Answered: Q1. An equilateral transmission line…

Q1. An equilateral transmission line has a total corona loss of 53 kW at 106 kV and a loss of 98 kW at 111 kV. What is the disruptive critical voltage? What is the corona loss at 115 kV?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.32MCQ

See similar textbooks

Related questions

Q: 2. Derive an expression for the output voltage of the circuit below in terms of the fou input…

Q: 7- In FM modulation, what is the value of the frequency deviation, if the amplitude of the…

A: The solution is given below

Q: wave rectifier has Vin of 5sinwt volts and forward voltage of 0.7 volts, what is the average Vo?

A: We need to find out average value of given rectifier

Q: Q1a Voltage control – fault level • A load bus (bus-L) is suppling from two different buses A & B…

Q: 43-45 NETWORKS Find the currents in the following networks. 43. 10Ω 44. 3800 V 13 50 2 20 Ω I3 (I2…

A: In this question we will find network currents.... Note:- as per our guideline , I am.supposed to…

Q: Q2: A 33 kV,3-phase underground feeder, 3.4 km long, uses three single core cable. Each cable has a…

Q: In the following circuit, a 1k resistor, a 142mH coil and a 160UF capacitor are connected in…

Q: Q2: Consider a line of code- LDD $C100. Before execution of this line of code, the memory locations…

A: We need to find out output of given instructions

Q: 1. (а) Draw the block diagram of the feedback system and derive an equation to show that negative…

A: for our policy , i can solve only 1st question

Q: A ferromagnetic core is shown in Figure 1. The depth of the core (in to page) is 15cm, and the other…

Q: The dwelling has a floor area of 142 sq. m. It has a typical household appliance including one 8 kW…

A: A dwelling unit is a place used for providing living accommodations, the place is not a hotel, but…

Q: Semiconductors having band gap near 1.5 eV are preferred for solar cells because, select the best…

A: High band gap cells in the range of 1.5 eV absorb more number of photons from sun radiation as…

Q: Compute the total Resistance Compute the voltage and current in each resistor R1= 30 0 R= 50 R= 15 0…

A: Given:

Q: Consider a system with the following closed loop characteristics polynomial: s+ 6s + 11s?+(K+6)s +Ka…

A: The solution is given below

Q: Si 2.2 k2 12 V 1.8 k2 -12 V

Q: TUTORIAL PROBLEMS A 3-phase, star-connected alternator is rated at 15000 kVA, 11 kV. The armature…

A: Solve the problem

Q: F B D-

Q: 5. Suppose we have a stationary external magnetic field B. We have a negatively charged particle of…

A: The magnetic field is the number of magnetic lines accumulated at a place that creates a magnetic…

Q: 2. Consider the voltage divider circuit for biasing an n-channel E-MOSFET. Given the following…

A: We need to find current and voltage for given circuit

Q: In the following circuit, calculate the: 1. Impedance, 2. Circuit current, 3. Power factor, 4.…

Q: 7.5 kN 5 kN 10 Vo 2 kn 6V - Vout Determine I and Vout

A: The solution is given below

Q: Q 3: Draw the output waveforms (So, U, and V) for the below sequential circuit by assuming the…

Q: Zea 1-j2 1+j3 2 1+j2 2 j5 2 Find Zeq for this circuit. Show all your work.

Q: Determine the input waveform Vi and output waveform Vo of the following circuit diagram. 2.Determine…

A: 1. From the given circuit , silicon diode has forward with voltage of 0.7V. →for…

Q: Q2: A 33 kV 3-phase underground feeder, 3.4 km long, uses three single core cable. Each cable has a…

Q: _4. i,xâ |

A: 4) To find the magnitude of the cross-product

Q: If the size of the memory is 1MB, what is the last address of the memory? A. Ох3FFFF OXFFFFF C.…

A: As per our company guidelines we are supposed to answer only first question kindly repost other…

Q: Figure 2 shows a small 480-V distribution system, Y-connection. Assume that the lines in the system…

A: As per Bartleby Policy we can answer first 3 subparts. Please repost the question for other parts.…

Q: Question 5 Design a circuit to accomplish the following if statement If ( XW) && (N=0) Then (Q-…

A: Logic diagram can be drawn to any circuit, by using the logic diagram the behavior of the system to…

Q: 29. For the two-stage, capacitively coupled amplifier in Figure 6-57, find the following values: (a)…

A: Given A two stage amplifier,we need to find individual voltage gains and overall voltage gain of…

Q: Problem: Line of Charge • Find the electric field at point P from the charged rod shown below. The…

Q: For the circuit shown, R1 S the switch S is closed at t= Os. 1Ω R : R3 C=1mF V=5V 20Ω 1) What is the…

Q: x(z) = 4 – ; Causal Signal - z-1 z+0.5 x(n) =

A: We need to find out Inverse z transfer of given signal

Q: Discussion 1- Does K.CL & K.V.L depend on the relationship between current and voltage in a…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: What would be the likely output voltage VOUT of the figure below? Show your solution. R 9V Tr1 Dz…

Q: 1a.) What electric and magnetic fields correspond to the TM modes of a 1D ideal metallic waveguide?…

A: Transverse mode is a mode of operation in an electromagnetic field perpendicular to radiation wave…

Q: Given the state diagram below, generate the (a)state table, (b)state equations, (c)output equation…

A: The given state diagram is: Let the input is X and the output is Y. Since the number of states is…

Q: What is the difference between a transistor and an integrated circuit?

