Electrical EngineeringQ 4. With the automobile compressoroperating and little or no refrigerationneeded, the low side pressuremay increase too high and lowers theevaporator temperature.may increase too low and increases theevaporator temperature.may drop too low and lowers theevaporator temperature.may drop too high and increases theevaporator temperature.

Answered: Image /qna-images/answer/18fb6f5c-e05b-4d99-a6e5-4904a5222148.jpg

Answered: Q 4. With the automobile compressor…

Engineering

Mechanical Engineering

Q 4. With the automobile compressor operating and little or no refrigeration needed, the low side pressure

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 15RQ: Why is information regarding the specific volume of gases important to the designer of...

See similar textbooks

Related questions

Q: 4- the solar powered absorption cooling cycle is the most popular system for solar cooling…

A: Absorption cooling involves dissolving a vapour in a liquid, pumping the solution to a higher…

Q: The schematic diagrams of two suggested designs for a boiling water reactor are shown in the…

A: T-s diagram of direct cycle is

Q: Explain in brief which refrigerant/s would you choose for each of the following applications and…

A: Refrigerant is fluid that carries heat in the refrigerator at low temperature and released the heat…

Q: The temperature limits of a CO2 refrigerating plants are 25°C and -10°C. If the vapour is dry at the…

A: Given Data CO2 Refrigeration plant with temperature limit 25°C and -10°C Mass flow of CO2 4 kg/min

Q: Apply the first law of thermodynamics to power requiring compressor. Assume that the process is…

Q: differentiate between Open Feedwater Heaters and Closed Feedwater Heater with given 1 application on…

Q: a. The static pressure on the pipe wall b. The dynamic pressure c. The stagnation pressure

Q: e photo below is the refrigeration cycle of Ammonia, Im just confused on where h2 and Tsup=105 C…

A: To Show the concept how cardinal points are calculated in ammonia refrigeration cycle.

Q: 3) If the measurement parameters of a refrigeration machine are known, the amount of heat for liquid…

Q: 3. The point that connects the saturated liquid line to the saturated vapor line is called the: (A)…

Q: Water is pumped from a chiller in the basement, where z1=0m, to a cooling coil located on the 20th…

Q: 1. Explain detail about Reciprocating compressor i) Working principle of Reciprocating compressor…

A: Reciprocating compressors are widely used in industries for increasing the pressure of the air or to…

Q: The volume of the compressor tank is 3.5 ft2, when the pressures reach 20 psi. What is the work done…

Q: derive the general formula for the intercooling related to the number of stage of compressor

A: Intercooling, which is used in most multi-stage compressors, increases the moisture in the air.…

Q: 2. A steam-jet pump maintains a temperature 50°C in the evaporator. The cooled water leaves at the…

A: Given Data The temperature maintained by steam jet is:T1=T3=5°C The warm temperature is:T2=10°C The…

Q: 6-The point at which water directly converts into steam is called ___________ A. sensible heat of…

A: The point at which water directly converts into steam is called latent heat of vaporisation.…

Q: A refrigeration system is used to cool water in the evaporator at 7.5 kg/s from 30°℃ to 4°C.Find the…

A: Given data: m˙=7.5 kg/sT1=30°CT2=4°CCOP=5 Need to determine the required compressor power.

Q: 2- The efficiency indicator for a refrigerant cycle is coefficient of performance cop which is…

A: Aa per bartleby guidelines we are allowed to solve only 1st question if multiple questions are…

Q: lot the COP of regerigerator and heat pump for temperature range from 1 degree celcius to 28 degree…

A: To determine the COP of refrigerator and heat pump.

Q: For 602.28 kPa Evaporator (8) temperature and degree superheat leaving the compressor (h) mass of…

A: Given data Standard refrigerating cycle withEvaporator pressure = 602.28 kPa ≈ 6 barCondensing…

Q: When a refrigeration system that produces low or no cooling has high suction pressure and low head…

A: For high pressure suction to occur you may have insufficient compressor which means your…

Q: the limitation(s) of gas turbines.

A: Given: Gas turbine To write: The limitations of gas turbine

Q: Calculate the power required by a system of one compressor serving two evaporators. One evaporator…

A: At 10oC ; Saturation Pressure , P = 680.9 kPa Specific Enthalpy , h = 408.6 kJ/kg At 10oC ;…

Q: A R22 twin-cylinder 92x110 mm compressor operating at 1680 rpm, a condensing pressure of 1500 kPa…

A: Given: PC = 1500 kPa PE = 380 kPa RC = 23.5 TOR N = 1680 rpm D = 92 mm L = 110 mm k= 2 ηM=92% Win/M…

Q: When a chiller is used, the secondary refrigerant that circulates in the building is _____.

A: Given Data : Chiller secondary refrigerant

Q: The Pump Work is the work required to push the water into the boiler at a higher pressure

Q: A 4-stage centrifugal pump discharges 1000 gpm of water at 1750 1pm with a total heat head of 1000…

Q: 9. With the use of centrifugal pump, the heat transfer is maximum.

A: Solution:

Q: Calculate the power required by a system of one compressor serving two evaporators. One evaporator…

A: High temperature evaporator load and temperature, Q˙e,2=40 kW, Te,2=12oCLow temperature evaporator…

Q: Problem 4: Consider the following schematic of a simple turbojet engine model that uses air as its…

Q: Q3 / What would happen if the oil was replaced with water in the steam pump? Explain that.

