PROBLEM NO. 5 A 6-m long ladder has a mass of 1Q kg, and its center of gravity is 2.4 m from the bottom along the ladder. The ladder is resting on a 5° upward sloping floor at A and on a wall inclined to the right at 5° from the vertical at B, so that it makes an angle of 60° with the horizontal. How far up along the ladder can a 7T-kg man climb before the ladder is on the verge of slipping? The angle of friction at all contact surfaces is 15°. Also determine the total reaction at A and B in Newton. Note: Point A is at the left of point B.

PROBLEM NO. 5 A 6-m long ladder has a mass of 1Q kg, and its center of gravity is 2.4 m from the bottom along the ladder. The ladder is resting on a 5° upward sloping floor at A and on a wall inclined to the right at 5° from the vertical at B, so that it makes an angle of 60° with the horizontal. How far up along the ladder can a 7T-kg man climb before the ladder is on the verge of slipping? The angle of friction at all contact surfaces is 15°. Also determine the total reaction at A and B in Newton. Note: Point A is at the left of point B.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Determine the distance s to which the 90-kg painter can climb without causing the 4-m ladder to slip at its lower end A. The top of the 15-kg ladder has a small roller, and at the ground the coefficient of sta- tic friction is 0.25. The mass center of the painter is directly above her feet. 4 m A 1.5 m
4. A ladder 20 ft long leans against a sloping embankment, its foot being secured 10 ft from the base of the embankment and its top reaches the top of the embankment. If the sloping side of the embankment is 15ft, 4.1. What angle does the ladder make with the horizontal ground?
H-W: 5m 25m 5m ▼ 5m Jeremy Sakalam Kanino ka lang!!). Consider uplift: M = 0.6 20m Read: FS, FSS, Determine if Safe, Min and Max q
The reduced level of a floor is 99.995 m, the staff reading on the floor is 1.505 m. If the inverted staff reading against the roof is 1.795 m, the floor level below the slab, is
A rigid bar AC is being supported by a 5 mm diametersteel cable BD. Determine the vertical deflection of point Cif the system is subjected to a temperature increase of 50C°. For steel, ? = 11.7??/??°, ? = 200 ???
W 60° "The 50 KN block is on top of an inclined plane shown in the figure. Determine the weight (W) of the steel bar that will move the 50 KN block sliding down the inclined plane with velocity of 2 m/sec and displacement of 2 meters. cable 8 H = 0.30 w/
SHOW THE SOLUTION NEATLY A 5m long ladder has its upper end leaning against a vertical wall and lower end on a perfectly level ground. The lower end moves away at a constant rate of 3cm/sec. How fast is the upper end of the ladder moving down, in cm/sec when the lower end is 3m from the wall? a. 25 cm/sec b. 25 cm/sec c. -2.25 cm/sec d. -0.25 cm/sec
Need complete solution A ladder with the length of 10m leans against a vertical wall 9m high. How fast is the base of the ladder slides when its base is 7m away from the wall if the top of the ladder slides at 1.2 m/s downward? Choices: 1.02 m/s 1.22 m/s 1.43 m/s 1.63 m/s
H.W Determine the distance s to which the 90-kg painter can climb without causing the 4-m ladder to slip at its lower end A. The top of the 15-kg ladder has a small roller, and at the ground, the coefficient of static friction is 0.25. The mass center of the painter is directly above her feet. B 4 m 1.5 m-
Situation X:A series of uniformly spaced hangers along a parabolic cable supports a 60 – m pipeline a5 shown. The total weight of the pipe and water is 7kN/m. w (kN/m) ppeine Test Bank: Engineering Mechanics Principle of Structural Analysis and Design 31. Calculate the minimum sag (m) of the cable if the allowable tensile load of the cable is 3200 kN. А. 1.1 В. 0.9 С. 1.0 D. 0.8 32. If the sag is y = 3 m, calculate the tensile stress (MPa) at mid length of the cable If its diameter is 75 mm. В. 265 С. 221 D. 238 A. 242 33. If the sag is y = 3 m, calculate the maximum additional load (kN/m) can the cable support if its al- lowible tensile load is 2000kN. A. 6.0 В. 5.8 С. 6.5 D. 4.6
ROD DETAILS CEILING 120° p = 0.75 ROD 1. What is the weight of Block C that will BLOCK B 60 KN displace Block A, 3 meters in 5 seconds up u = 0.35 30° PULLEY 1 the inclined plane when PULLEY 2 Block C is released? The weight of Pulley 2 is 10 KN. 50° BLOCK A 50 KN p = 0.20 BLOCK C
Referring to Figure below. it shows the section of a Barrage. The various dimensions and levels are in meters, Determine the uplift pressure at the key points (D₁,C₁,E2,D2,C₂,E3 and D3). Also find whether the section provided safe against uplift at point A and B.Is the structure safe against piping if the permissible exit gradient is 1/6. RL 108.50 1 m 105.00- ETC, 104.00 E -16 m- 97.00 D₂ 105.0 97.00 106.00 43m 17.5 m 54 m 37 m 103.52 101.581025 -6m-8.5- C₂ D₂ 95.00