Q/ Compute the angle (Theta) for the member (A), the resultant force of FA and FB is directed horizontally to the right. Also, find the magnitude of the resultant force. FA=8 kN

Q: 1. Two resistors, three capacitors, a battery, and two switches are connected in the circuit shown b...

A: In steady state, the capacitor has a voltage across it, but no current flows through the circuit: th...

Q: 2 mF 0.2 H rell Zin 1/3 U 1/8 C 10 mF www

A: The given figure is shown below:  

Q: The carrier power in an AM signal is 70 mW the USB power is 1 mW, what is the efficiency of the AM s...

A: Given: Carrier power,  Pc=70 mW USB power, PUSB=1 mW To find: Efficiency of AM signal

Q: Draw to scale a vector diagram showing the following voltages : v1 = 100 sin 500 t; v2 = 200 sin (50...

A:

Q: QUESTION 1 Refer to the given circuit below. Determine the equivalent resistance across terminals a ...

A:

Q: Q6 The following test results were oblalined on a 275-kW, 3-0, 6,600-V non- salient pole type genera...

A: Current: This is the time rate of the change of the charges and its unit is ampere.

Q: 2. For the voltage regulator shown in Figure below, VO =9 Vand R1=1k0. Calculate the value of R2. In...

A: The solution is given below 

Q: Q 3. For the circuit shown in Fig. 1, calculate the current through all the branches of the circuit ...

A: Given

Q: Use Eight-bit signed binary representation to perform the following computation + 46 -110

A:

Q: QUESTION 6 Two resistors with resistances of 13 Q and 18 Q are connected in series. The series combi...

A: The solution is given below 

Q: D4.2. Calculate the work done in moving a 4-C charge from B(1,0, 0) to A(0, 2, 0) along the path y =...

A: The solution is given below 

Q: Q2) For the circuit shown in Figure below find: a. Ve(l) and le (1) b. ve(l') and le(l') c. Vell = 1...

A: We need to find out current and voltage through capacitor in the given circuit .

Q: 200 300 100 R2 100 V2 -20V 13.727

A:

Q: y(t)= x(t)cos(2rf.t), Is this a LTI system?

A:

Q: VR(t) i(t) R + vi(t) v(t) = Vmcos(@t +0) L = 33 mH R = 1.5 k2 Assume the source has been on for a lo...

A: Given  

Q: Q11/A 3-phase, 400 V wound rotor motor has a delta-connected stator winding alid Star connected roto...

A:

Q: G: Amf CA= 6Mf te G: 3mf G: Suf HE Gr: 240 volts FIC.# 2

A:

Q: 3. Determine whether the corresponding system is linear, time invariant and causal. Show block diagr...

A:

Q: Calculate the equivalent resistance of this circuit between the 2 terminals. Use the values, a = 47 ...

A: This question belongs to circuit theory . It is based on the concept of series and parallel combinat...

Q: Compute the value of V, and I for Circuits 1, 2 and 3, for the input voltages shown in the table. Wr...

A:

Q: Q/the current in R8 R2 R6 100 150 R5 R4 R8 140 130 R1 R3 180 200 V1 R7 30 20V O 0.056 O 0.035 O 0.07...

A: In this question,  Choose the correct option What is current in the R8 ohm resistance.  We are solvi...

Q: 1. A Silicon diode is operating at a room temperature of 25 °C and has a reverse current of 10 nA. S...

A:

Q: Hiw:-Write the nodal equalionns X find the Voltage across the 28 resistor for net. shown? 3 く7 240v ...

A: The solution is given below

Q: Obtain the truth table of the following functions, and express each function in minterms and/or max...

A:

Q: The signals below, CK and D are the clock and D inputs to two different components: a D latch and a ...

A: Timing diagram is drawn in step -3

Q: 2. A silicon diode has a saturation current of 5nA at 27'C. Estimate the Is at 100'C? ANS. 784.03 nA...

A:

Q: Q/the total resistance of the following circuit is: * 150 Req R1 R3 180 200 R8 R2 140 R5 O 22.72 27....

A: The solution is given below 

Q: 2.3 Compute the impulse response of the LTI system whose step response is 0 1 2

A:

Q: A 5-ohm load is connected to the secondary of a l1100/110-V power transformer. The effective load in...

A:

Q: When the diode is reversed biased, the terminal that is connected to the lower potential of the sour...

A: Diode is said to be reverse biased when cathode voltage is greater than anode voltage.   

Q: -2.4 x 1015/cm³ at 300 K is added. A steady current of e hole concentration, electron concentration,...

A:

Q: prima dings Hz ideal transformer have if the core flux is not allowed to exceed 5 mWb?

A:

Q: I. CONVERT THE FOLLOWING INTO POLAR and EXPONENTIAL FORM AND PLOT IN AN ARGAND DIAGRAM 4. Z= -6-2i 5...

A: The solution is given below 

Q: 1. A Silicon diode is operating at a room temperature of 25 °C and has a reverse current of 10 nA. S...

A:

Q: Q1. (b) A single-phase, 120 V, 60 Hz universal motor is operating at 1800 rpm and its armature curre...

A:

Q: A certain noninverting amplifier has an Rị of 5.152 kQ and an Rf of 30.894 ka The closed-loop gain i...

A: Given: A non-inverting amplifier has Input resistance, Ri=5.152 kΩ Feedback resistance, Rf=30.894 kΩ...

Q: a) A time signal x (t) is shown in Fig. Sketch and label each of thefollowing signais. r(t) x(2t + 2...

A:

Q: Determine the current I1, k and ID2 for the given network. (Use 2nd approximation) ANS. 1 = 212.12 u...

A:

Q: Which statement is incorrect for a forward biased diode O a. Va>Vk O b. Vak>Vth O c. Current due to ...

A:

Q: I. CONVERT THE FOLLOWING INTO POLAR and EXPONENTIAL FORM AND PLOT IN AN ARGAND DIAGRAM

A:

Q: The 2 phenomenons that describe the sudden increase of the current in a Reverse bias diode are: and ...

A: In this question,  Fill the blank.  Both question are releted to the characteristic of the reverse b...

Q: CI C5 C2 C8 C9 C6

A: Breadboard-It is a plate which is used to make circuit with external input source. Its connecting po...

Q: At 110 volts, a lagging power factor load in single-phase consumes 500 Watts and 8 Amperes. Determin...

A:

Q: 1. A moving-coil instrument gives f.s.d. for a cur- rent of 10 mA. Neglecting the resistance of the ...

A:

Q: 1.What voltage is boosted at the output of a multiplier. a) average b) rms c) peak d) instantaneous

A: The solution is given below 

Q: Q/Rth between a and b is: * 200 300 100 R2 100

A: Given, We have a network. We have to find the R th . Please find the below attachments for the clear...

Q: What is the phase relationship of the input and output voltages ?of a CE amplifier

A: The phase difference between input and output voltages of a CE amplifier is 180 deg.

Q: Determine the following: Ic, VF , VR , R1

A: BJT (bipolar junction transistor) A transistor having a three terminal made up of semiconductor comp...

Q: *44. For the network of Fig. 2.188, determine the range of V; that will maintain V at 8 V and not ex...

A:

Q: Consider the function g(t). g(t) = = 20 cos(69Tt +=) 5 Find the fundamental period of g(t).

A: Given data, gt=20cos69πt+π5  

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.