Q: 4. Calculate the power required to compress 18 kg/min of NH, from saturated vapour at 1.4 bar to…

Q: Q2: an ammonia vapour compressor refrigerator has a single acting stage, single acting reciprocating…

Q: How does vortex tube refrigirator work in a portable min coolerbox or portable refridge? kindly…

A: Vortex tube refrigerator is used compressed air to cool as low as to air-condition the space. this…

Q: The power required to drive the compressor in Carnot refrigeration is 50 Hp. It operates between…

A: GivenCarnot refrigeration systempower required to compressor W=50HPT1=-5oC=268KT2=40oC=313K

Q: ifferentiate Refrigerator from Heat pumps in terms of: (a) Transfer of Heat, (b) Location of the…

A: Given Refrigerator Heat pump To find Differences

Q: A superheat-controlled expansion valve in a refrigerant 22 system is not equipped with an external…

Q: Q11 (connected to Q10) The water tank has m-100 kg, and it gets Q,- 20 kcal/min solar heat per…

A: Given that, Mass of the water tank, m=100 kg,Solar heat per minute, Qs=50 kcal/min,Heat from heater…

Q: 2- What is the difference between subcooled liquid and saturated liquid?

A: Differance between sub cooled liquid and saturated liquid :-

Q: Choose the close thermodynamic system a. Gas turbine b. Thermo-flask c. Centrifugal pump d.…

Q: Determine the rate of heat transfer between the turbine and its surroundings if the operational…

Q: A metal tank contains air at 20 C and 400 kPa. The tank volume is 5 m3 . It is connected through a…

A: Given data as per question The temperature of the air in tank A = 200 C The pressure of air in tank…

Q: 15. A commercial refrigeration system with a single suction line and multiple evaporators can…

A: A commercial refrigeration system with a single suction line and multiple evaporators can maintain a…

Q: The COP of the cycle is

A: Given data, Refrigerant vapor enters into the compressor of a standard vapor compression cycle at;-…

Q: b- An evacuated tank ,shown if fig of 1 ft3 is coupled to air supply line through valve .When the…

Q: ate is 30 kg/min. Determine a) the tons of refrigeration b) the power required c) the COP.

Q: In the induced draft cooling tower, the fan forces the air through the tower. True

A: This question is based on the concept of cooling tower in power plant.

Q: pressure. Calculate the (a) work produced by the turbine, (b) the work consumed by the pump, (c)…

A: Given: P1= 20 kPa Turbine inlet conditions P= 5000 kPa T=400oC Steam extraction at P=1600 kPa TO…

Q: a. The theoretical minimum power input to the compressor b. The reversible COP, If the high and low…

Question

Electrical Engineering
Q 4. With the automobile compressor
operating and little or no refrigeration
needed, the low side pressure
may increase too high and lowers the
evaporator temperature.
may increase too low and increases the
evaporator temperature.
may drop too low and lowers the
evaporator temperature.
may drop too high and increases the
evaporator temperature.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

explain 2-stage reciprocating air compressor
True or False: A thermocouple develops direct current and voltage.
What advantage does a thermostatic expansion valve have over a capillary tube?
A pressure cooker 6 ltr
(a) A pneumatic receiver in Figure 2 with capacity 1000 liters is located outside the building. The pressure of the receiver is 12 bars at normal temperature, 32-degree Celsius. However, during hot season, the temperature can reach 40-degree Celsius. What is the maximum pressure to ensure the receiver did not damage during hot season? Figure 2 (b) Explain how multi stage compressor works. Air receiver
In perfect gas law demonstration experiment, the vacuum cylinder must be connected to: Select one: a. Pump inlet b. Pump discharge c. None of these d. Heat transfer service unit
What is "isothermal compression" and its definition in practise ? Please choose correct option. a. It is a compression during which temparature of the air is kept constant. Compression process should be done very slowly to allow any heat to transfer to the surrounding medium. b. It is the expansion of air in a motor, during which it is heated and given extra energy. c. It is the periodic compression and expansion of a gas in a compressor as to load and unload energy to it. d. It is the compression of air in a compressor, which is neither running too fast or too slow, suitable for practical purposes. e. It is the compression of air in a heat-insulated cylinder, but compression should be very slow.
Explain Compressor?
Problem 3 For the system to the right, why would we want to heat the hot water heater using the HVAC system, rather than more traditional methods (such as burning natural gas)? Home inside nir temp: 20°C hot wnter henter - 10 liters imax temp: 50'C) Subrooler (autside air temmp: 32°C) R14a refrigerant PJ P2 sat. Hquid Qhot-water P2= OF 16 MPa T2=70°C P4-P2 Throttle (adinbatic) Compressor ladiabatic) Fan PS = P13 Pl=400 Pa at vapor air flow Tair =-10°C
What is the static air powering watts of a fan designed to deliver 800m3/hr of air with static pressure of 5cm of water column on full delivery.a. 155.3 b. 95.7 c. 105.8 d. 122.6
Q#01: Briefly explain the following. 2-Stage Reciprocating Air Compressor.
Air service unit and air cooler is not available in closed type of fluid power system. Select one: True False