Q: FIND V. in thE netwovk VAI2 TVA- Vo

A: The solution is given below

Q: Given the following star-connected source, 2) 100/120° V 1. Find the line voltage, Vry, Vyb , Vbr O…

A: In this question, We need to determine the line voltage Vry , Vyb and Vbr ? Draw the phasor…

Q: For the Wheatstone bridge cited in the figure, calculate what the resistance Rx must be that…

A: In this question, We need to determine the value of unknown resistance Rx?

Q: circuit diagram for electrical fault detector system for a three-phase transmission line

A: It is asked to show the circuit diagram of electrical fault detector system for a three-phase…

Q: 1. Solve for the current of 1+j3 ohms impedance using Kirchhoff's Law 0.02. n 0.0LR loody lo 3 V

A: Given circuit,

Q: For a full-wave rectified signal the dc voltage of 0.636Vm. The rms value of the ac component of the…

Q: A a 10+ j102 Va = 200 Z0°V, rms 10+ j10Q 10+ j102 n bB b V. В B.

Q: A 6600 V, 3 phase star connected alternator has a synchronous impedance of (0.4 +j6) per phase.…

A: Voltage regulation: It is the difference between the sending and receiving end voltage. It is…

Q: The EMF and resistor voltage in a series RLC circuit are shown as functions of time. Part A Choose…

A: The solution is given below

Q: A standing wave on a string is described by the wave function y(x,t) = (6 mm) sin(4Ttx)cos(30rnt).…

A: Y(x,t) = (3mm)sin(4πx+30πt) + (3mm)sin(4πx-30πt) {Since 2sin(A)cos(B) = sin(A+B) + sin(A-B) }…

Q: Consider the voltage divider circuit for biasing an n-channel E-MOSFET. Given the following…

Q: 20 V 2 A Figure P 5.5-5 Encuentre el circuito equivalente Thevenin. . Rt=3 Ohmios Vt 10V ORI3 Ohmios…

Concept explainers

Fiber Optics

Fiber optics is a technology used to transmit the facts such as light or pulses with fiber or plastic over long distances. Visual fibers are about the width of a human hair strand and, when tied directly to a fiber-optic cable, can transmit multiple long-distance records and faster in different ways.

Question

Quiz 1. Course 2nd
QI. An equilateral transmission line has a total
corona loss of 53 kW at 106 kV and a loss of 98
kW at 111 kV. What is the disruptive critical
voltage? What is the corona loss at 115 kV?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A double-circuit its capacitance to neutral per mile. line is shown below. The conductor radius is 0.0452 ft. Determine 16' 16' a b 22' c' b' a'
Q1. An equilateral transmission line has a total corona loss of 53 kW at 106 kV and a loss of 98 kW at 111 kV. What is the disruptive critical voltage? What is the corona loss at 115 kV?
2.5 A 3-phase single circuit bundled conductor line with two sub-conductors per phase has horizontal spacing with 6.1 m between the centre lines of adjacent phases. The distance between the sub- conductors of each phase is 30.5 cm and each sub-conductor has a diameter of 2.54 cm. Find the inductance per phase per km. [0.988 mH]
The total reactive power consumed by the three-phase load(in VAr) is??
The affect of the earth plane is to slightly increase the capacitance, and as the line height increases, the effect of earth becomes negligible. True False
The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
4/ Which parameter is neglected or ignored in Short Transmission Lines? A. SHUNT CAPACITANCE ONLY B. SERIES CONDUCTANCE AND SHUNT CAPACITANCE C. SHUNT CONDUCTANCE AND SHUNT CAPACITANCE D. SHUNT CONDUCTANCE ONLY
A three phase system with Dab Dbc one conductor per phase as shown in the figure. The conductors are stranded and spaced as shown, (Dab=Dbc=4m). The outside diameter of the phase conductor is 2cm. The GMR of the phase conductor is 0.7788 cm. The value of inductance per phase is: Select one: O a. (1.2445 * 10A-3) mH/km O b. (1.1559 * 10^-6) H/m O c. (1.4562 * 10A-6) H/m O d. (1.2945 * 10A-6) H/m O e. (1.2445 * 10A-6) H/m
What is total admittance and impedance from source side.
Calculate the capacitance per km per phase for a 3 phase, 50Hz, double circuit line shown in figure below. Each conductor has a diameter of 25mm and subconductor spacing 0,3m. the line is completely transposed. 0.3m 6 m 6m
5.5 kW, 1450 rpm. L-type equivalent circuit and parameters for a continuous sinusoidal phase of a star connected 3-phase ASM with line voltage 220 V and frequency 50 Hz are given as follows, ignoring core (iron) losses: R1=0.21 Ohm, R2=-0.18 Ohm, X1=X2-0.66 Ohm and Xm = 9.9 Ohm How many times the inrush current will be the rated current when the ASM is started directly? Answer options group 8.0815 2.6455 4.3763 7.1534 1.2558 6.3414 5.2280 3.7473
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight 1-The capacitance in uF/km without effect of ground is 2-The capacitance in pF/km with effect of ground is