg). 2-Mass flow rate is (A=nr^2). 3-Pressure is measuring in (Pascal's). 4- Mass is measuring in (Kg). 5- K.E is formulas K.E=1/2mu^2. 6- P.E is formulas P.E=mgv. 7-dynamic viscosity =m/s. 8- Minor losses occur in loss of pressure. 9- Minor losses occur in Head pipe. 10. Minor losses occur in Solution of pipe flow.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Choose the correct answer Kinematic viscosity is * f. dynamic viscosity* Density b. About 1.2*10^-2 m2/s for water e. Both b and d c. Density*dynamic viscosity d. Both a and c g. Both f and c a. About 1.2*10^-6 m2/s for water
1. Suppose a person is 182 cm tall. A typical blood pressure is often given as 110/70 mm Hg, with a mean pressure of 80 mm Hg. A. Do you think this is the gauge pressure or absolute pressure? Why? 6, If the pressure at the top of the head is about 39 mm Hg, how far away is this person's head from the heart? Assume the density of blood is about 6% higher than that of water. C, What then would be the blood pressure of this person at their feet? D. Suppose this person suffers a puncture wound around the same height as the heart where the opening is about 3 mm in diameter. How far could blood shoot from their body assuming it comes out horizontally with 0 m/s initial horizontal velocity? Please show me how to solue thes problem iN nEat and clené de fail. Show ala equatiins that I must aSE fo Get neat I mUst correct asweres. 4o Ger he Thank gon !!
3. A differential manometer is connected to two pipes as shown in Fig. 2.31. The pipe A is containing water and the pipe B is containing an oil of specific gravity 0.8. Find the difference of mercury levels, the pressure difference in the two pipes be 80 kPa. [Ans. 426 mm] Water- 3.5 m B To Fig. 2.31. Fluid Pressure and its Measurement 37 300 Fig. 2.32. -Oil of sp. gr. 0.8 Copyrighted materia B
The figure shows a sensor indicating a gauge pressure reading of 1.5 kPa. The fluids are at 20°C Determine: a) the height hb. b) the height hc.The specific weight of air is 12.0 N/m3.
TRUE OR FALSE Specific Volume is a measure of a fluid's resistance to deformation under shear stress. While a unit expresses a specific type of physical quantity, a dimension assigns a property of scale so that the unit can be measured. Temperature at which water has the highest density is usually taken as 4°C(39.2°F). The continuum concept in hydraulics assumes that a fluid often behaves as if itwere comprised of continuous matter that is infinitely divisible into smaller and smaller parts.
The dependence of thermal conductivity of a material on temperature is given by an empirical equation k = a ebT where a and b are constants, and k is in W/m-K and T is in K. Spot the true statement from the following set. a, a and b have the same dimension as k. b. a has the dimension of k and b is dimensionless. c. a and b are dimensionless. d. a has the dimension of k and b has the dimension of T.
1. Pressures up to 3000 bar are measured with a dead-weight gauge. The piston diameter is 4 mm. What is the approximate mass in kg of the weights required? 2. A gas is confined in a 0.47 m diameter cylinder by a piston, on which rests a weight. The mass of the piston and weight together is 150 kg. The local acceleration of gravity is 9.813 m's-2, and atmospheric pressure is 101.57 kPa. (a) What is the force in newtons exerted on the gas by the atmosphere, the piston, and the weight, assuming no friction between the piston and cylinder? (b) What is the pressure of the gas in kPa? (c) If the gas in the cylinder is heated, it expands, pushing the piston and weight upward. If the piston and weight are raised 0.83 m, what is the work done by the gas in kJ? What is the change in potential energy of the piston and weight? 3. Steam at 1400 kPa and 350°C [state 1] enters a turbine through a pipe that is 8 cm in diameter, at a mass flow rate of 0.1 kg: s-1. The exhaust from the turbine is…
B) Compare between Two of the following 1- Open System and close system. 2- Otto cycle and Air-Standard cycle 3- Energy transfer by work and Energy transfer by Heal c) Find the dimensions of viscosity u. Write the dimensional formula of Force in the (FLT) rather than (MLT) systems.
Dynamic viscosity of fluid Density of fluid If X= , then the unit of X is = O m?/kg O m/sec? O m/sec O m?/sec The container contains an oil of specific gravity 0.64 with the pressure measured at the bottom of the container is 150 Pa. Find the pressure head in m of oil. The pressure head of oil in m = If the density of fluid is not a variable in a fluid flow, it is known as O Incompressible O Unsteady flow O Uniform flow O Compressible
4. If the modulus of elasticity (E) for water is given to be 2.2GPa, what pressure is required to reduce the volume by 0.6%? 5. A tank contains two substance oil (A) and water (B) subject to variable air pressure: the dimension is shown below and corresponds to 1atm If air is
Which of the following statement is correct? Select one: O a. point functions are inexact Differential. O b. Point functions are not the properties of the system. O c. The Point Function depends on the path followed during a process as well as the end states. O d. Examples for points functions are temperature, pressure, density.
. As shown in the figure, what is the static gage pressure in kg/cm² in the air chamber? Air 1.5 m 1.5 m Air Oil 4 m s = 0.80 5 m 3.5 m glycerin (1.25)